check engine Lexus HS250h 2010 Instrument cluster / LEXUS 2010 HS250H (OM75006U) User Guide
[x] Cancel search | Manufacturer: LEXUS, Model Year: 2010, Model line: HS250h, Model: Lexus HS250h 2010Pages: 608, PDF Size: 9.89 MB
Page 411 of 608

411
4-2. Maintenance
4
Maintenance and care
General maintenance
Engine compartment
Tr u n k
ItemsCheck points
Brake fluidIs the brake fluid at the correct level?
( P.  4 3 1 )
CoolantIs the engine coolant at the correct 
level? ( P.  4 2 8 )
Engine oilIs the engine oil at the correct level? 
( P.  4 2 4 )
Exhaust systemThere should not be any fumes or 
strange sounds.
Radiator/condenser
The radiator and condenser should 
be free from foreign objects. 
( P.  4 3 0 )
Wa s h e r  f l u i dIs there sufficient washer fluid? 
( P.  4 3 2 )
ItemsCheck points
12-volt batteryCheck the connections. ( P.  4 3 3 )
Listed below are the general maintenance items that should be performed 
at the intervals specified in the “Warranty and Service Guide” or “Owner’s 
Manual Supplement”. It is recommend ed that any problem you notice 
should be brought to the attention of  your Lexus dealer or qualified service 
shop for advice. 
Page 414 of 608

414
4-2. Maintenance
Vehicle exterior
ItemsCheck points
Doors/trunk• Do the doors and trunk operate smoothly?
Engine hood• Does the engine hood lock system work properly?
Fluid leaks
• There should not be any signs of fluid leakage after the vehicle has 
been parked.
Ti r e s
• Is the tire inflation pressure cor-
rect?
• The tires should not be damaged or  excessively worn.
• Have the tires been rotated  according to the maintenance 
schedule?
• The wheel nuts should not be loose.
CAUTION
■If the hybrid system is operating
Turn the hybrid system off and ensure that  there is adequate ventilation before per-
forming maintenance checks. 
Page 424 of 608

424
4-3. Do-it-yourself maintenance
Engine oil
With the engine at operating temperature and turned off, check the oil 
level on the dipstick.
■ Checking the engine oil
Park the vehicle on level ground.  A
 fter turning off the hybrid sys-
tem, wait more than 5 minutes fo r the oil to dr
 ain back into the 
bottom of the engine.
Holding a rag under the end, pull 
the dipstick out.
Wipe the dipstick clean.
Reinsert the dipstick fully.
Holding a rag under the end, pull  the dipstick ou
 t and check the 
oil level.
Wipe the dipstick and reinsert it fully.
Low
Full 
Page 425 of 608

425
4-3. Do-it-yourself maintenance
4
Maintenance and care
■Adding engine oil
If the oil level is below or near the 
lo
w level mark, add engine oil of 
the same type as th at already in the 
engine.
Make sure to check the  oil type and pr
 epare the items needed before 
adding oil.
Remove the oil filler cap by turning it counterclockwise.
Add engine oil slowly, checking the dipstick.
Install the oil filler cap by turning it clockwise.
Engine oil selection P. 551
Oil quantity
(Low   Full)1.2 qt. (1.1 L, 1.0 lmp. qt.)
ItemsClean funnel 
Page 427 of 608

427
4-3. Do-it-yourself maintenance
4
Maintenance and care
CAUTION
■Used engine oil
●Used engine oil contains potentially harmful contaminants which may cause skin 
disorders such as inflammation and skin cancer, so care should be taken to avoid 
prolonged and repeated contact. To remove  used engine oil from your skin, wash 
thoroughly with soap and water.
●Dispose of used oil and filters only in a safe and acceptable manner. Do not dis-
pose of used oil and filters in househol d trash, in sewers or onto the ground. 
Call your Lexus dealer, service station or auto parts store for information con-
cerning recycling or disposal.
●Do not leave used engine oil within the reach of children.
NOTICE
■To prevent serious engine damage
Check the oil level on a regular basis.
■When replacing the engine oil
●Be careful not to spill engine oil on the vehicle components.
●Avoid overfilling, or the engine could be damaged.
●Check the oil level on the dipstick every time you refill the vehicle.
●Be sure the engine oil filler cap is properly tightened. 
Page 429 of 608

429
4-3. Do-it-yourself maintenance
4
Maintenance and care
Power control unit coolant reservoirReservoir cap
“FULL” line
“LOW” line
If the level is on or below the 
“LOW” line, add coolant up to the 
“FULL” line. (P.  5 5 2 )
■Coolant selection
Only use “Toyota Super Long Life Coolant”  or a s
 imilar high quality ethylene glycol 
based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life 
hybrid organic acid technology.
U.S.A.: “Toyota Super Long Life Coolant”  is a
  mixture of 50% coolant and 50% 
deionized water. (Minimum temperature: -31 F [-35C])
Canada: “Toyota Super Long Life Coolant” is a mixture of 55% coolant and 45%  d
 eionized water. (Minimum temperature: -44 F [-42 C])
For more details about coolant, contact your Lexus dealer.
■If the coolant level drops within  a short time of replenishing
Visually check the radiators, hoses, engine/power control unit coolant reservoir 
ca
 ps, drain cock and water pump.  
If you cannot find a leak, have your Lexus dealer test the cap and check for leaks in 
the coo
 ling systems. 
Page 430 of 608

430
4-3. Do-it-yourself maintenance
Radiator and condenser
Check the radiator and condenser and clear away any foreign objects. 
If either of the above parts is extremely  dir
 ty or you are not sure of their 
condition, have your vehicle inspected by your Lexus dealer.
CAUTION
■When the hybrid system is hot
Do not remove the engine/power control unit coolant reservoir caps.  
The cooling system may be under pressure and may spray hot coolant if the cap is 
removed, causing burns or other injuries.
NOTICE
■When adding coolant
Coolant is neither plain water nor straight  antifreeze. The correct mixture of water 
and antifreeze must be used to provide  proper lubrication, corrosion protection 
and cooling. Be sure to read the antifreeze or coolant label.
■If you spill coolant
Be sure to wash it off with water to prevent it from damaging parts or paint.
CAUTION
■When the hybrid system is hot
Do not touch the radiators or condense r as they may be hot and cause burns. 
Page 455 of 608

455
4-3. Do-it-yourself maintenance
4
Maintenance and care
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. 
If this happens, check and replace the fuses as necessary.
Turn the “POWER” switch off.
Open the fuse box cover.
Engine compartment
Push the tab in and lift the lid off.
Driver’s side instrument panel Remove the lid.
After a system failure, see “Fuse la y
 out and amperage ratings” 
( P.  4 5 8 ) for details about which fuse to check. 
Page 469 of 608

469
4-3. Do-it-yourself maintenance
4
Maintenance and care
Light bulbs
You may replace the following bulbs by yourself. The difficulty level of 
replacement varies depending on the bulb. If necessary bulb replacement 
seems difficult to perform, contact your Lexus dealer. 
For more information about replacing other light bulbs, contact your Lexus 
dealer
 .
■Preparing for light bulb replacement
Check the wattage of the light bulb to be replaced. ( P.
  5 5 6 )
■ R
emove the engine compartment covers
  P.
 4 2 3
■ F
ront bulb locations
Halogen headlights
Front side marker lightHeadlight low beam
Parking light
Front turn signal light
Front fog light
Headlight high beam 
Page 506 of 608

506
5-2. Steps to take in an emergency
(Flashes)
(If equipped)
Indicates that the moon 
roof is not fully closed A buzzer also sounds. 
(With the “POWER” 
switch off, and the 
driver's door open)
Close the moon roof.
Indicates that the parking 
brake is still engagedIf the vehicle reaches a 
speed of 3 mph  
(5 km/h),   
flashes and a buzzer 
sounds to indicate that 
the parking brake is still 
engaged.
Release the parking 
brake.
Indicates that the washer 
fluid level is lowAdd washer fluid.
(U.S.A. only)
Indicates that the engine 
oil is scheduled to be 
changed
Check the engine oil, and 
change if necessary.
Comes on approximately 
4500 miles (7200 km) 
after the engine oil is 
changed. 
 (The indicator will not 
work properly unless the 
oil maintenance data has 
been reset.)
Wa r n i n g  m e s s a g eDetailsCorrection procedure