Lexus IS300 2005 Basic Functions / LEXUS 2005 IS300 (OM53489U) Owner's Guide
Manufacturer: LEXUS, Model Year: 2005, Model line: IS300, Model: Lexus IS300 2005Pages: 425, PDF Size: 3.42 MB
Page 31 of 425
KEYS AND DOORS
14
SV11012a
SportCross
1Locking the doors
2Unlocking the doors
3Indicator light
4Sounding an alarm
NOTE: *This feature can be set inoperative as vehicle theftdeterrent measure in case of the loss of the wireless remote control key. Ask your Lexus dealer for details.
When you operate any button on the key, push it slowly and
surely. At this time, the indicator light on the key grip flashes
once.
The operational range of the wireless remote control is
approximately 1 meter (3 ft.). The ef fective range may vary with
different conditions. To activate the wireless remote control
without fail, do it approximately 1 meter (3 ft.) from your Lexus. In the following cases, the battery in the key may be
discharged. If this is the case, replace it using a special
screwdriver.
The remote control does not work.
The operational range of wireless remote control becomes
extremely short.
The indicator light on the key is dimmed or does not come
on.
For the replacement of the battery, see ªReplacing the batteryº
on page 18. You can also have the battery of the key replaced
by your Lexus dealer.
If you lose the wireless key, contact your Lexus dealer as soon
as possible to avoid the possibility of theft, or an accident.
You can use up to 4 wireless remote control keys for the same
vehicle. Contact your Lexus dealer for detailed information.
The wireless remote control key is an electronic
component. Observe the following instructions in order
not to cause damage to the key.
Do not leave the wireless remote control key in places
where the temperature becomes high such as on the dashboard.
Do not disassemble it.
Avoid knocking it hard against other objects or dropping it.
Avoid putting it in water.
04 06.30
Page 32 of 425
KEYS AND DOORS
15
Locking/Unlocking the doors
When you push the ªLOCKº button on the key briefly, all
the doors will be locked from outside the vehicle.
At this time, one beep sounds* and the emergency flashers
flash once.** However, when you push the ªLOCKº button with
any door not closed securely, the buzzer sounds for 10
seconds.*** To stop the buzzer, close all the doors securely or
push the ªUNLOCKº button. If the key is in the ignition switch,
locking cannot be done.
Make sure all the doors are locked when you leave the vehicle.
Push the ªLOCKº button once again. If they were already
locked, one beep sounds and the emergency flashers will
flash.
NOTE: *The beep sound can be set not to sound. **The emergency flasher can be set not to flash. ***The buzzercan be set not to sound if a door is not closed securely. Ask your Lexus dealer for details.
NOTICE
Sedan only: Do not push the ªLOCKº button any longerthan 2 to 3 seconds. Pushing the button longer activates
an alarm. For details, see page 16.
When you push the ªUNLOCKº button, the driver's door
is unlocked. Pushing that button once again within 3
seconds from the first push, all other doors are also
unlocked.*
NOTE: *The 2±step unlocking function can be changed. Ask your Lexus dealer for details.
At this time, two beeps sound* and the emergency flashers
flash twice.** Together with the activation of unlocking, the
interior light comes on for 15 seconds if the interior light switch
is in ªDOORº position.*** However, this function does not work
when the ignition key is in the ªONº position. For further
information, see ªInterior lightº on page 60.
You have 30 seconds to open a door after using the wireless
remote unlock feature.**** If a door is not opened by then, all
the doors will be automatically locked again.
Even if the ªLOCKº or ªUNLOCKº switch is kept pressed in, the
locking or unlocking operation is not repeated. Release the
button and then push again.
NOTE: *The beep sound can be set not to sound. **The emergency flashers can be set not to flash. ***The interiorlight can be set not to come on or the duration of lighting can
be changed. ****The time before automatic re±locking can be changed. Ask your Lexus dealer for details.
04 06.30
Page 33 of 425
KEYS AND DOORS
16
Unlocking the trunk lid
SV11009b
When you keep the button pushed for about 1 second, you
can unlock the trunk lid.* One beep sounds.
This function does not work when the key is in the ignition
switch.
NOTE: *The operation method can be changed. Ask your Lexus dealer for details.
Sounding an alarm*
SV11010a
Sedan
When you push the ªPANICº button for about 2 to 3
seconds, an alarm sounds to deter any person trying to
break into or damage your vehicle.
If you want to stop the alarm, push any button.
This function does not work when the ignition key is in the ªONº
position.
NOTE: *The alarm can be set not to sound. Ask your Lexus
dealer for details.
04 06.30
Page 34 of 425
KEYS AND DOORS
17
SV11013b
SportCross
When you push the ªPANICº button for about 1 second, an
alarm sounds to deter any person trying to break into or
damage your vehicle.
If you want to stop the alarm, push any button.
This function does not work when the ignition key is in the ªONº
position.
NOTE: *The alarm can be set not to sound. Ask your Lexus dealer for details.
For vehicles sold in U.S.A.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
NOTICE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
04 06.30
Page 35 of 425
KEYS AND DOORS
18
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio / TV
technician for help.
FCC WARNING:
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
For vehicles sold in Canada
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation of
the device.
Replacing the battery
When you replace the battery, prepare a lithium battery
CR1616 or equivalent and a special screwdriver.
CAUTION
Special care should be taken to prevent small children
from swallowing the removed battery or components.
NOTICE
When replacing the battery, be careful not to lose the components, screws and O±ring.
Replace only with the same or equivalent typerecommended by a Lexus dealer.
Dispose of used battery according to the local laws.
04 06.30
Page 36 of 425
KEYS AND DOORS
19
11L028±1
1. Remove the screw, and then the cover while pushing it in
the arrow direction.
11L029±1
2. Remove the module from the key frame.
11L030±1
3. Remove the 2 screws to take out the lid of the module.
4. Take out the discharged battery and put a new battery with
the positive side up.
04 06.30
Page 37 of 425
KEYS AND DOORS
20
NOTICE
Make sure the positive side and negative side of thebattery are faced correctly.
Do not replace the battery with wet hands. Water maycause unexpected rust.
Do not touch or move any components inside thetransmitter, or it may interfere with proper operation.
Be careful not to bend the electrode when insertingthe battery and that dust or oils do not adhere to theinside of the module.
Take care not to lose the screws and O±ring.
5. Install the lid with the 2 screws.
NOTICE
Take care not to damage or bend the O±ring wheninstalling.
6. Install the module into the key frame and secure the cover
with the screw.
7. When pushing any switch on the wireless key, make sure
the indicator light comes on.
DOORS
Locking with key
SS11007a
1Lock 2Unlock
Turn the key towards the front of the vehicle to lock and
towards the back to unlock.
Locking (or unlocking) the driver's door will lock (or unlock) all
the other doors simultaneously. In the driver's door lock,
turning the key once will unlock the driver's door and twice in
succession will unlock all doors simultaneously.*
Together with the activation of unlocking, the interior light will
turn on for 15 seconds if the interior light switch is in the
ªDOORº position.** However, this function does not work when
the ignition key is in the ªONº position. For further information,
see ªInterior lightº on page 60.
04 06.30
Page 38 of 425
KEYS AND DOORS
21
NOTE: *The 2±step unlocking function can be changed.**The interior light can be set not to come on or the durationof lighting can be changed. Ask your Lexus dealer for details.
Locking with inside lock button
SV11004
1Lock 2Unlock
Push in the lock button to lock and unlock the door.
The front doors can be opened by pulling the inside handles
even if the lock buttons are in the locked position.
CAUTION
Do not pull the inside handle of the front doors while
driving. The doors will open and an accident may occur.
Lexus strongly recommends that all children be placed
in the rear seat of the vehicle.
Closing the door with the lock button pushed in will also lock
the door. Be careful not to lock your keys in the vehicle. The
door will not lock if the key is left in the ignition switch when
closing the front doors.
CAUTION
Before driving, make sure the doors are closed and
locked, especially when small children are in the
vehicle. Along with the proper use of seat belts, locking
the doors helps prevent the driver and passengers from
being thrown out from the vehicle during an accident. It
also helps prevent the doors from being opened
unintentionally.
04 06.30
Page 39 of 425
KEYS AND DOORS
22
Locking with power door lock switch
SV11006a
1Lock 2Unlock
To lock all the doors simultaneously, push the power door
lock switch down on the front side. Pushing down on the
rear side will unlock them.
The same switch is also located on the front passenger's side.
Setting the auto door locking and unlocking
functions
You can set the following auto door locking and unlocking
functions.
(a) Locking linked with the shift position (Automatic
transmission only)
All the doors are locked automatically when the selector lever
is moved out of the ªPº position with the engine running.(b) Unlocking linked with the shift position (Automatic
transmission only)
All the doors are unlocked automatically when the selector
lever is moved to the ªPº position with the ignition switch in the
ªONº position.*
NOTE:
*This function is the default setting for new vehicles.
(c) Locking linked with the vehicle speed
All the doors are locked automatically when the vehicle speed
reaches 20 km/h (12 mph) or higher. However, if any door is
unlocked during driving, this auto locking function will not
operate until the unlocked door is opened once.*
NOTE:*This function is the default setting for new vehicles.
(d) Unlocking linked with opening the driver's door
All the doors are unlocked automatically when the driver's door
is opened within 10 seconds after the ignition switch is turned
from ªONº to the ªACCº or ªLOCKº position.*
NOTE:*This function is the default setting for new vehicles.
Setting the functions
1. Close all the doors.
2. Turn the ignition switch to the ªONº position.
3. Within 10 seconds after the ignition switch is turned to the
ªONº position;
04 06.30
Page 40 of 425
KEYS AND DOORS
23
To set function (a)
Push and hold the front of the power door lock switch for 5 seconds with the selector lever in the ªPº position.
To set function (b)
Push and hold the rear of the power door lock switch for 5 seconds with the selector lever in the ªPº position.
To set function (c)
Push and hold the front of the power door lock switch for 5 seconds with the selector lever in any position except ªPº.
To set function (d)
Push and hold the rear of the power door lock switch for 5 seconds with the selector lever in any position except ªPº.
All the doors automatically lock and unlock when you release
the power door lock switch. This indicates that the function is
set. If all the doors do not lock and unlock, the time the switch
was held may have been too short or too long. Perform the
procedure over again starting from step 1.
If you want to cancel a function, repeat the procedure. Each
time you perform the procedure, the function is set or
cancelled.
Locking with rear door child±protector
SV11005
1Lock 2Unlock
Whenever small children are in the vehicle, lock the rear
door so that it does not open by the inside door handle. To
do this, turn the knob to the ªLOCKº position as shown
and then close the door.
04 06.30