lock lexus LS400 2000 Engine / LEXUS 2000 LS400 (OM50533U) Manual Online

IN CASE OF AN EMERGENCY
363
40L046
2. Block the wheel diagonally opposite the flat tire to
keep the vehicle from rolling when it is jacked up.
When blocking a wheel, place a wheel block in front of
the front wheels or behind the rear wheels.

IN CASE OF AN EMERGENCY
365
CAUTION
Do not try to pull off the ornament by hand. Take due
care in handling the ornament to avoid unexpected
personal injury.
40L008±1
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before raising the vehicle.
Turn the wheel nuts counterclockwise to loosen them.
To get maximum leverage, fit the wrench to the nut so
that the handle is on the right side, as shown above.
Grab the wrench near the end of the handle and pull up
on the handle. Be careful that the wrench does not slip
off the nut.
Do not remove the nuts yet ± just unscrew them about
one±half turn.

IN CASE OF AN EMERGENCY
367
40L010±2
6. After making sure no one is in the vehicle, raise
it high enough so that the spare tire can be installed.
Allow for the fact that you need more ground clearance
when putting on the spare tire than when removing the
flat tire.
To raise the vehicle, insert the jack handle into the jack
(it is a loose fit) and turn it clockwise. As the jack touches
the vehicle and begins to lift, double±check that it is
properly positioned.

IN CASE OF AN EMERGENCY
371
40L014±1
9. Lower the vehicle completely and tighten the
wheel nuts.
Turn the jack handle counterclockwise to lower the
vehicle.
Use only the wheel nut wrench to tighten the nuts. Do
not use other tools or any additional leverage other than
your hands, such as a hammer, pipe or your foot. Make
sure the wrench is securely engaged over the nut.
Tighten each nut a little at a time in the order shown.
Repeat the process until all the nuts are tight.

IN CASE OF AN EMERGENCY
377
40L022±1
Place the ignition key in the ºACCº position.
NOTICE
Do not tow with the key removed or in theºLOCKº position, as the steering lockmechanism is not strong enough to hold thefront wheels straight.
When lifting wheels, take care to ensureadequate ground clearance for towing at theopposite end of the raised vehicle. Otherwise,the bumper and/or underbody of the towedvehicle will be damaged during towing.
(b) Using a flat bed truck

IN CASE OF AN EMERGENCY
384
IF YOU CANNOT SHIFT
AUTOMATIC TRANSMISSION SELECTOR LEVER
40L025a
If you cannot shift the selector lever, use the shift
lock override button as follows:
1Turn the ignition key to ºLOCKº or ºACCº. Make
sure the parking brake is applied. Pry up the cover
with a flat±bladed screwdriver or equivalent.

IN CASE OF AN EMERGENCY
385
40L026a
2Insert your finger, the screwdriver or equivalent into
the hole to push down the shift lock override button.
You can shift the selector lever while pushing the
button.
For your safety, keep the brake pedal depressed.
Be sure to have the system checked by your Lexus
dealer as soon as possible.

IN CASE OF AN EMERGENCY
386
IF YOU LOSE YOUR KEYS ORLOCK YOURSELF OUT
You can purchase a new key at your Lexus dealer if
you can give them the key number and master key.
Even if you lose only one key, contact your Lexus dealer
to make a new key. If you lose all your master keys, you
cannot make new keys; the whole engine immobiliser
system must be replaced.
See the suggestion given in ªKeysº on page 9.
You can use the wireless remote control system with the
new key. Contact your Lexus dealer for detailed
information.
If your keys are locked in the vehicle and you cannot get
a duplicate, many Lexus dealers can still open the door
for you, using their special tools. If you must break a
window to get in, we suggest breaking the smallest side
window because it is the least expensive to replace. Be
extremely cautious to avoid cuts from the glass.

MAINTENANCE
390
GENERAL MAINTENANCE
Listed below are the general maintenance items that
should be performed at the intervals specified. It is
recommended that any problem you notice be brought
to the attention of your Lexus dealer or qualified service
shop for their advice.
CAUTION
Make these checks only where adequate ventilation can
be obtained if you run the engine.
Vehicle exterior
Items listed below should be performed from time to
time, unless otherwise specified.
Tire pressure
Check the pressure with a gauge every two weeks, or at
least once a month and adjust as shown on the tire
pressure label. See page 431 for a dditional information.
Tire surface
Check the tires carefully for cuts, damage or excessive
wear. See page 435 for additional information.
Wheel nuts
When checking the tires, make sure to check the nuts for
looseness. Tighten them if necessary. Tire rotation
Rotate
the tires every 12000 km (7500 miles). See page
433 for additional information.
Fluid leaks
Check underneath for leaking fuel, oil, water or other
fluid after the vehicle has been parked for a while. If you
smell fuel fumes or notice any leak, have the cause
found and corrected immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate
smoothly and all latches lock securely. Make sure the
engine hood secondary latch secures the hood when the
primary latch is released.

MAINTENANCE
391
Vehicle interior
Items listed below should be checked regularly, e.g.
while performing periodic services, cleaning the
vehicle, etc.
Lights
Make sure the headlights, stop lights, tail lights, turn
signal lights, and other lights are working. Check
headlight aim.
Service reminder indicators and warning buzzers
Check that all service reminder indicators and warning
buzzers function properly. Steering wheel
Check that it has the specified free play. Be alert for
changes in steering condition, such as hard steering,
excessive free play or strange noise.
Seats
Check
that all front seat controls such as seat adjusters,
seatback recliner, etc. operate smoothly. Check that the
head restraints move up and down smoothly and that the
locks hold securely in any latched position.
Seat belts
Check that the seat belt system such as buckles,
retractors and anchors operate properly and smoothly.
Make sure the belt webbing is not cut, frayed, worn or
damaged.
Accelerator pedal
Check the pedal for smooth operation and uneven pedal
effort or catching.
Brake pedal
Check the pedal for smooth operation and the proper
clearance and free play. Check the brake booster
function.
Brakes
At a safe place, check that the brakes do not pull to one
side when applied.