lock Lexus IS300 2003 Basic Functions / LEXUS 2003 IS300 (OM53439U) Service Manual

EXTERIOR EQUIPMENT
87
MOON ROOF
SV15003

1Open 2Close
To slide open the moon roof, push the switch on the rear
side briefly. The moon roof will open and stop partway 80
mm (3.2 in.) from the fully opened position. When you
push the switch again, the moon roof will open fully. To
stop partway, push the same switch or ºTILTº switch
briefly while the moon roof is moving.
As driving with the moon roof opened fully will cause wind
throbs, we recommend you to drive with the moon roof partway
80 mm (3.2 in.) from the fully opened position.
To operate the moon roof, the ignition key must be in the ºONº
position.
The sun shade can be opened or closed manually. However,
if you open the moon roof, the sun shade will be opened with
the moon roof. To close the moon roof, push the switch on the front side.
The moon roof will fully close. To stop partway, push the
same switch or ºTILTº switch.
SS15012

1Tilt up 2Lower
To tilt up the rear end of the moon roof fully, push the
switch on the rear side or on the front side to lower it.
To operate the moon roof, the ignition key must be in the ºONº
position.
Key off operation:
Even if the ignition key is turned to the
ºACCº or ºLOCKº position, the moon roof can be operated until
either of the front doors is opened (or for about 45 seconds).
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
94
Folding down front passenger's seatback
SV16080
Return the seatback to the up±right position. Pull up the
side levers and fold the seatback down.
SV16081
You can use the front passenger's seatback as a temporary
table only when the vehicle is stopped.
CAUTION
To avoid serious injury:
Do not set up the seatback table while the vehicle is
moving.
 Do not sit on the folded seatback.
 Make sure the front passenger's seat is securely
locked in sliding position when you set the front pas-
senger's seat as a temporary table.
NOTICE
To prevent the seat from damaging, avoid putting heavy
loads on the temporary table.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
96
Front seat precautions
(on vehicles with side airbags)
CAUTION
The side airbags are installed in the driver and front
passenger seats. Observe the following precautions.
Do not lean against the front door when the vehicle
is in use, since the side airbag inflates with
considerable speed and force. Otherwise, you may
be killed or seriously injured.
 Do not modify or replace the seats or the upholstery
of seats with side airbags. Such changes may
disable the system, or cause the side airbags to
inflate accidentally, resulting in death or serious
injury. Consult your Lexus dealer if you insist on
modifications of this kind.
 Do not use seat accessories which cover the area
where the side airbags infla te. Such accessories may
prevent the side airbags from activating correctly,
causing death or serious injury.
Seat adjustment precautions
CAUTION
 Do not adjust the seat while the vehicle is moving as
the seat may unexpectedly move and cause the
driver to lose control of the vehicle.
 Be careful that the seat does not hit a passenger,
luggage or the rear seat.
 After adjusting the seat position, release the lever
and try sliding the seat forward and backward to
make sure it is locked in position.
 After adjusting the seatback, exert body pressure to
make sure it is locked in position.
 Do not put objects under the seats. Otherwise, the
objects may interfere with the seat±lock mechanism
or unexpectedly push up the seat position adjusting
lever and the seat may suddenly move, causing the
driver to lose control of the vehicle.
 While adjusting the seat, do not put your hands under
the seat or near the moving parts. Otherwise, your
hands or fingers may be caught and injured.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
97
Adjusting front seats
SS16001

1Seat position lock release lever
2Seat cushion front edge angle adjusting knob
3Seat cushion height adjusting knob
4Seatback angle lock release lever
Adjusting seat position
SS16003
Hold the center of the lever and pull it up. Then slide the
seat to the desired position with slight body pressure and
release the lever.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
100
CAUTION
To avoid serious injury:
Do not set up the seatback table while the vehicle is
moving.
 Do not sit on the folded seatback.
 Make sure the front passenger's seat is securely
locked in sliding position when you set the front pas-
senger's seat as a temporary table.
NOTICE
To prevent the seat from damaging, avoid putting heavy
loads on the temporary table.
FOLD±DOWN REAR SEATS
Before folding down rear seats
SV16105
1To stow the rear center seatbelt, line the concave end tab
upon the round end tab.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
102
Folding down rear seats
SV16103
Lower the head restraints to the lowest position, unlock
the seatbacks by pushing the lock release button on the
side of the seatback and fold them down.
When returning the rear seats to their original position, lift
up the seatbacks until they lock.
CAUTION
When returning seats to their original position:
 Make sure the seat belts are not twisted or caught
under the seat and are arranged in their proper posi-
tion and are ready to use.
 Make sure the seat is securely locked by pushing
forward and rearward on the top of the seatback.
TRUNK STORAGE EXTENSION
SV16005
1. Pull down the center armrest in the rear seat.
Open the cover (a) by removing the strap and unzipping the
fastener of the cover (a).
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
104
NOTICE
To prevent damage to the armrests, avoid putting heavyloads on them.
HEAD RESTRAINTS
Front seats
SV16006
To raise the head restraint, pull it up. To lower it, press the
lock release button and push the head restraint down. To
move the head restraint forward or rearward, pull or push
on the top.
The head restraint is most effective when it is close to your
head. Therefore, using a cushion on the seatback is not
recommended.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
105
CAUTION
Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed.
Rear seats
SV16007

Outside rear seats
SV16008

Center rear seat
To raise the head restraint, pull it up. To lower it, press the
lock release button and push the head restraint down.
Center rear head restraint: When an occupant sits on the
center rear seat, always pull up the head restraint to the lock
position.
The head restraint is most effective when it is close to your
head. Therefore, using a cushion on the seatback is not
recommended.
CAUTION
 Adjust the center of the head restraint so that it is
closest to the top of your ears.
 After adjusting the head restraint, make sure it is
locked in position.
 Do not drive with the head restraints removed.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
106
TILT STEERING WHEEL
SV16064
To change the steering wheel angle, hold the steering
wheel, pull the lock release lever toward you, tilt the
steering wheel to the desired angle and release the lever.
When the steering wheel is in a low position, it will spring up as
you release the lock release lever.
CAUTION
 Do not adjust the steering wheel while the vehicle is
moving. Doing so may cause the driver to mishandle
the vehicle and an accident may occur resulting in
death or injuries.
 After adjusting the steering wheel, try moving it up
and down to make sure it is locked in position.
OUTSIDE REAR VIEW MIRRORS
SV16010
Adjust the mirror so that you can just see the side of your
vehicle in the mirror.
Be careful when judging the size or distance of any object seen
in the outside rear view mirror on the passenger's side. It is a
convex mirror with a curved surface. Any object seen in a
convex mirror will look smaller and farther away than if seen in
a normal flat mirror.
When you push the rear window and outside rear view mirror
defogger switch or operate the wipers, the heater panels in the
outside rear view mirrors will quickly clear the mirror surface.
(See º Rear window and outside rear view mirror defogger, and
windshield wiper deicer switchº on page 34.)
Some models: When the inside rear view mirror darkens in
ºAUTOº mode, the outside rear view mirrors also darken to
reduce the reflection of the headlights of the following vehicle.
For details, see ºInside rear view mirrorº on page 108.
2003 IS300 from Aug. '02 Prod. (OM53439U)

COMFORT ADJUSTMENT
11 2
CAUTION
Do not adjust the display while the vehicle is moving.
Be sure to adjust the display only when the vehicle is
stopped.
CALIBRATING THE COMPASS (circling calibration)
SV16139
ºCº appears on the display in case the circling calibration is
required due to a drastic change in the magnetic field. To
rectify this, follow the calibration procedure below.
SV16079
Drive the vehicle slowly (at 8 km/h (5 mph) or lower) in a circle
until the direction is displayed. If there is not enough space to
drive in a circle, drive around the block until the direction is
displayed.
After driving in 1 to 3 circles in the above method, calibration
is complete with the direction shown on the display.
If calibration cannot be performed because of the magnetized
vehicle, etc., take your vehicle to Lexus dealer.
 Do not perform circling calibration of the compass in a place
where the earth's magnetic field is subject to interference by
artificial magnetic fields (underground parking, under a
steel tower, between buildings, roof parking, near a
crossing, near a large vehicle, etc.).
 During calibration, do not operate electric systems (moon
roof, power windows, etc.) as they may interfere with the
calibration.
2003 IS300 from Aug. '02 Prod. (OM53439U)