ECU lexus LS400 1996 Audio System / 1996 LS400: IN CASE OF AN EMERGENCY

IN CASE OF AN EMERGENCY
165
Never get beneath the vehicle when supported by
a jack.
Do not start or run the engine while your vehicle is
supported by a jack.

Tool boxJackSpare tireJack handle
1. Get the tool, jack and spare tire.
To prepare yourself for an emergency, you should familiarize
yourself with the use of the jack and each tool, and their
storage locations.

Joint
When removing the jack, turn the joint by hand in the
ªcontractº direction until the jack is free.
When storing, turn the joint by hand in the ªexpandº
direction until the jack is firmly secured to prevent it
from flying forward during a collision or sudden
braking.

IN CASE OF AN EMERGENCY
169 Align the holes in the wheel with the bolts. Then lift up the
wheel and get at least the top bolt started through its hole.
Wiggle the tire and press it back over the other bolts.
Reinstall the wheel nuts and tighten them as much as you
can by hand. Press the tire back and see if you can tighten
them more.
9. Lower the vehicle completely and tighten the wheel
nuts.
Turn the jack handle counterclockwise to lower the vehicle.
Use only the wheel nut wrench to tighten the nuts. Do not use
other tools or any additional leverage other than your hands,
such as a hammer, pipe or your foot. Make sure the wrench
is securely engaged over the nut.
Tighten each nut a little at a time in the order shown. Repeat
the process until all the nuts are tight.
CAUTION!
As soon as possible after changing wheels, have the
wheel nuts tightened by torque wrench at 103 N´m
(10.5 kgf´m, 76 ft´lbf.).
10. Reinstall the wheel ornament.
Put the wheel ornament into position and then tap it firmly
with the side or heel of your hand to snap it into place.
CAUTION!
Take due care in handling the ornament to avoid
unexpected personal injury.
11. After changing the wheel, check the air pressure of
the replaced tire. Stow all the tools, jack and flat tire
securely.

IN CASE OF AN EMERGENCY
170If the pressure of the replaced tire is low, drive slowly to the
nearest service station and fill to the correct pressure.
Do not forget to reinstall the tire valve cap as dirt and
moisture could get into the valve core and possible cause air
leakage. If the cap is missing, put a new one on as soon as
possible.
This is the same procedure for changing or rotating your
tires.
CAUTION!
Before driving, make sure all the tools, jack and flat
tire are securely in place in their storage location to
reduce the possibility of personal injury during a
collision or sudden braking.
IF YOUR VEHICLE NEEDS TO BE
TOWED
If towing is necessary, we recommend you to have it
done by your Lexus dealer or a commercial tow truck
service.
Proper equipment will help ensure that your vehicle is not
damaged while being towed. Commercial operators are
generally aware of the state/provincial and local laws
pertaining to towing.
Your vehicle can be damaged if it is towed incorrectly.
Although most operators know the correct procedure, it is
possible to make a mistake. To avoid damage to your
vehicle, make sure the following few precautions are
observed. If necessary, show this page to the tow truck
driver.
TOWING PRECAUTIONS:
Use a safety chain system for all towing, and abide by the
state/provincial and local laws. The wheels and axle on the
ground must be in good condition. If they are damaged, use
a towing dolly.

IN CASE OF AN EMERGENCY
1743. Towing with a sling type truck
From front
Follow the instructions for towing from front in ª2. Towing with
wheel lift type truckº.
From rear
NOTICE
Do not tow with a sling type truck. This may cause
body damage.
Emergency towing
If towing service is not available in an emergency, your
vehicle may be temporarily towed by a cable secured to
one of the eyelets under the front or rear of the vehicle.
A driver must be in the vehicle to steer it and operate the
brakes. Towing in this manner may be done only on
hard±surfaced roads for a short distance and at low speeds.
Also, the wheels, axles, drive train, steering and brakes must
all be in good condition.
Before towing, release the parking brake and put the
transmission in ªNº. The ignition key must be in ªACCº
(engine off) or ªONº (engine running).
CAUTION!
If the engine is not running, the power assist for the
brakes and steering will not work so steering and
braking will be much harder than usual.