sensor Lexus GX470 2005 Scheduled Maintenance Guide / LEXUS 2005 GX470 (OM60B11U) Owner's Guide

STARTING AND DRIVING
444
Driving over the steps such as the joints on the road.
 Driving on roads where the road surface is pitted or
has other differences in surface height.
Install all 4 tires of specified size at appropriate
pressure: The anti±lock brake system detects vehicle
speeds using the speed sensors for respective wheels'
turning speeds. The use of tires other than specified
may fail to detect the accurate turning speed resulting
in a longer stopping distance.ªABSº warning light

1U.S.A.2Canada
The light comes on when the ignition key is turned to the ªONº
position. If the anti±lock brake system and the brake assist
system work properly, the light turns off after a few seconds.
Thereafter, if either of the systems malfunctions, the light
comes on again.
When the ªABSº warning light is on (and the brake system
warning light is off), the anti±lock brake system, the brake
assist system, the active traction control system and the
vehicle stability control system do/does not operate, but the
brake system still operates conventionally.
When the ªABSº warning light is on (and the brake system
warning light is off), the anti±lock brake system does not
operate so that the wheels could lock up during a sudden
braking or braking on slippery road surfaces.

STARTING AND DRIVING
448
NOTICE
Do not use liquid sealants for a flat tire as air pressuresensors will be damaged.
When the tires must be repaired or replaced, havethem repaired or replaced by the nearest Lexusdealer or authorized tire dealer. The tire pressuresensors will be affected by the installation or removal
of tires.
The tire pressure warning system is not to be used as a substitute for regular inspections. Be sure to check
the air pressure in the tires on a regular basis.
When the tires must be replaced, replace the grommets for air pressure sensors as well.
If the warning light blinks:
The tire pressure warning system may be malfunctioning.
Contact your Lexus dealer.System malfunction
The tire pressure warning system does not function
properly under certain circumstances. In the following
cases, the low tire pressure warning light may not come
on even if the tire inflation pressure is low, or it may come
on when the tire inflation pressure is actually normal.
 Electric devices or facilities using similar radio wave
frequencies are nearby.
 A radio set to similar frequencies is in use.
 A lot of snow or ice covers the vehicle, in particular, around
the wheels or wheel housings.
 The tires are not equipped with an air pressure sensor.
 Tire chains are used.

STARTING AND DRIVING
449

Non±genuine Lexus wheels are used.
 Although the tires are equipped with air pressure sensors,
the selector switch (see page 455.) is set to other tire setting.
CAUTION
The use of non±genuine wheels will cause the air
pressure sensors to transmit the electronic code in
different manner, resulting in the system failure.
 The use of different type of tires with genuine wheels
may also cause the malfunction of the system.

STARTING AND DRIVING
454
Replacing tires and wheels
When replacing the wheels, be sure to install air pressure
sensors on the wheels.
There are 3 ways to set up the air pressure sensors:
(a) Remove the sensor from the old wheel and install it to the
new wheel.
(b) Keep the same wheel with air pressure sensor and replace
only the tire.
(c) Use a new wheel and sensor.
You have to register an ID code for a new sensor. Up to 2 sets
of codes can be registered. As one ID for the originally installed
sensor is registered at ªMAINº of the selector switch, use the
ª2ndº position to register an ID for the new sensor.
You do not need to re±register the ID code for any other
replacements. For the use of the originally installed tires, put
the selector switch at ªMAINº and for the use of tires set
purchased later, put the switch at ª2ndº. For the sensor
selector switch, see page 455.CAUTION
 Have the tires, wheels or sensors replaced and ID
codes registered by a Lexus dealer. If you need
sensors, purchase from a Lexus dealer.
 The use of non±genuine wheels will cause the air
pressure sensors to transmit the electronic code in
different manner, resulting in the failure of the
system.

STARTING AND DRIVING
455
Selector switch

1Main position22nd position
The selector switch is located in the lower part of the
driver's side instrument panel.
The ID code is given in the sensor. To activate the air
pressure warning system, it is necessary to register the ID
code of the sensor on the selector switch in the vehicle.2 sets of ID codes can be registered. The code of the tires
originally installed on the vehicle is registered on the switch at
ªMAINº. Have a new tires set with new air pressure sensors
registered at ª2ndº by Lexus dealer.
ID codes should be registered by Lexus dealer. Once
registered,
change the setting position each time you purchase
tires and wheels. Re±registration is not required.
When purchasing new tires, consult your Lexus dealer.
CAUTION
When the tires whose ID code is registered at ªMAINº
are used, the system does not work properly with the
selector switch set at ª2ndº. If the tires whose ID code
is registered at ª2ndº are stored nearby, the system will
detect their tire pressure (and vice versa).

ELECTRICAL COMPONENTS
604
33ABSSOL30
Anti±lock brake system,
vehicle stability control system,
active traction control system,
brake assist system
No.FUSEAMPERECIRCUIT
34ALT±S7.5Charging system
35MAYDAY7.5No circuit
36HORN10Horns
37A/F
HEATER15A/F sensor
38TRN±HAZ15Turn signal lights
39ETCS10Electronic throttle control system
40EFI20Multiport fuel injection
system/sequential multiport fuel
injection system
41D FR P/W20Power window
42DR/LCK25Power door lock
43TOWING30Towing converter
44RADIO NO.230Audio system, navigation
system
45A/PUMP50Multiport fuel injection
system/sequential multiport fuel
injection system
46IGN10
Multiport fuel injection
system/sequential multiport fuel
injection system, vehicle
stability control system

BODY
637
NOTICE

Use a good foam±type shampoo to clean the carpets.

Do not use dye or bleach on the belts Ð it mayweaken them.

Do not use the belts until they become dry.

The windows may be cleaned with any household
window cleaner.

Do not apply detergent to or wet the automatic wipercontrol sensor when cleaning the inside of thewindshield.

When cleaning the inside of the quarter and rearwindows, be careful not to scratch or damage the
wire antennas, heater wires or connectors.