child restraint Lexus IS300 2005 Basic Functions / LEXUS 2005 IS300 (OM53489U) Owner's Guide

OCCUPANT RESTRAINT SYSTEMS
150
SV16055

Move seat fully back
A forward±facing child restraint system should be
allowed to be installed on the front passenger seat
only when it is unavoidable. Always move the seat as
far back as possible, because the front passenger
airbag could inflate with considerable speed and
force. Otherwise, the child may be killed or seriously
injured.
 Do not allow the child to lean his/her head or any part
of his/her body against the door or the area of the
seat, front or side pillar or roof side rail from which
the side airbags or curtain shield airbags deploy even
if the child is seated in the child restraint system. It is
dangerous if the side airbag and curtain shield airbag
inflate, and the impact could cause death or serious
injury to the child.
SV16075
If the driver's seat position does not allow sufficient
space for safe installation, install the child restraint
system on the rear right seat.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
151
SV16039
1. Run the lap and shoulder belt through or around the
convertible seat following the instructions provided by its
manufacturer and insert the tab into the buckle taking care not
to twist the belt. Keep the lap portion of the belt tight.
CAUTION
 After inserting the tab, make sure the tab and buckle
are locked and that the lap and shoulder portions of
the belt are not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent your child from properly latching the tab
and buckle.
 If the seat belt does not function normally, it cannot
protect your child from death or serious injury.
Contact your Lexus dealer immediately. Do not install
the child restraint system on the seat until the seat
belt is fixed.
SV16040
2. Fully extend the shoulder belt to put it in the lock mode.
When the belt is then retracted even slightly, it cannot be
extended.
To hold the convertible seat securely, make sure the belt is in
the lock mode before letting the belt retract.
SV16041
3. While pressing the convertible seat firmly against the seat
cushion and seatback, let the shoulder belt retract as far as it
will go to hold the convertible seat securely.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
152
SV16042
CAUTION
Push and pull the child restraint system in different
directions to be sure it is secure. Follow all the
installation instructions provided by its manufacturer.
SV16058
4. To remove the convertible seat, press the buckle±release
button and allow the belt to retract completely. The belt will
move freely again and be ready to work for an adult or older
child passenger.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
153
(C) Booster seat installation
SV16031
A booster seat must be used in forward±facing position
only.
SV16044

Move seat fully back
CAUTION

A forward±facing child restraint system should be
allowed to be installed on the front seat only when it
is unavoidable. Always move the seat as far back as
possible, because the front passenger airbag could
inflate with considerable speed and force. Otherwise,
the child may be killed or seriously injured.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
154
Do not allow the child to lean his/her head or any part
of his/her body against the door or the area of the
seat, front or side pillar or roof side rail from which
the side airbags or curtain shield airbags deploy even
if the child is seated in a child restraint system. It is
dangerous if the side airbag and curtain shield airbag
inflate, and the impact could cause death or serious
injury to the child.
SV16045
1. Sit the child on a booster seat. Run the lap and shoulder belt
through or around the booster seat and child following the
instructions provided by its manufacturer and insert the tab into
the buckle, taking care not to twist the belt.
Make sure the shoulder belt is correctly across the child's
shoulder and that the lap belt is positioned as low as possible
on the child's hips. See ªSeat beltsº on page 110 for details.
CAUTION
 Always make sure the shoulder belt is positioned
across the center of child's shoulder. The belt should
be kept away from child's neck, but not falling off
child's shoulder. Otherwise, the child may be killed or
seriously injured in case of sudden braking or a
collision.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
155
Both high±positioned lap belts and loose±fitting
belts could cause death or serious injuries due to
sliding under the lap belt during a collision or other
unintended event. Keep the lap belt positioned as low
on a child's hips as possible.
 For child's safety, do not place the shoulder belt
under child's arm.
 After inserting the tab, make sure the tab and buckle
are locked and that the lap and shoulder portions of
the belt are not twisted.
 Do not insert coins, clips, etc. in the buckle as this
may prevent your child from properly latching the tab
and buckle.
 If the seat belt does not function normally, it cannot
protect your child from death or serious injury.
Contact your Lexus dealer immediately. Do not install
the child restraint system on the seat until the seat
belt is fixed.
SV16056
2. To remove the child restraint system, press the
buckle±release button and allow the belt to retract.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
156
Using a top strap (Sedan)
SV16047
Follow the next procedure for a child restraint system that
requires the use of a top strap.
SV16072

Anchor brackets
Use the anchor bracket on the filler panel behind the rear seat
to attach the top strap.
Anchor brackets are installed for each rear seating position.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
157
SV16062

Center seat position
1. Lower the head restraint.
2. Fix the child restraint system with the seat belt.
3. Latch the hook onto the anchor bracket and tighten the
top strap.
For instructions to install the child restraint system, see ªT ypes
of child restraint systemº on page 143.
CAUTION
Make sure the top strap is securely latched, and check
that the child restraint system is secure by pushing and
pulling it in different directions. Follow all the
installation instructions provided by its manufacturer.
SV16118

Side seat position
1. Remove the head restraint.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
158
SV16153a
2. Fix the child restraint system with the seat belt.
Latch the hook onto the anchor bracket and tighten the
top strap.
For instructions to install the child restraint system, see ªTypes
of child restraint systemº on page 143.
CAUTION
Make sure the top strap is securely latched, and check
that the child restraint system is secure by pushing and
pulling it in different directions. Follow all the
installation instructions provided by its manufacturer.
SV16119
3. Replace the head restraint.
04 06.30

OCCUPANT RESTRAINT SYSTEMS
159
Installation with child restraint lower
anchorages
SV16100
The lower anchorages for the child restraint system
interfaced with the FMVSS225 specification are installed
in the rear seat.
The anchorages are installed in the gap between the seat
cushion and seatback of both outboard rear seats.
Child restraint system interfaced with the FMVSS213
specification can be fixed with these anchorages. In this case,
it is not necessary to fix the child restraint system with a seat
belt on the vehicle. CHILD RESTRAINT SYSTEM INSTALLATION
SV16187b
Canada only

Type A
04 06.30