10W-30
5W-30 Preferred
Temperature range anticipated before next oil change
ENGINE
193 Oil capacity
Drain and refill
with filter
without filter
Oil grade
Recommended oil viscosity (SAE):
5.1 L (5.4 qt., 4.5 Imp.qt.)
4.8 L (5.1 qt., 4.2 Imp.qt.)
API grade SG or SH, Energy-Conserving II multigrade engine
oil or ILSAC multigrade engine oil
− COOLING SYSTEM
Capacity
Coolant type
10.8 L (11.4 qt., 9.5 Imp.qt.)
Ethylene-glycol coolant (Do not use alcohol type.)
− FUEL
Fuel type
Research octane umber
Only UNLEADED
96 (Octane Rating 91) or higher
− IGNITION SYSTEM
ENGINE
198
CHECKING THE ENGINE OIL
LEVEL
Low line
Add oilO.K.
Too full
Full line
With the engine at operating temperature and turned off,
check the oil level on the dipstick.
1. To get a true reading, the vehicle should be on a level spot.
After turning off the engine, wait a few minutes for the oil to
drain back into the bottom of the engine.
2. Pull out the dipstick, and wipe it clean with a rag.
3. Reinsert the dipstick and push it in as far as it will go, or the
reading will not be correct.
4. Pull the dipstick out and look at the oil level on the end. If it
is between the full line and the low line, it is O.K.
If the oil level is below or only slightly above the low line,
add engine oil of the same type as already in the engine.
Remove the oil filler cap and add engine oil in small quantities
at a time, checking the dipstick. The approximate quantity of
oil needed to fill between the low line and the full line on the
dipstick is indicated below.
When the level reaches within the correct range, return the
filler cap and turn the cap clockwise until you hear a click.
Oil quantity. L (qt., Imp. qt.) 1.5 (1.6., 1.3)
NOTICE:
Avoid overfilling, or the engine could be damaged.
Check the oil level on the dipstick once again after
adding the oil.
