change time Lexus IS250 2014 Navigation Manual

172
5. SETUP
IS300h/250_Navi_EE
1Display the “Navigation settings”
screen. (→P.170)
2Select “Average speed”.
3Select “” or “” to set the average ve-
hicle speeds.
“Default”: Select to set the default speeds.
“Consider traffic info”: Select to set use set-
tings based on traffic information.
1Display the “Navigation settings”
screen. (→P.170)
2Select “Select POI icons”.
3Select the category to be changed.
“Default”: Select to set the default catego-
ries.
4Select the desired category.
“List all categories”: Select to display all
POI categories.
5Select the desired POI icon.
AVERAGE SPEED
The speed that is used for the calculation
of the estimated travel time and estimat-
ed arrival time can be set.
INFORMATION
●
The displayed time to the destination is
the approximate driving time that is cal-
culated based on the selected speeds
and the actual position along the guid-
ance route.
●The time shown on the screen may vary
greatly depending on progress along the
route, which may be affected by condi-
tions such as traffic jams and construction
work.
POI CATEGORY CHANGE
(SELECT POI ICONS)
Up to 6 POI icons, which are used for
selecting POIs on the map screen, can
be selected as favourites.
IS_Navi_EE_53C71E.book 172 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

185
6. TIPS FOR THE NAVIGATION SYSTEM
IS300h/250_Navi_EE
NAVIGATION SYSTEM
3
zAccurate current position may not be
shown in the following cases:
• When driving on a small angled Y-shaped
road.
• When driving on a winding road.
• When driving on a slippery road such as
in sand, gravel, snow, etc.
• When driving on a long straight road.
• When motorway and surface streets run
in parallel.
• After moving by ferry or vehicle carrier.
• When a long route is searched during
high speed driving.
• When driving without setting the current
position calibration correctly.
• After repeating a change of direction by
going forward and backward, or turning
on a turntable in a parking lot.
• When leaving a covered parking lot or
parking garage.
• When a roof carrier is installed.
• When driving with tyre chains installed.
• When the tyres are worn.
• After replacing a tyre or tyres.
• When using tyres that are smaller or
larger than the factory specifications.
• When the tyre pressure in any of the 4
tyres is not correct.zInappropriate route guidance may occur in
the following cases:
• When turning at an intersection off the
designated route guidance.
• If you set more than 1 destination but skip
any of them, auto reroute will display a
route returning to the destination on the
previous route.
• When turning at an intersection for which
there is no route guidance.
• When passing through an intersection for
which there is no route guidance.
• During auto reroute, the route guidance
may not be available for the next turn to
the right or left.
• During high speed driving, it may take a
long time for auto reroute to operate. In
auto reroute, a detour route may be
shown.
• After auto reroute, the route may not be
changed.
• If an unnecessary U-turn is shown or
announced.
• If a location has multiple names and the
system announces 1 or more of them.
• When a route cannot be searched.
• If the route to your destination includes
gravel, unpaved roads or alleys, the route
guidance may not be shown.
zIf the vehicle cannot receive GPS signals,
the current position can be adjusted
manually. (→P.1 7 3 )
IS_Navi_EE_53C71E.book 185 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

195
1. BASIC OPERATION
AUDIO/VISUAL SYSTEM
IS300h/250_Navi_EE
4
XUsing the instrument panel
1Each time the “RADIO” or “MEDIA”
button is pressed, the audio control
mode changes.
“RADIO” button: To display the radio oper-
ation screen.
“MEDIA” button: To display the external
media operation screen.
XUsing the Remote Touch
1Press the “MENU” button on the
Remote Touch.
2Select “A u d i o ”.
3Select “Source”.
4Select the desired source.
SELECTING AN AUDIO
SOURCE
INFORMATION
●Dimmed screen buttons cannot be oper-
ated.
IS_Navi_EE_53C71E.book 195 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

204
2. RADIO OPERATION
IS300h/250_Navi_EE
No.Function
Select to display the manual tuning screen.
Select to display the station list screen.
Select to display the preset station screen.
Select to display the audio source selection screen.
Select to display the audio setting screen.
Select to tune to preset stations/ensembles.
Select to display the time shift operation screen.
Tune/Scroll knob:
•“Presets” screen: Turn to select preset stations/ensembles.
•“Stations” screen: Turn to move up/down the list.
•Manual tuning screen: Turn to step up/down frequencies or change services.
•“DAB time shift” screen: Turn to jump forward/backwards.
Press to turn mute on/off.
•Press to move up/down the preset stations/ensembles.
•Press to move up/down the station list.
•Press and hold 0.8 sec. or more to seek up/down available stations/ensembles continu-
ously while the button is being pressed.
•Press to select a radio mode.
•While in a radio mode, pressing the “RADIO” button changes radio modes.
Power/Volume knob:
•Turn to adjust volume.
•Press to turn the audio system on/off.
•Press and hold to restart the audio system.
INFORMATION
●The radio automatically changes to stereo reception when a stereo broadcast is received.
●If the signal becomes weak, the radio reduces the amount of channel separation to prevent
the weak signal from creating noise. If the signal becomes extremely weak, the radio
switches from stereo to mono reception.
IS_Navi_EE_53C71E.book 204 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

213
3. MEDIA OPERATION
IS300h/250_Navi_EE
AUDIO/VISUAL SYSTEM
4
1Select .
zEach time is selected, the mode
changes as follows:
• track repeat
→ off
1Select .
zEach time is selected, the mode
changes as follows:
•random (1 disc random)
→ off
PLAYING AN AUDIO CD
REPEATING
The track currently being listened to can
be repeated.
INFORMATION
●When is selected, “RPT” appears
on the screen.
RANDOM ORDER
Tracks can be automatically and ran-
domly selected.
INFORMATION
●When is selected, “RAND”
appears on the screen.
IS_Navi_EE_53C71E.book 213 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

214
3. MEDIA OPERATION
IS300h/250_Navi_EE
1Select .
zEach time is selected, the mode
changes as follows:
XWhen random playback is off
• file repeat → folder repeat → off
XWhen random playback is on
• file repeat → off
1Select .
zEach time is selected, the mode
changes as follows:
•random (1 folder random)
→ folder random (1 disc random) → off
PLAYING AN MP3/WMA/
AAC DISC
REPEATING
The file or folder currently being listened
to can be repeated.
INFORMATION
●Each time is selected, “RPT”/
“FLD.RPT” appears on the screen.
RANDOM ORDER
Files or folders can be automatically and
randomly selected.
INFORMATION
●Each time is selected, “RAND”/
“FLD.RAND” appears on the screen.
IS_Navi_EE_53C71E.book 214 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

220
3. MEDIA OPERATION
IS300h/250_Navi_EE
1Select “Search”.
2Enter the title number and select “OK”.
zThe player starts playing video for that title
number.
1Select “A u d i o ”.
2Each time “Change” is selected, the au-
dio language is changed.
zThe languages available are restricted to
those available on the DVD disc.
1Select “Subtitle”.
2Each time “Change” is selected, the lan-
guage the subtitles are displayed in is
changed.
zThe languages available are restricted to
those available on the DVD disc.
zWhen “Hide” is selected, the subtitles can
be hidden.
SEARCHING BY TITLE
CHANGING THE AUDIO
LANGUAGE
CHANGING THE SUBTITLE
LANGUAGE
IS_Navi_EE_53C71E.book 220 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

221
3. MEDIA OPERATION
IS300h/250_Navi_EE
AUDIO/VISUAL SYSTEM
4
1Select “A n g l e ”.
2Each time “Change” is selected, the an-
gle is changed.
zThe angles available are restricted to those
available on the DVD disc.
CHANGING THE ANGLE
The angle can be selected for discs that
are multi-angle compatible when the an-
gle mark appears on the screen.
IS_Navi_EE_53C71E.book 221 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

225
3. MEDIA OPERATION
IS300h/250_Navi_EE
AUDIO/VISUAL SYSTEM
4
•Press to select a media mode.
•While in a media mode, pressing the
“MEDIA” button changes media modes.•Press to select a media mode.
•While in a media mode, pressing the
“MEDIA” button changes media modes.
Power/Volume knob:
•Turn to adjust volume.
•Press to turn the audio system on/off.
•Press and hold to restart the audio sys-
tem.Power/Volume knob:
•Turn to adjust volume.
•Press to turn the audio system on/off.
•Press and hold to restart the audio sys-
tem.
CAUTION
●Do not operate the player’s controls or connect the USB memory while driving.
NOTICE
●Depending on the size and shape of the USB memory that is connected to the system, the
armrest may not close fully. In this case, do not forcibly close the armrest as this may dam-
age the USB memory or the terminal, etc.
●Do not leave your portable player in the car. In particular, high temperatures inside the vehi-
cle may damage the portable player.
●Do not push down on or apply unnecessary pressure to the portable player while it is con-
nected as this may damage the portable player or its terminal.
●Do not insert foreign objects into the port as this may damage the portable player or its ter-
minal.
INFORMATION
●The system can only output the sound while driving.
●Audio files and image files can be played back at the same time. However, the slide show
interval may be longer than when an audio file is not being played back.
●If tag information exists, the file/folder names will be changed to track/album names.
No.Function
AudioVideo
IS_Navi_EE_53C71E.book 225 ページ ２０１４年５月２９日　木曜日　午前１１時２２分

226
3. MEDIA OPERATION
IS300h/250_Navi_EE
1Select .
zEach time is selected, the mode
changes as follows:
XWhen random playback is off
• file/track repeat → folder/album
repeat → off
XWhen random playback is on
• file/track repeat → off
1Select .
zEach time is selected, the mode
changes as follows:
• random (1 folder/album random) →
folder/album random (all folder/album
random) → off
USB AUDIO
REPEATING
The file/track or folder/album currently
being listened to can be repeated.
INFORMATION
●Each time is selected, “RPT”/
“FLD.RPT” appears on the screen.
RANDOM ORDER
Files/tracks or folders/albums can be
automatically and randomly selected.
INFORMATION
●Each time is selected, “RAND”/
“FLD.RAND” appears on the screen.
IS_Navi_EE_53C71E.book 226 ページ ２０１４年５月２９日　木曜日　午前１１時２２分