low beam Lexus HS250h 2010 Wide View Front Monitor System / LEXUS 2010 HS250H QUICK GUIDE OWNERS MANUAL (OM75023U)

35
Automatic High Beam (If Equipped)
Turn the headlight switch to the “AUTO”
position.
Push the lever away from you.
The Automatic High Beam indicator will
come on when the headlights are turned
on automatically to indicate that the sys-
tem is active.

The Automatic High Beam uses an in-vehicle camera sensor to assess the brightness of
streetlights, the lights of oncoming and preceding vehicles, etc., and automatically turns
high beam on or off as necessary.
When all of the following conditions are fulfilled, high beam will be automatically turned on
(after approximately 1 second):
• Vehicle speed is above approximately 20 mph (32 km/h).
• The area ahead of the vehicle is dark.
• There are no oncoming or preceding vehicles with headlights or tail lights turned on.

82
What to do if...
*: It also comes on due to natural causes such as natural air leaks and tire inflation pressure
changes caused by temperature. Adjust the tire inflation pressure.
Follow the correction procedures.
Open door warning light(On the center
panel)
Front passenger’s seat belt
reminder light
Low fuel level warning lightMaster warning light
(On the instru-
ment cluster)
Driver’s seat belt reminder
light
(Illuminate no
flashing)Tire pressure warning light*
See the Owner's Manual
Tu r n s i g n a l i n d i c a t o rCruise control indicator
Headlight indicator (U.S.A.)Radar cruise control
indicator (if equipped)
Tail light indicator (Canada)“LKA” indicator (if equipped)
Headlight high beam indicator“SET” indicator
Automatic High Beam
indicator*1Intuitive parking assist
indicator (if equipped)
Front fog light indicator“AFS OFF” indicator
(if equipped)
“READY” indicator
(Flashing)
Slip indicator
EV drive mode indicatorVSC OFF indicator
Eco Driving Indicator Light
(Flashes faster)
“PCS” indicator
“ECO MODE” indicatorSRS airbag on-off indicator
“PWR MODE” indicator
For further information, refer to the Owner's Manual.