air conditioning lexus LS400 1998 Engine / LEXUS 1998 LS400 (OM50498U) Owner's Guide

AIR CONDITIONING AND AUDIO
145 When the magazine is set completely, the system will be in a ”Load”
cycle for approximately 20 seconds while the system searches for
discs in the magazine. Upon completion of this cycle, the CD unit
will be ready to play. If the ”CD” button is pushed during the ”Load”
cycle, ”LOAD” appears on the display until the system has
completed the load cycle, after which the system will begin normal
play.
CAUTION
To reduce the chance of injury in case of an accident or a
sudden stop, always keep the cover closed while driving.
(b) Playing a compact disc
20L058-1
Push the ”CD” button if the magazine is already loaded in the
player.
”CD” appears on the display.
The discs set in the magazine are played continuously, starting with
disc number 1. The disc number of the disc currently being played,
the track number and the time from the beginning of the program
appear on the display.
When play of one disc ends, the first track of the following disc
starts. When play of the final disc ends, play of the first disc starts
again.
The player will skip any empty disc trays.

AIR CONDITIONING AND AUDIO
146(c) Selecting a desired disc
20L025-1
Push the ”DISC” button to select the disc number.
Push the button and hold it until the desired disc number appears on
the display. When you release the button, the player will start
playing the selected disc from the first track.(d) Searching for a desired track
20L053-3
Push the ”SCAN” button briefly.
”SCAN” will appear on the display. The compact disc player will
play the next track for 10 seconds, then scan again. To select a track,
push the ”SCAN” button a second time. If the player reaches the end
of the disc, it will continue scanning at track 1.
After all the tracks are scanned in one pass, normal play resumes.

AIR CONDITIONING AND AUDIO
147 (e) Searching for a desired disc
20L054-2
Push the ”SCAN” button until you hear a beep.
With ”D.SCAN” on the display, the program at the beginning of each
disc will be played for 10 seconds. To continue listening to the
program of your choice, push the ”SCAN” button a second time.
After all the discs in the magazine are scanned in one pass, the scan
function is cancelled.(f) Selecting a desired track
20L100
”TRACK” button: Use for direct access to a desired track.
Push either side of the ”TRACK” button and hold it until the desired
track number appears on the display. As you release the button, the
player will start playing the selected track from the beginning.
”Fast forward” button.
Push the ”

” button and hold it to fast forward the disc. When
you release the button, the compact disc player will resume playing
from that position.
”Reverse” button.
Push the ”” button and hold it to reverse the disc. When you
release the button, the compact disc player will resume playing.

AIR CONDITIONING AND AUDIO
148(g) Other compact disc player functions
20L055-2
”RPT” button: Use it for automatic repeat of the track you are
currently listening to.
Push the button while the track is playing. When the track is
finished, the player will automatically go back to the beginning of
the track and play the track again. To cancel it, push the button once
again.
”RAND” button: Use it for automatic track selection and play by
the system.
When the button is pushed, the system selects a track in the discs
which are set and plays it. To cancel it, push the button once again.
When a track is skipped or the system is inoperative, push the button
to reset.(h) If the player malfunctions
If ”WAIT” appears on the display, audio signals of the disc cannot
be read or the system has trouble. Push the ”CD” button once again.
If the player does not operate, check that the disc surface is not soiled
or damaged. If the disc is O.K., the following two causes are
possible.
Condensation may have occurred on the internal mechanism of
the automatic changer. Open the cover to let the air circulate.
The temperature of the player’s internal mechanism is raised
because of high external temperature. Remove the magazine
from the player to cool it.
If the player still does not operate, take it to your Lexus dealer.
Car audio system operating hints
NOTICE
To ensure the correct audio system operation:
Be careful not to spill beverages over the audio system.
Do not put anything other than a cassette tape or CD
magazine into the cassette tape slot or CD changer.

AIR CONDITIONING AND AUDIO
149 Radio reception
Usually, the problem with radio reception does not mean there is a
problem with your radio it is just the normal result of conditions
outside the vehicle.
For example, nearby buildings and terrain can interfere with FM
reception. Power lines or telephone wires can interfere with AM
signals. And of course, radio signals have a limited range, and the
farther you are from a station, the weaker its signal will be. In
addition, reception conditions change constantly as your vehicle
moves.
Here are some common reception problems that probably do not
indicate a problem with your radio:
FM
Fading and drifting stations Generally, the effective range of FM
is about 40 km (25 miles). Once outside this range, you may notice
fading and drifting, which increase with the distance from the radio
transmitter. They are often accompanied by distortion.
Multipath FM signals are reflective, making it possible for two
signals to reach your antenna at the same time. If this happens, the
signals will cancel each other out, causing a momentary flutter or
loss of reception.
Static and fluttering These occur when signals are blocked by
buildings, trees, or other large objects. Increasing the bass level may
reduce static and fluttering.Station swapping If the FM signal you are listening to is
interrupted or weakened, and there is another strong station nearby
on the FM band, your radio may tune in the second station until the
original signal can be picked up again.
AM
Fading AM broadcasts are reflected by the upper atmosphere
especially at night. These reflected signals can interfere with those
received directly from the radio station, causing the radio station to
sound alternately strong and weak.
Station interference When a reflected signal and a signal received
directly from a radio station are very nearly the same frequency, they
can interfere with each other, making it difficult to hear the
broadcast.
Static AM is easily affected by external sources of electrical noise,
such as high tension power lines, lightening, or electrical motors.
This results in static.
Caring for your cassette player and tapes
For high performance from your cassette player and tapes:
Clean the tape head and other parts regularly.
A dirty tape head or tape path can decrease sound quality and
tangle your cassette tapes. The easiest way to clean them is by
using a cleaning tape. (A wet type is recommended.)

AIR CONDITIONING AND AUDIO
150Use highquality cassettes:
Lowquality cassette tapes can cause many problems, including
poor sound, inconsistent playing speed, and constant
autoreversing. They can also get stuck or tangled in the cassette
player.
Do not use a cassette if it has been damaged or tangled or if its
label is peeling off.
Do not leave a cassette in the player if you are not listening to it,
especially if it is hot outside.
Store cassettes in their cases and out of direct sunlight.
Avoid using cassettes with a total playing time longer than 100
minutes (50 minutes per side). The tape used in these cassette is
thin and could get stuck or tangled in the cassette player.Caring for your compact disc player and discs
20L037
Use only compact discs labeled as shown. The player is intended
for use with 12 cm (4.7 in.) discs only.
Extremely high temperature can keep your compact disc player
from working. On hot days, use air conditioning to cool the
vehicle interior before you listen to a disc.
Bumpy roads or other vibrations may make your compact disc
player skip.
If moisture gets into your compact disc player, you may not hear
any sound even though your compact disc player appears to be
working. Remove the magazine from the player and wait until it
dries.

AIR CONDITIONING AND AUDIO
151
20L038
Correct
Wrong
Handle compact discs carefully, especially when you set them
into the magazine. Hold them on the edge and do not bend them.
Avoid getting fingerprints on them, particularly on the shiny side.
Dirt, scrapes, warping, pin holes, or other disc damage could
cause the player to skip or to repeat a section of a track. (To see
a pin hole, hold the disc up to the light.)
20L039
To clean a compact disc: Wipe it with a soft, lintfree cloth that has
been dampened with water. Wipe in a straight line from the center
to the edge of the disc (not in a circle). Do not use a conventional
record cleaner or antistatic device.

AIR CONDITIONING AND AUDIO
152
20L040
A new disc may have rough edges on its inner and outer
perimeter. Remove the rough edges by pressing the side of a
ballpoint pen or pencil against the inner and outer edges of the
disc as shown.
If you continue to play a disc with rough edges, flakes will fall on to
the signal side of the disc and cause sound skipping or other
problems.
CAUTION
Compact disc players use invisible laser beams which could
cause hazardous radiation exposure if directed outside the
unit. Be sure to operate the player correctly as instructed.

DRIVING TIPS
188Because of the added load of the trailer, your vehicle’s engine
may overheat on hot days (at temperatures over 30C [85F])
when going up a long or steep grade with a trailer. If the engine
coolant temperature gauge indicates overheating, immediately
turn off the air conditioning (if in use), pull your vehicle off the
road and stop in a safe spot. See ”If your vehicle overheats” on
page 196 of this manual.
Always place wheel blocks under both the vehicle and trailer
wheels when parking. Apply the parking brake firmly. Put the
transmission in ”P”. Avoid parking on a slope with a trailer, but
if it cannot be avoided, do so only after performing the following:
1. Apply the brakes and keep them applied.
2. Have someone place wheel blocks under both the vehicle and
trailer wheels.
3. When the wheel blocks are in place, release your brakes slowly
until the blocks absorb the load.
4. Apply the parking brake firmly.
5. Shift into ”P” and turn off the engine.When restarting out after parking on a slope:
1. With the transmission in ”P” position, start the engine. Be sure
to keep the brake pedal depressed.
2. Shift into the ”3”, ”2”, ”L” or ”R” position.
3. Release the parking brake and brake pedal and slowly pull or back
away from the wheel blocks. Stop and apply your brakes.
4. Have someone retrieve the blocks.
CAUTION
Do not exceed 72 km/h (45 mph) or the posted towing speed
limit, whichever is lower. Because instability (swaying) of
a towing vehicletrailer combination usually increases as
the speed increases, exceeding 72 km/h (45 mph) may cause
loss of control.
Slow down and downshift before descending steep or long
downhill grades. Do not make sudden downshifts.
Avoid holding the brake pedal down too long or too
frequently. This could cause the brakes to overheat and
result in reduced braking efficiency.

IN CASE OF AN EMERGENCY
197 B: If no steam is coming from your engine:
Leave the engine running and turn off the air conditioning. Check
the following.
Is the cooling fan operating?
Is the coolant in the acceptable range?
Is the engine drive belt O.K.?
CAUTION
When the engine is running, keep hands and clothing away
from the moving fan and engine drive belt.
Do not attempt to remove the radiator cap when the engine
and radiator are hot. Serious injury could result from
scalding hot fluid and steam blown out under pressure.
If the cooling fan is not operating or the coolant is not in the
acceptable range, turn off the engine and call your Lexus dealer.
If both conditions are O.K., after the engine coolant temperature has
cooled to normal, continue driving your vehicle.
If the engine coolant temperature does not cool down, or your
vehicle overheats again, have it checked as soon as possible by your
Lexus dealer.
IF YOU HAVE A FLAT TIRE
1. Reduce your speed gradually, keeping a straight line. Move
cautiously off the road to a safe place well away from the traffic.
Avoid stopping on the center divider of a highway. Park on a level
spot with firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the parking brake and put the transmission in ”P”.
4. Have everyone get out of the vehicle on the side away from
traffic.
5. Read the following instructions thoroughly.
NOTICE
For vehicles equipped with the height control switch, be sure to
turn the ignition switch off before jacking. If this is not done, the
vehicle height adjustment function will operate, which may
cause body damage.
CAUTION
When jacking, be sure to observe the following to reduce the
possibility of personal injury:
Follow jacking instructions.
Do not start or run the engine while your vehicle is
supported by the jack.