warning lexus LS400 1998 Audio System / LEXUS 1998 LS400 (OM50498U) User Guide
[x] Cancel search | Manufacturer: LEXUS, Model Year: 1998, Model line: LS400, Model: Lexus LS400 1998Pages: 304, PDF Size: 5.94 MB
Page 54 of 304

GAUGES, METERS AND SERVICE REMINDER INDICATORS
39
(e) Discharge Warning Light
This light warns that the battery is being discharged.
If it comes on while you are driving, stop the vehicle, turn off the
engine, and check for the cause. Look first at the engine drive belt.
If it is loose or broken, the generator will not charge the battery
properly.
If the belt is O.K., there is a problem somewhere in the charging
system.
The engine ignition will continue to operate, however, until the
battery is discharged. Turn off the air conditioning, blower, radio,
etc., and drive directly to the nearest Lexus dealer or repair shop.
NOTICE
Do not continue driving if the engine drive belt is broken or
loose.
(f) Malfunction Indicator Lamp
This lamp comes on in the following cases.
a. The fuel tank is completely empty. (See ”Fuel gauge” on page 34
for instructions.)
b. The fuel tank cap is not tightened securely. (See ”Fuel tank cap”
on page 65 for instructions.)
c. There is a problem somewhere in your engine electrical system
or electronic throttle control system.
If it comes on while you are driving in case c., have your vehicle
checked/repaired by your Lexus dealer as soon as possible.
(g) ”ABS” Warning Light
This light warns that there is a problem somewhere in your anti lock
brake system.
If the light comes on while you are driving, have your vehicle
checked by your Lexus dealer as soon as possible.
The light will come on when the ignition key is turned to ”ON”, and
will go off after about a few seconds.
When the ”ABS” warning light is on (and the brake system warning
light is off), the brake system operates conventionally but anti lock
brake system is not assisting brake performance so that the wheels
could lock up during a sudden brake or braking on slippery road
surfaces.
(h) Open Door Warning Light
This light remains on until all the doors are completely closed.
Page 55 of 304

GAUGES, METERS AND SERVICE REMINDER INDICATORS
40
(i) Low Fuel Level Warning Light
This light comes on when the fuel level in the tank becomes nearly
empty. Fill the tank as soon as possible.
On inclines or curves, due to the movement of fuel in the tank, the
low fuel level warning light may come on earlier than usual.
(j) Key Reminder Buzzer
This buzzer reminds you to remove the key when you open the
driver’s door with the ignition key in the ”ACC” or ”LOCK”
position.
How to check all the service reminder indicators
(except the low fuel level warning light):
1. Apply the parking brake.
2. Open the door.
The following service reminder indicator should come on. It goes
off when you close the door completely.
3. Turn the ignition key to ”ACC”.
The following service reminder indicator should come on. It goes
off after 6 seconds.
4. Turn the ignition key to ”ON”.
The following service reminder indicators should come on.
or
The following service reminder indicators go off after 3 seconds.
Page 56 of 304

GAUGES, METERS AND SERVICE REMINDER INDICATORS
41
or
5. Turn the ignition key to ”START”.
The following service reminder indicator should come on.
or
If any service reminder indicator or warning buzzer does not
function, either the bulb is burned out or circuit is in need of repair.
Have it checked by your Lexus dealer as soon as possible.
MULTI INFORMATION DISPLAY
13L042 1
The multi information display provides cruise information on
your vehicle’s driving condition and warning messages if your
vehicle has trouble. During ordinary driving, cruise
information is shown in the display. However, if any problem
occurs in your vehicle, a warning message appears in place of
cruise information. To change to the cruise information display,
push the ”FUNCTION” button.
Page 59 of 304

GAUGES, METERS AND SERVICE REMINDER INDICATORS
44
(b) Warning messages
13L052
Reminder light
W40
W40
When the engine oil pressure becomes too low, the above
message appears, the reminder light flashes and the warning
tone sounds.
If this message appears while you are driving, pull off the road to a
safe place and stop the engine immediately. Call a Lexus dealer or
qualified repair shop for assistance.
The message may appear when the oil level is extremely low. It is
not designed to indicate low oil level, and the oil level must be
checked using the oil level dipstick.
NOTICE
Do not drive the vehicle with the warning message displayed
even for one block. It may ruin the engine.
W41 W41
When your brake pads are worn enough to require replacement,
the above message appears, the reminder light flashes and the
warning tone sounds.
If this message appears while you are driving, have the brake pads
checked and replaced by your Lexus dealer as soon as possible.
W43 W43
W42
W42
W45 1
W44
W44
W46
W46
When any door or trunk is open with the ignition switch turned
on, the message which door or trunk is open appears, and the
reminder light comes on.
Page 60 of 304

GAUGES, METERS AND SERVICE REMINDER INDICATORS
45 If you continue driving with any door or trunk open, the reminder
light starts flashing and the warning tone sounds to remind you to
close the door or trunk.
W52 W52
If the driver’s door is opened with the ignition switch turned off
and the moon roof opened, the above message appears and the
reminder light flashes.
W48 W48
In the following cases, the warning message appears and the
reminder light next to the warning message and the ”VSC OFF”
indicator light come on. And the warning tone also sounds.
(a) After the removal of the battery terminals (See ”Initial
adjustment of vehicle skid control system” on page 175.)
(b) If the vehicle skid control system malfunctions
If the above message appears for the cause of (b), have your vehicle
checked by your Lexus dealer as soon as possible.
Although the above message appears, you can continue your normal
driving, but without the vehicle skid control system function.
W49 W49
In the following cases, the above message appears, the reminder
light comes on and the warning tone sounds.
When the headlight switch is turned to the first or second
clickstop with one or more of tail light bulbs burned out.
When the brake pedal is held down with one or more of stop light
bulbs burned out.
Have defective bulbs replaced as soon as possible.
W50 W50
When the engine oil level is too low, the above message appears,
the reminder light comes on and the warning tone sounds.
Add oil as soon as possible. (For instructions, see ”Checking the
engine oil level” on page 230.)
NOTICE
Continued engine operation with low engine oil will damage the
engine.
Page 61 of 304

GAUGES, METERS AND SERVICE REMINDER INDICATORS
46
W51 W51
When the fluid level in the tank becomes nearly empty, the above
message appears, the reminder light comes on and the warning
tone sounds.
Fill the tank as soon as possible.
W53 W53
When there is a problem somewhere in the automatic headlight
leveling system, the above message appears, the reminder light
comes on and the warning tone sounds.
If this message appears, have your vehicle checked by your Lexus
dealer.
INSTRUMENT PANEL LIGHT
CONTROL
13L005
To adjust the brightness of the instrument panel lights, turn the
knob.
Page 70 of 304

INTERIOR EQUIPMENT
55 3. When the frequency and code is registered, the indicator light
flashes rapidly. Then you can release both buttons.
4. If you wish, repeat the procedure for each remaining button for
another garage door opener.
If you want to write a new program over the program set already,
select a button you want to program and repeat the procedure from
step 1. The previous program is erased and a new program will be
set.
If the transmitter has a ”rolling code” feature, it is necessary to
program the garage door opener receiver on the garage, after
programming the garage door opener on the vehicle,. For the
setting of the receiver, refer to the instruction manual for the
receiver.
After setting the receiver, push the programmed button on the
vehicle for about 1 to 2 seconds within the operational range.
The old type garage door openers manufactured before 1982 cannot
be programmed in this system.
CAUTION
When programming or operating the garage door opener,
make sure there is no one around the moving door. It is
dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door opener. The
indicator light comes on. The garage door opener continues to send
the signal for up to 20 seconds as long as the button is pushed.
(c) Erasing the garage door opener memory
Push and hold down the 2 outside buttons until the indicator light
flashes. All memorized data will be erased.
FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Rules part 15.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference that may be received,
including interference that may cause undesired operation.
WARNING: This transmitter has been tested and
complies with FCC and DOC/MDC rules. Changes or
modifications not expressly approved by the partly
responsible for compliance could void the user’s
authority to operate the device.