clock lexus LS400 1996 Engine / 1996 LS400: IN CASE OF AN EMERGENCY

IN CASE OF AN EMERGENCY
167 Pry off the wheel ornament, using the screwdriver as shown.
CAUTION!
Do not try to pull off the ornament by hand. Take due
care in handling the ornament to avoid unexpected
personal injury.
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before raising the vehicle.
Turn the nuts counterclockwise to loosen them. To get
maximum leverage, fit the wrench to the nut so that the
handle is on the right side, as shown above. Grab the wrench
near the end of the handle and pull up on the handle. Be
careful that the wrench does not slip off the nut.
Do not remove the nuts yet ± just unscrew them about
one±half turn.
5. Position the jack at the jack points as shown.
Make sure the jack is positioned on a level and solid surface.
6. After making sure no one is in the vehicle, raise it
high enough so that the spare tire can be installed.
Allow for the fact that you need more ground clearance when
putting on the spare tire than when removing the flat tire.

IN CASE OF AN EMERGENCY
168To raise the vehicle, insert the jack handle into the jack (it is
a loose fit) and turn it clockwise. As the jack touches the
vehicle and begins to lift, double±check that it is properly
positioned.
CAUTION!
Never get under the vehicle when it is supported by
the jack alone.
7. Remove the wheel nuts and remove the flat tire.
Lift the flat tire straight off and put it aside.
Before putting on the wheel, remove any corrosion on the
mounting surfaces with a wire brush or such. Installation of
wheels without good metal±to±metal contact at the
mounting surface can cause wheel nuts to loosen and
eventually cause a wheel to come off while driving.
8. Reinstall all the wheel nuts finger tight.

IN CASE OF AN EMERGENCY
169 Align the holes in the wheel with the bolts. Then lift up the
wheel and get at least the top bolt started through its hole.
Wiggle the tire and press it back over the other bolts.
Reinstall the wheel nuts and tighten them as much as you
can by hand. Press the tire back and see if you can tighten
them more.
9. Lower the vehicle completely and tighten the wheel
nuts.
Turn the jack handle counterclockwise to lower the vehicle.
Use only the wheel nut wrench to tighten the nuts. Do not use
other tools or any additional leverage other than your hands,
such as a hammer, pipe or your foot. Make sure the wrench
is securely engaged over the nut.
Tighten each nut a little at a time in the order shown. Repeat
the process until all the nuts are tight.
CAUTION!
As soon as possible after changing wheels, have the
wheel nuts tightened by torque wrench at 103 N´m
(10.5 kgf´m, 76 ft´lbf.).
10. Reinstall the wheel ornament.
Put the wheel ornament into position and then tap it firmly
with the side or heel of your hand to snap it into place.
CAUTION!
Take due care in handling the ornament to avoid
unexpected personal injury.
11. After changing the wheel, check the air pressure of
the replaced tire. Stow all the tools, jack and flat tire
securely.