power Lexus IS300h 2013 Owner's Manual

5268-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
Con-
tinu-
ousThe driver’s door was opened
when the shift lever was not in P
and the power switch was not
turned off.
Shift the shift lever to P.
Con-
tinu-
ousCon-
tinu-
ous
The driver’s door was opened
and closed while the electronic
key was not in the vehicle, the
shift lever was not in P and the
power switch was not turned off.
Shift the shift lever to P.
Bring the electronic key back
into the vehicle.
Once
The electronic key is not
detected when an attempt is
made to start the hybrid system.
Start the hybrid system with
the electronic key present.
OnceCon-
tinu-
ous
An attempt was made to exit the
vehicle with the electronic key
and lock the doors without first
turning the power switch off
when the shift lever was in P.
Turn the power switch off and
lock the doors again.
(Flashes)
(Displayed alternately)
(Flashes)
(Flashes)
(Displayed alternately)
(Flashes)

5278-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)
Once3
times
The electronic key was carried
outside the vehicle and a door
other than the driver’s door was
opened and closed while the
power switch was in a mode
other than off.
Bring the electronic key back
into the vehicle.
The driver’s door was opened
and closed while the electronic
key was not in the vehicle, the
shift lever was in P and the
power switch was not turned off.
Turn the power switch off.
Bring the electronic key back
into the vehicle.
9
times
An attempt was made to drive
when the electronic key was not
inside the vehicle.
Confirm that the electronic
key is inside the vehicle.

Con-
tinu-
ous
An attempt was made to lock the
doors using the smart entry &
start system while the electronic
key was still inside the vehicle.
Retrieve the electronic key
from the vehicle and lock the
doors again.
Once
Con-
tinu-
ous
An attempt was made to lock
either front door by opening a
door and putting the inside lock
button into the lock position,
then closing the door by pulling
on the outside door handle with
the electronic key still inside the
vehicle.
Retrieve the electronic key
from the vehicle and lock the
doors again.
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
(Flashes)
(Vehicles with the entry function)
(Flashes)

5288-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
Once
The electronic key has a low bat-
tery.
Replace the electronic key
battery. (P. 472)
Once
The steering lock could not be
released within 3 seconds of the
power switch being pressed.
Press the power switch while
depressing the brake pedal
and moving the steering wheel
left and right.
Once
Indicates a malfunction in the
smart entry & start system
Have the vehicle inspected by
any authorized Lexus dealer
or repairer, or another duly
qualified and equipped profes-
sional.
Once
• When the doors were unlocked
with the mechanical key and
then the power switch was
pressed, the electronic key
could not be detected in the
vehicle.
• The electronic key could not
be detected in the vehicle even
after the power switch was
pressed two consecutive times.
Touch the electronic key to
the power switch while
depressing the brake pedal.
Once
During a hybrid system starting
procedure in the event that the
electronic key was not function-
ing properly (P. 550), the
power switch was touched with
the electronic key.
Press the power switch within
10 seconds of the buzzer
sounding.
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
(Flashes)

5298-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)

Indicates that:
• With the power switch off, the
doors were unlocked and then
the driver’s door was opened
and closed;
• The power switch was turned
to ACCESSORY mode with-
out starting the hybrid system;
or
• The shift lever was shifted to P
from another position with the
power switch in ON mode.
Press the power switch while
depressing the brake pedal.
Once
The power switch has been
turned off with the shift lever in a
position other than P.
Shift the shift lever to P.
Once
After the power switch has been
turned off with the shift lever in a
position other than P, the shift
lever has been shifted to P.
Turn the power switch off.

Power was turned off due to the
automatic power off function.
Next time when starting the
hybrid system, increase the
engine speed slightly and
maintain that level for approx-
imately 5 minutes to recharge
the 12-volt battery.
Con-
tinu-
ous

Indicates that the hybrid system
was stopped in an emergency
while driving
To restart the hybrid system,
shift the shift lever to N and
turn the power switch to ON
mode.
*
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
(Flashes)
(Flashes)
(Flashes)

5308-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
*: The hybrid system may not be restarted depending on the vehicle condition.
Warning messages
P. 525
Warning buzzer
P. 512
Once
Indicates that the power switch
has been pressed while driving
Except when emergency stop-
ping of the vehicle is needed,
immediately release the power
switch.
Interior
buzzerExterior
buzzerWarning messageDetails/Actions
(Flashes)

5328-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
Emergency tire puncture repair kit components
Hose
Air release cap
Air pressure gaugeCompressor switch
Power plug
Stickers1
2
3
4
5
6

5358-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)
Make sure that the compressor
switch is off.
Remove the power plug from the
compressor.
Connect the power plug to the power outlet socket. (P. 421)5
6
7

5398-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)
With the compressor switch off, disconnect the hose from the valve on
the tire and then pull out the power plug from the power outlet socket.
Some sealant may leak when the hose is removed.
Install the valve cap onto the valve of the emergency repaired tire.
Attach the air release cap to the
end of the hose.
If the air release cap is not attached,
the sealant may leak and the vehicle
may get dirty.
Temporarily store the bottle in the luggage compartment while it is
connected to the compressor.
To spread the liquid sealant evenly within the tire, immediately drive
safely for about 5 km (3 miles) below 80 km/h (50 mph).
After driving for about 5 km (3
miles), stop your vehicle in a safe
place on a hard, flat surface and
remove the air release cap from
the hose before reconnecting the
repair kit.
15
16
17
18
19
20

5448-2. Steps to take in an emergency
IS300h_EE(OM53B95E)
NOTICE
When performing an emergency repair
Perform the emergency repair without removing the nail or screw that has
punctured the tread of the tire. If the object that has punctured the tire is
removed, repair by the emergency tire puncture repair kit may not be possible.
The kit is not waterproof. Make sure that the kit is not exposed to water, such
as when it is being used in the rain.
Do not put the kit directly onto dusty ground such as sand at the side of the
road. If the kit vacuums up dust etc., a malfunction may occur.
Use the kit with the top facing upward. The kit cannot work properly if it is
laid on its side.
Handling the emergency tire puncture repair kit
The compressor power source should be 12 V DC suitable for vehicle use. Do
not connect the compressor to any other source.
If gasoline splatters on the kit, the kit may deteriorate. Take care not to allow
gasoline to contact it.
Store the kit in its assigned place out of reach of children.
Do not disassemble or modify the kit. Do not subject parts such as the air
pressure indicator to impacts. This may cause a malfunction.
To avoid damage to the tire pressure warning valves and transmitters
When a tire is repaired with liquid sealants, the tire pressure warning valve and
transmitter may not operate properly. If a liquid sealant is used, contact any
authorized Lexus dealer or repairer, or another duly qualified and equipped
professional as soon as possible. Make sure to replace the tire pressure warning
valve and transmitter when replacing the tire. (P. 451)

5478-2. Steps to take in an emergency
8
When trouble arises
IS300h_EE(OM53B95E)
One of the following may be the cause of the problem:
One or both of the 12-volt battery terminals may be disconnected.
The 12-volt battery may be discharged. (P. 551)
Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional if the problem cannot be repaired, or if repair proce-
dures are unknown.
When the hybrid system does not start, the following steps can be used as
an interim measure to start the hybrid system if the power switch is func-
tioning normally:
Set the parking brake.
Shift the shift lever to P.
Turn the power switch to ACCESSORY mode.
Press and hold the power switch for about 15 seconds while depressing
the brake pedal firmly.
Even if the hybrid system can be started using the above steps, the system
may be malfunctioning. Have the vehicle inspected by any authorized
Lexus dealer or repairer, or another duly qualified and equipped profes-
sional.
The interior lights and headlights do not turn on, or the horn does
not sound.
Emergency start function
1
2
3
4