seat adjustment Lexus IS300 2003 Basic Functions / LEXUS 2003 IS300 (OM53439U) User Guide

COMFORT ADJUSTMENT
97
Adjusting front seats
SS16001

1Seat position lock release lever
2Seat cushion front edge angle adjusting knob
3Seat cushion height adjusting knob
4Seatback angle lock release lever
Adjusting seat position
SS16003
Hold the center of the lever and pull it up. Then slide the
seat to the desired position with slight body pressure and
release the lever.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
98
Adjusting seatback angle
SS16005
Lean forward and pull the lever up. Then lean back to the
desired angle and release the lever.
CAUTION
To reduce the risk of sliding under the lap belt during a
collision, avoid reclining the seatback any more than
needed. The seat belts provide maximum protection in
a frontal or rear collision when the driver and the
passenger are sitting up straight and well back in the
seats. If you are reclined, the lap belt may slide past
your hips and apply restraint forces directly to the
abdomen. In the event of a frontal collision, the more the
seat is reclined, the greater the risk of personal injury.
Adjusting seat cushion height
SS16007
Turn the knob either way.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
99
Adjusting seat cushion front edge angle
SS16009
Turn the knob either way.
Folding down front passenger's seatback
SV16080
Return the seatback to the up±right position. Pull up the
side levers and fold the seatback down.
SV16132
You can use the front passenger's seatback as a temporary
table only when the vehicle is stopped.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
100
CAUTION
To avoid serious injury:
Do not set up the seatback table while the vehicle is
moving.
 Do not sit on the folded seatback.
 Make sure the front passenger's seat is securely
locked in sliding position when you set the front pas-
senger's seat as a temporary table.
NOTICE
To prevent the seat from damaging, avoid putting heavy
loads on the temporary table.
FOLD±DOWN REAR SEATS
Before folding down rear seats
SV16105
1To stow the rear center seatbelt, line the concave end tab
upon the round end tab.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
101
SV16106
2Wrap up the concave end tab and the round end tab lined
upon each other.
SV16107
3Insert these tabs in the hollow of the seatbelt cover, pull
it up and hook it while pressing the ºPUSHº mark.
Seat belt must be stowed before you fold the seatback. (See
ºFold±down rear seatsº on page 100.)
NOTICE
The seat belt must be stowed before you fold the seat- back.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
102
Folding down rear seats
SV16103
Lower the head restraints to the lowest position, unlock
the seatbacks by pushing the lock release button on the
side of the seatback and fold them down.
When returning the rear seats to their original position, lift
up the seatbacks until they lock.
CAUTION
When returning seats to their original position:
 Make sure the seat belts are not twisted or caught
under the seat and are arranged in their proper posi-
tion and are ready to use.
 Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback.
TRUNK STORAGE EXTENSION
SV16005
1. Pull down the center armrest in the rear seat.
Open the cover (a) by removing the strap and unzipping the
fastener of the cover (a).
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
104
NOTICE
To prevent damage to the armrests, avoid putting heavyloads on them.
HEAD RESTRAINTS
Front seats
SV16006
To raise the head restraint, pull it up. To lower it, press the
lock release button and push the head restraint down. To
move the head restraint forward or rearward, pull or push
on the top.
The head restraint is most effective when it is close to your
head. Therefore, using a cushion on the seatback is not
recommended.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
105
CAUTION
Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed.
Rear seats
SV16007

Outside rear seats
SV16008

Center rear seat
To raise the head restraint, pull it up. To lower it, press the
lock release button and push the head restraint down.
Center rear head restraint: When an occupant sits on the
center rear seat, always pull up the head restraint to the lock
position.
The head restraint is most effective when it is close to your
head. Therefore, using a cushion on the seatback is not
recommended.
CAUTION
 Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
11 3
CAUTION
When doing the circling calibration, be sure to secure
a wide space, and watch out for people and vehicles
in the neighborhood. Do not violate any local traffic
rules while performing circling calibration.
 Do not adjust the display while the vehicle is moving.
Be sure to adjust the display only when the vehicle is
stopped.
SEAT BELTS
Seat belt precautions
Lexus strongly urges that the driver and passengers in the
vehicle be properly restrained at all times with the seat belts
provided. Failure to do so could increase the chance of injury
and/or the severity of injury in accidents.
The seat belts provided for your vehicle are designed for
people of adult size, large enough to properly wear them.
Child. Use a child restraint system appropriate for the child
until the child becomes large enough to properly wear the
vehicle's seat belts. See ºChild restraintº on page 140 for
details.
If a child is too large for a child restraint system, the child should
sit in the rear seat and must be restrained using the vehicle's
seat belt. According to accident statistics, the child is safer
when properly restrained in the rear seat than in the front seat.
If a child must sit in the front seat, the seat belts should be worn
properly. Do not let the child sit on your lap. It does not provide
sufficient restraint. If an accident occurs and the seat belts are
not worn properly, the force of the rapid inflation of the airbag
may cause severe injury to the child.
Do not allow the child to stand up or kneel on either rear or front
seats. An unrestrained child could suffer serious injury or
death during emergency braking or a collision.
Pregnant woman. Lexus recommends the use of a seat belt.
Ask your doctor for specific recommendations. The lap belt
should be worn securely and as low as possible over the hips
and not on the waist.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
11 4Injured person. Lexus recommends the use of a seat belt.
Depending on the injury, first check with your doctor for specific
recommendations.
CAUTION
Persons should ride in their seats properly wearing
their seat belts whenever the vehicle is moving.
Otherwise, they are much more likely to suffer serious
bodily injury or death in the event of sudden braking or
a collision.
When using the seat belts, observe the following:

Use the belt for only one person at a time. Do not use
a single belt for two or more people ± even children.
 Avoid reclining the seatbacks too much. The seat
belts provide maximum protection when the
seatbacks are in the upright position. (See
ºAdjusting seatback angleº on page 93 or 98.)
 Be careful not to damage the belt webbing or
hardware. Take care that they do not get caught or
pinched in the seat or doors.
 Inspect the belt system periodically. Check for cuts,
fraying, and loose parts. Damaged parts should be
replaced. Do not disassemble or modify the system.
Keep the belts clean and dry. If they need cleaning,
use a mild soap solution or lukewarm water. Never
use bleach, dye, or abrasive cleaners ± they may
severely weaken the belts. (See ºCleaning the
interiorº on page 367 for instructions.)
 Replace the belt assembly (including bolts) if it has
been used in a severe impact. The entire assembly
should be replaced even if damage is not obvious.
Fastening front and rear seat belts
SV16013
Adjust the seat as needed and sit up straight and well back
in the seat. To fasten your belt, pull it out of the retractor
and insert the tab into the buckle.
You will hear a click when the tab locks into the buckle.
The seat belt length automatically adjusts to your size and the
seat position.
2003 IS300 from Aug. '02 Prod. (OM53439U)