garage door opener lexus LS400 2000 Engine / LEXUS 2000 LS400 OWNER'S MANUAL (OM50533U)

SECTION 1 ± 4
81
INSTRUMENTS AND CONTROLS
Interior equipment
Vanity mirrors81
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Interior lights 83
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Personal lights 85
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ignition switch light 87
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Clock 88
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . .
Outside temperature display 89
. . . . . . . . . . . . . . . . . . . . .
Cigarette lighter and ashtray 90
. . . . . . . . . . . . . . . . . . . . .
Power outlet 92
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Rear console box 94
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Glove box 94
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\

Garage door opener 96
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cup holder 99
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Coin box 102
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .\

Penlight 103
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
.
Floor mat 103
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Luggage stowage precautions 106
. . . . . . . . . . . . . . . . . .
VANITY MIRRORS

INTERIOR EQUIPMENT
96
GARAGE DOOR OPENER
The garage door opener is manufactured under
license from HomeLink and can be programmed
to operate garage doors, estate gates, security
lighting, etc.
(a) Programming HomeLink
14L040

INTERIOR EQUIPMENT
97


1Indicator light 2Buttons
The
HomeLink has 3 buttons and can be
programmed to operate 3 separate devices.
Prepare the HomeLink
 for programming by
erasing all codes or the memorized data
programmed by the former owner. Follow the
procedure in º(c) Erasing the garage door opener
memoryº.
1. Decide which one of the 3 buttons you want to
program. Push and hold down the button for about 20
seconds until the indicator light begins to flash. While
holding this button, follow steps º2º and º3º.
2. Bring the hand held garage door opener within about
25 mm (1 in.) of the button being programmed and push
the button on the hand held garage door opener. The
signal from the hand held garage door opener is sent to
the vehicle's opener.
3. When the frequency and code is registered, the
indicator light flashes rapidly. At this point, you can
release both buttons.
4. To program the remaining buttons, repeat steps º1º
through º3º.
If you want to replace an existing program with a new
program, select the button you want to program. Follow
the procedure from step 1.
If the transmitter has a ºrolling code featureº, it is
necessary to program the in±garage receiver after programming
HomeLink
.
1. Locate the ºtrainingº or ºlearningº button on the
in±garage receiver and push and release this
button. Location of the button may vary by the
garage door opener manufacturer.
2. Firmly push and release the trained HomeLink

button 2 times (some garage door manufacturer
may require you to push the HomeLink button up
to 3 times) to complete the process.
The garage door should now operate when the
HomeLink
 button is pushed.

INTERIOR EQUIPMENT
98Do not use the HomeLink
 universal transmitter with
any garage door opener that lacks the safety stop and
reverse feature as required by Federal Safety
Standards. This includes any garage door opener
model manufactured before April 1, 1982.
CAUTION
When programming or operating the garage door
opener, make sure there is no one around the moving
door. It is dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door
opener. The indicator light comes on. The garage door
opener continues to send the signal for up to 20 seconds
as long as the button is pushed.
(c) Erasing the garage door opener memory
Push and hold down the 2 outside buttons for about 20
seconds until the indicator light flashes. All memorized
data will be erased. FCC ID: CB2V94800
CANADA: 1763 102 264
This device complies with FCC Rules Part 15.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference that may be received,
including interference that may cause undesired
operation. WARNING: This transmitter has
been tested and complies with FCC and
DOC/MDC rules. Changes or modifications
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the device.

ELECTRICAL COMPONENTS
452
35 RADIONO.120Audio system
36 MPX±B10Power window, Door lock,
Tilt and telescopic steering
37 ECU±B7.5Vehicle skid control system,
Daytime running light system
38 HAZ10Emergency flashers
No.FUSEAMPERECIRCUIT
39 EFI NO.120Multiport fuel injection
system/sequential multiport fuel
injection system
40 DOME10Interior light, Vanity lights,
Foot lights, Rear personal light,
Garage door opener
41 OBD7.5On±board diagnosis system
42 DRL10Daytime running light system
43 H±LP R LW R15Right±hand headlight (low
beam)
44 H±LP LLW R15Left±hand headlight (low beam)