ground clearance lexus LS400 1998 Audio System / LEXUS 1998 LS400 OWNER'S MANUAL (OM50498U)

IN CASE OF AN EMERGENCY
202
40L0102
6. After making sure no one is in the vehicle, raise it high enough
so that the spare tire can be installed.
Allow for the fact that you need more ground clearance when putting
on the spare tire than when removing the flat tire.
To raise the vehicle, insert the jack handle into the jack (it is a loose
fit) and turn it clockwise. As the jack touches the vehicle and begins
to lift, doublecheck that it is properly positioned.
CAUTION
Never get under the vehicle when the vehicle is supported by
the jack alone.
40L0111
7. Remove the wheel nuts and remove the flat tire.
Lift the flat tire straight off and put it aside.
40L0121
Before putting on the wheel, remove any corrosion on the mounting
surfaces with a wire brush or such. Installation of wheels without
good metaltometal contact at the mounting surface can cause
wheel nuts to loosen and eventually cause a wheel to come off while
driving.

IN CASE OF AN EMERGENCY
206From rear
40L0221
Place the ignition key in the ”ACC” position.
NOTICE
Do not tow with the key removed or in the ”LOCK” position,
as the steering lock mechanism is not strong enough to hold
the front wheels straight.
When lifting wheels, take care to ensure adequate ground
clearance for towing at the opposite end of the raised vehicle.
Otherwise, the bumper and/or underbody of the towed vehicle
will be damaged during towing.
(b) Using a flat bed truck
40L016
Tie down points
40L017-2

CHASSIS
245
Tire selection
When replacing a tire, use only the same size and construction
as originally installed and with the same or greater load capacity.
Using any other size or type of tire may seriously affect handling,
ride, speedometer/odometer calibration, ground clearance, and
clearance between the body and tires or snow chains.
Do not mix radial, belted, or conventional tires on your vehicle.
Do not use tires or wheels other than the manufacturer’s
recommended size.
It can cause dangerous handling characteristics, resulting in loss of
control. If you need to change from conventional tires to radial tires
or vice versa, replace them as a set.
INSTALLING SNOW TIRES AND
CHAINS
When to use snow tires or chains
Snow tires or chains are recommended when driving on snow or
ice.
On wet or dry roads, conventional or radial tires provide better
traction than snow or studded tires.
Snow tire selection
If you need snow tires, select the same size, construction and load
capacity as the original tires on your Lexus.
Do not use tires other than stated above. Since your vehicle has
radial tires as original equipment, make sure your snow tires also
have radial construction. Do not install studded tires without first
checking local regulations for possible restrictions.
Snow tire installation
Snow tires should be installed on all wheels.
Installing snow tires on the rear wheels only can lead to an excessive
difference in road grip capability between the front and rear tires
which could cause loss of vehicle control.

CHASSIS
247
REPLACING WHEELS
When to replace your wheels
If you have wheel damage such as bending, cracks or heavy
corrosion, the wheel should be replaced.
If you fail to replace damaged wheels, a tire may slip off a wheel or
they may cause loss of handling control.
Replacement with used wheels is not recommended as they may
have been subjected to rough treatment or high mileage and could
fail without warning. Also, bent wheels which have been
straightened may have hidden structural damage and therefore
should not be used. Never use an inner tube in a leaking wheel which
is designed for a tubeless tire.
Wheel selection
When replacing wheels, care should be taken to ensure that they
are equivalent to those removed in load capacity, diameter, rim
width, and offset.
Correct replacement wheels are available at your Lexus dealer.
A wheel of a different size or type may adversely affect handling,
wheel and bearing life, brake cooling, speedometer/odometer
calibration, stopping ability, headlight aim, bumper height, vehicle
ground clearance, and tire or snow chain clearance to the body and
chassis.
ALUMINUM WHEEL
PRECAUTIONS
After driving your vehicle the first 1600 km (1000 miles), check
that the wheel nuts are tight.
If you have rotated, repaired, or changed your tires, check that the
wheel nuts are still tight after driving 1600 km (1000 miles).
When using tire chains, be careful not to damage the aluminum
wheels.
Use only the Lexus wheel nuts and wrench designed for your
aluminum wheels.
When balancing your wheels, use only Lexus balance weights or
equivalent and a plastic or rubber hammer.
As with any wheel, periodically check your aluminum wheels for
damage. If damaged, replace immediately.
SUSPENSION AND CHASSIS
CAUTION
Do not modify the suspension/chassis with lift kits, spacers,
springs, etc. It can cause dangerous handling characteristics,
resulting in loss of control.