Lexus IS300 2003 Basic Functions / LEXUS 2003 IS300 OWNER'S MANUAL (OM53439U)

COMFORT ADJUSTMENT
98
Adjusting seatback angle
SS16005
Lean forward and pull the lever up. Then lean back to the
desired angle and release the lever.
CAUTION
To reduce the risk of sliding under the lap belt during a
collision, avoid reclining the seatback any more than
needed. The seat belts provide maximum protection in
a frontal or rear collision when the driver and the
passenger are sitting up straight and well back in the
seats. If you are reclined, the lap belt may slide past
your hips and apply restraint forces directly to the
abdomen. In the event of a frontal collision, the more the
seat is reclined, the greater the risk of personal injury.
Adjusting seat cushion height
SS16007
Turn the knob either way.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
99
Adjusting seat cushion front edge angle
SS16009
Turn the knob either way.
Folding down front passenger's seatback
SV16080
Return the seatback to the up±right position. Pull up the
side levers and fold the seatback down.
SV16132
You can use the front passenger's seatback as a temporary
table only when the vehicle is stopped.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
100
CAUTION
To avoid serious injury:
Do not set up the seatback table while the vehicle is
moving.
 Do not sit on the folded seatback.
 Make sure the front passenger's seat is securely
locked in sliding position when you set the front pas-
senger's seat as a temporary table.
NOTICE
To prevent the seat from damaging, avoid putting heavy
loads on the temporary table.
FOLD±DOWN REAR SEATS
Before folding down rear seats
SV16105
1To stow the rear center seatbelt, line the concave end tab
upon the round end tab.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
101
SV16106
2Wrap up the concave end tab and the round end tab lined
upon each other.
SV16107
3Insert these tabs in the hollow of the seatbelt cover, pull
it up and hook it while pressing the ºPUSHº mark.
Seat belt must be stowed before you fold the seatback. (See
ºFold±down rear seatsº on page 100.)
NOTICE
The seat belt must be stowed before you fold the seat- back.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
102
Folding down rear seats
SV16103
Lower the head restraints to the lowest position, unlock
the seatbacks by pushing the lock release button on the
side of the seatback and fold them down.
When returning the rear seats to their original position, lift
up the seatbacks until they lock.
CAUTION
When returning seats to their original position:
 Make sure the seat belts are not twisted or caught
under the seat and are arranged in their proper posi-
tion and are ready to use.
 Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback.
TRUNK STORAGE EXTENSION
SV16005
1. Pull down the center armrest in the rear seat.
Open the cover (a) by removing the strap and unzipping the
fastener of the cover (a).
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
103
SV16082
2. Pull the lever, lift the cover (b) up and fix it to the upper
part of the trunk using the magnet attached on the cover
(b).
Be sure to use ºLEXUS Genuine Sports Gear, Bagº for carrying
long objects (ski board, poles, etc.) properly.
For installation and handling of the ºLEXUS Genuine Sports
Gearº, follow the instructions provided with goods.
CAUTION
Be sure to close the cover (a) and (b) when the trunk
storage extension is not in use. Goods in the luggage
compartment may be thrown into the passenger
compartment in a sudden stop or crash resulting in
injury.
ARMRESTS
SV16129

Front
SV16130

Rear
To use the armrests, pull them down as shown above.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
104
NOTICE
To prevent damage to the armrests, avoid putting heavyloads on them.
HEAD RESTRAINTS
Front seats
SV16006
To raise the head restraint, pull it up. To lower it, press the
lock release button and push the head restraint down. To
move the head restraint forward or rearward, pull or push
on the top.
The head restraint is most effective when it is close to your
head. Therefore, using a cushion on the seatback is not
recommended.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
105
CAUTION
Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed.
Rear seats
SV16007

Outside rear seats
SV16008

Center rear seat
To raise the head restraint, pull it up. To lower it, press the
lock release button and push the head restraint down.
Center rear head restraint: When an occupant sits on the
center rear seat, always pull up the head restraint to the lock
position.
The head restraint is most effective when it is close to your
head. Therefore, using a cushion on the seatback is not
recommended.
CAUTION
 Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
106
TILT STEERING WHEEL
SV16064
To change the steering wheel angle, hold the steering
wheel, pull the lock release lever toward you, tilt the
steering wheel to the desired angle and release the lever.
When the steering wheel is in a low position, it will spring up as
you release the lock release lever.
CAUTION
 Do not adjust the steering wheel while the vehicle is
moving. Doing so may cause the driver to mishandle
the vehicle and an accident may occur resulting in
death or injuries.
 After adjusting the steering wheel, try moving it up
and down to make sure it is locked in position.
OUTSIDE REAR VIEW MIRRORS
SV16010
Adjust the mirror so that you can just see the side of your
vehicle in the mirror.
Be careful when judging the size or distance of any object seen
in the outside rear view mirror on the passenger's side. It is a
convex mirror with a curved surface. Any object seen in a
convex mirror will look smaller and farther away than if seen in
a normal flat mirror.
When you push the rear window and outside rear view mirror
defogger switch or operate the wipers, the heater panels in the
outside rear view mirrors will quickly clear the mirror surface.
(See º Rear window and outside rear view mirror defogger, and
windshield wiper deicer switchº on page 34.)
Some models: When the inside rear view mirror darkens in
ºAUTOº mode, the outside rear view mirrors also darken to
reduce the reflection of the headlights of the following vehicle.
For details, see ºInside rear view mirrorº on page 108.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
107
CAUTION
Do not adjust the mirror while the vehicle is moving.
Doing so may cause the driver to mishandle the
vehicle and an accident may occur, resulting in
personal death or injuries.
 Since the mirror surfaces can get hot, keep your
hands off them when the rear window and outside
rear view mirror defogger switch is on or operate the
wipers.
Power rear view mirror control
SV16012

1Master switch 2Control switch
To adjust the power rear view mirror, first place the master
switch at ºLº (left) or ºRº (right), and push the contro\
l
switch on the desired side.
The power rear view mirrors can be adjusted when the key is
in the ºACCº or ºONº position.
NOTICE
If ice should jam the mirror, do not operate the control
or scrape the mirror face. Use a spray de±icer to free themirror.
Folding rear view mirrors
SS16030
To fold the rear view mirror, push backward.
The rear view mirrors can be folded backward for parking in
restricted areas.
CAUTION
Do not drive with the mirrors folded backward. Both the
driver and passenger side rear view mirrors must be
extended and properly adjusted before driving.
2003 IS300 from Aug. '02 Prod. (OM53439U)