lock Lexus GX460 2010 Manual PDF

152
1-7. Safety information
GX460_CANADA (OM60F29U)
Installing child restraints
Follow the child restraint system manufacturer’s instructions. Firmly
secure child restraints to the seats using the LATCH anchors or a seat belt.
Attach the top tether strap when installing a child restraint.
The lap/shoulder belt can be used if your child restraint system is not com-
patible with the LATCH (Lower Anchors and Tethers for Children) system.
Child restraint LATCH anchors
LATCH anchors are provided
for the right side second seat
and between the center and left
side second seats. (Buttons dis-
playing the location of the
anchors are attached to the
seats.)
Seat belts equipped with a child
restraint locking mechanism
(ALR/ELR belts except driver’s
seat belt) (→P. 8 8 )
GX460_CANADA.book Page 152 Thursday, February 4, 2010 11:54 AM

153
1-7. Safety information
1
Before driving
GX460_CANADA (OM60F29U)
Installation with LATCH systemFold the seatback forward. Then
return the seatback and secure it
at the first lock position (most
upright position). (→P. 6 8 )
Anchor bracket (for top tether
strap)
Anchor brackets are provided
for each second seats.
STEP1
GX460_CANADA.book Page 153 Thursday, February 4, 2010 11:54 AM

155
1-7. Safety information
1
Before driving
GX460_CANADA (OM60F29U)
Installing child restraints using a seat belt (child restraint lock function
belt)
■ Rear facing  Infant seat/convertible seat
Fold the seatback forward. Then
return the seatback and secure it
at the first lock position (most
upright position). (→P. 6 8 )
Place the child restraint system on
the rear seat facing the rear of the
vehicle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.
STEP1
STEP2
STEP3
GX460_CANADA.book Page 155 Thursday, February 4, 2010 11:54 AM

156
1-7. Safety information
GX460_CANADA (OM60F29U)Fully extend the shoulder belt and
allow it to retract to put it in lock
mode. In lock mode, the belt can-
not be extended.
While pushing the child restraint
system down into the rear seat,
allow the shoulder belt to retract
until the child restraint system is
securely in place.
After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
STEP4
STEP5
GX460_CANADA.book Page 156 Thursday, February 4, 2010 11:54 AM

157
1-7. Safety information
1
Before driving
GX460_CANADA (OM60F29U)■
Forward facing  Convertible seat
Fold the seatback forward. Then
return the seatback and secure it
at the first lock position (most
upright position). (→P. 6 8 )
Place the child restraint system on
the seat facing the front of the vehi-
cle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.
STEP1
STEP2
STEP3
GX460_CANADA.book Page 157 Thursday, February 4, 2010 11:54 AM

158
1-7. Safety information
GX460_CANADA (OM60F29U)Fully extend the shoulder belt and
allow it to retract to put it in lock
mode. In lock mode, the belt can-
not be extended.
While pushing the child restraint
system into the rear seat, allow the
shoulder belt to retract until the
child restraint system is securely in
place.
After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
If the child restraint has a top tether strap, the top tether strap
should be latched onto the top tether strap anchor. (
→P. 161)
STEP4
STEP5
STEP6
GX460_CANADA.book Page 158 Thursday, February 4, 2010 11:54 AM

159
1-7. Safety information
1
Before driving
GX460_CANADA (OM60F29U)■
Booster seat
Fold the seatback forward. Then
return the seatback and secure it
at the first lock position (most
upright position). (→P. 6 8 )
Place the child restraint system on
the seat facing the front of the vehi-
cle.
STEP1
STEP2
GX460_CANADA.book Page 159 Thursday, February 4, 2010 11:54 AM

162
1-7. Safety information
GX460_CANADA (OM60F29U)
■Laws and regulations pertaining to anchorages
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications
can be used.
This vehicle is designed to conform to the SAE J1819.
CAUTION
■When installing a booster seat
To prevent the belt from going into ALR lock mode, do not fully extend the shoulder
belt. ALR mode causes the belt to tighten only. This could cause injury or discom-
fort to the child. (→P. 88)
GX460_CANADA.book Page 162 Thursday, February 4, 2010 11:54 AM

164
1-7. Safety information
GX460_CANADA (OM60F29U)
CAUTION
■When installing a child restraint system
●When installing a child restraint system in the second center seat, adjust both
seatbacks at the same angle.
●When using the LATCH anchors for a child restraint system, move the seat as far
back as possible, with the seatback close to the child restraint system.
●When a booster seat is installed, always ensure that the shoulder belt is posi-
tioned across the center of the child’s shoulder. The belt should be kept away from
the child’s neck, but not so that it could fall off the child’s shoulder. Failing to do so
may result in death or serious injury in the event of an accident or sudden braking.
●Ensure that the belt and plate are securely locked and the seat belt is not twisted.
●Push and pull the child restraint system from side to side and forward to be sure it
is secure.
●After securing a child restraint system, never adjust the seat.
●Follow all installation instructions provided by the child restraint system manufac-
turer.
■Do not use a seat belt extender
If a seat belt extender is used when installing a child restraint system, the seat belt
will not securely hold the child restraint system, which could cause death or serious
injury to the child or other passengers in the event of an accident.
GX460_CANADA.book Page 164 Thursday, February 4, 2010 11:54 AM

168
GX460_CANADA (OM60F29U)
2-1. Driving procedures
Driving the vehicle
The following procedures should be observed to ensure safe driving:
■Starting the engine
→ P. 1 7 9
■ Driving
With the brake pedal depressed, shift the shift lever to D.
(→P. 1 8 6 )
Release the parking brake. ( →P. 193)
Gradually release the brake pedal and gently depress the
accelerator pedal to accelerate the vehicle.
■ Stopping
With the shift lever in D, depress the brake pedal.
If necessary, set the parking brake.
If the vehicle is to be stopped for an extended period of time, shift the
shift lever to P or N. ( →P. 1 8 6 )
■Parking the vehicle
With the shift lever in D, depress the brake pedal.
Set the parking brake. (→ P. 193)
Shift the shift lever to P. ( →P. 1 8 6 )
If parking on a hill, block the wheels as needed.
Press the “ENGINE START STOP” switch to stop the engine.
Lock the door, making sure that you have the key on your per-
son.
STEP1
STEP2
STEP3
STEP1
STEP2
STEP1
STEP2
STEP3
STEP4
STEP5
GX460_CANADA.book Page 168 Thursday, February 4, 2010 11:54 AM