snow LEXUS LS430 2005 User Guide

STARTING AND DRIVING
316In the power mode, the “ECT PWR” light in the instrument
cluster is on and the transmission is shifted up at higher vehicle
speeds and shifted down more responsively
than in the normal
mode.
To return to the normal mode, push the driving pattern selector
switch lightly on the “SNOW” side.
Snow mode: For slippery road surfaces such as in snow. In
this mode, the spinning of the rear wheels is controlled
appropriately.
When you push the driving pattern selector switch on the
“SNOW” side, the snow mode is turned on and the “ECT
SNOW” light in the instrument cluster comes on.
To return to the normal mode, push the driving pattern selector
switch on the “SNOW” side again.
When you turn the ignition switch off in the snow mode, the
mode automatically changes to the normal mode.
LEXUS PARK ASSIST SYSTEM
31L354b
 Sensors
The Lexus park assist system will help you to easily park
by detecting any obstacle around your vehicle with
ultrasonic sensors and informing you of the approximate
distance from the vehicle to the obstacle with the
indicators on the display and with beeping sounds.*
This system will operate at a vehicle speed of less than about
10 km/h (6 mph) with the selector lever in a position other than
“P”.
NOTE:
* The volume of the beeps can be changed.
Ask your Lexus dealer for details.

STARTING AND DRIVING
320
W285
If the sensor is malfunctioning or a cable is broken, the
above message appears.
Although it is no problem to continue driving, have your vehicle
checked by your Lexus dealer as soon as possible.
W286
If icicles, snowflakes or mud gets on the sensor or it is
frozen, the sensor may not be able to detect an obstacle.
In either case, the above message appears.
Remove the foreign matter or deice the sensor. If the message
does not appear after cleaning, the system is operating
properly.
Lexus park assist system operating hints
31L355
 Sensor detection range
1
About 1 m (3 ft.) 2About 50 cm (1.5 ft.)
The sensor detection range is limited around the bumper.
Be sure to confirm a safe distance around your vehicle
and drive slowly.
If more than one obstacle is detected in the same
direction, the indicators for the obstacle nearest to the
vehicle will turn on.

STARTING AND DRIVING
321
CAUTION
Do not install an accessory or the like within the sensor
detection range. Doing so may cause the Lexus park
assist system to malfunction, resulting in an accident.
NOTICE
The sensors do not detect an obstacle just under the
bumper. A short object, thin stake or the like will be
detected once but might not be detected as your
vehicle gets very close to such an object.
 If an obstacle is very close to your vehicle, it might
not be detected.
 If a sensor is subjected to a strong impact, it will not
operate properly.
The Lexus park assist system may not work properly in
the following cases:
When icicles, snowflakes or mud gets on the sensors.
If removed, the system will work properly.
 When the sensor is frozen.
If deiced, the system will work properly.
 When the sensor is covered with something.
If removed, the system will work properly. Especially in cold weather, a malfunction warning screen may
appear on
the display due to frozen sensors. If the “Clean Park
Sonar” appears on the display, be sure to clean the sensor. If
the “Clean Park Sonar” appears despite no mud, ice or
snowflakes on the sensor, the sensor might have
malfunctioned. Have your vehicle checked by your Lexus
dealer.
In the following conditions, the detection range may be
affected:
 When you stop your vehicle in extreme hot or cold weather.
 Foreign matter such as snowflakes or mud gets on the
sensor.

STARTING AND DRIVING
322The Lexus park assist system may detect the following by
mistake:

Bumpy roads or gravelled roads or grass when driving on
such surfaces, or on grass
 Devices issuing ultrasonic waves, such as a horn from
another vehicle, motorcycle engine, air braking sound from
heavy−duty vehicles, if such a device is operated around
your vehicle
 Rain or water splashing over the sensor
 The ground on which the vehicle is tilted
 Radio antenna or fender pole mounted on your vehicle
 Mud, ice or snowflakes on the sensor
 Tall curb stone
 Towing eyelet mounted on your vehicle
 Towing hitch mounted on your vehicle The Lexus park assist system may not detect the
following:

Thin objects such as wire or rope
 Objects with a surface area too small to reflect ultrasonic
waves such as wire gauze or fence
 Sound wave absorbing objects such as cotton or snow
 Objects with a sharp edge
 Shorter objects
 Tall objects with the upper part projected
For vehicles with a Navigation System, the park assist
graphics appear both on the navigation display and
multi− information display. For details, see the separate
“Navigation System Owner’s Manual”.
For vehicles sold in Canada
This ISM device complies with Canadian ICES −001.

STARTING AND DRIVING
324
If the camera lens becomes dirty, it cannot transmit
a clear image. If water droplets, snow, or mud adhere
to the lens, rinse with water and wipe with a soft cloth.
If the lens is extremely dirty, wash it with a mild
cleanser and rinse.
 The displayed image may become darker and moving
images may be slightly distorted when the system is
cold. When backing up, be sure to check behind and
all around the vehicle visually and with mirror before
proceeding.AREA DISPLAYED ON SCREEN
Image is displayed approximately level on screen.
31L356
Check surroundings for safety.
 Corners of bumper

STARTING AND DRIVING
325

The area covered by the camera is limited. Objects
which are close to either corner of the bumper or under
the bumper cannot be seen on the screen.
 The area displayed on the screen may vary according
to vehicle orientation or road conditions. REAR VIEW MONITOR SYSTEM CAMERA
31L352
The rear view monitor system camera is located on the trunk
as shown in the illustration. The camera uses a special lens.
The distance of the image that appears on the screen differs
from the actual distance.
In the following cases, it may become difficult to see the images
on the screen, even when the system is functioning.

In the dark (for example, at night)
 When the temperature near the lens is extremely high or low
 When water droplets are adhering to the camera, or when
humidity is high (for example, when it rains)
 When foreign matter (for example, snow or mud) adheres
to the camera lens
 When the sun or the beam of headlights is shining directly
into the camera lens

STARTING AND DRIVING
326
31L357
Check surroundings for safety.
If a bright light (for example, sunlight reflected off the vehicle
body) is picked up by the camera, the smear effect* peculiar
to the camera may occur.
*: Smear effect — A phenomenon that occurs when a bright
light (for example, sunlight reflected off the vehicle body) is
picked up by the camera; when transmitted by the camera, the
light source appears to have a vertical streak above and below
it.
CRUISE CONTROL
The cruise control allows you to cruise the vehicle at a
desired speed over about 40 km/h (25 mph) with your foot
off the accelerator pedal.
Your cruising speed can be maintained although a slight speed
change may occur when driving up or down a gradient, within
the limits of engine performance. On steeper hills, a great
speed change will occur so it is better to drive without the cruise
control.
When the cruise control is on, the driving pattern of the
automatic transmission is fixed in the normal position,
regardless of the position of the selector switch.
CAUTION
 To help maintain maximum control of your vehicle,
do not use the cruise control when driving in heavy
or varying traffic, or on slippery (rainy, icy or
snowcovered) or winding roads.
 Avoid vehicle speed increases when driving
downhill. If the vehicle speed is too fast in relation to
the cruise control set speed, cancel the cruise
control then downshift the transmission to use
engine braking to slow down.

STARTING AND DRIVING
335
Dynamic radar cruise control—
CAUTION
Certain conditions make vehicle detection difficult or
impossible.

As this system operates by detecting primarily the
reflected wave from the rear end of the vehicle ahead,
the distance cannot be accurately detected in the
following cases, resulting in improper
vehicletovehicle distance.
 The rear section of the vehicle ahead is extremely
small such as an unloaded trailer.
 The vehicle ahead or other vehicles around you
are flinging up water or snow.
 Heavy luggage which is loaded in your trunk or on
top of your rear seats is raising up the nose of your
vehicle.
 The millimeter wave radar sensor automatically
detects dirt if it is sticking to the front of the sensor
or grille cover of your vehicle, and if detected, a
message is shown on the multiinformation display.
However, if the sensor or grille cover is covered with
a metallic vinyl bag, icicle, snowflakes, etc., dirt may
not be detected, resulting in improper
vehicletovehicle distance. Continue driving with
due care to the vehicle ahead. If dirt is detected, the
dynamic radar cruise control function is
automatically cancelled. Always keep the sensor and
grille cover clean.

STARTING AND DRIVING
336
Dynamic radar cruise control should not be used in the
following conditions, to avoid death or serious injury.
In bad weather (such as rain, fog, snow , sandstorms,
or when raindrops or snowflakes get in the millimeter
wave radar sensor or the grille cover), the
vehicletovehicle distance will not be measured
accurately.
If the wipers are operated at high speed (including the
high speed operation with the wiper lever in the
“AUTO” position), dynamic radar cruise control is
automatically cancelled. (In the case of the low speed
operation and intermittent wiper operation, it is not
cancelled.) Dynamic radar cruise control is
automatically cancelled when the measurement is
extremely unstable due to bad weather.
 On the roads in heavy traffic or at sharp bends:
As an appropriate speed cannot be maintained, death
or serious injury could result.
 On slippery road surfaces (icy or snowcovered road
surfaces):
The tires will race and you will be unable to control.On steep downhill slopes:
If there is no vehicle detected ahead, the preset speed
will be easily exceeded because of inefficient engine
braking, resulting in death or serious injury. (In this
case, automatic braking will not work.) If there is a
vehicle detected ahead, the delay in deceleration
timing could cause death or serious injury.
 When the warning tone sounds frequently (because
acceleration or deceleration was repeated or
sufficient vehicletovehicle distance was not
maintained), an appropriate vehicle speed cannot be
attained, resulting in death or serious injury.
 On roads with steep and short inclines and declines,
failure to detect the vehicle ahead will shorten the
distance between your vehicle and the vehicle ahead,
resulting in death or serious injury.

STARTING AND DRIVING
337
Dynamic laser cruise control—
CAUTION
Certain conditions make vehicle detection difficult or
impossible.

As this system operates by detecting primarily the
reflectors of the vehicle ahead, the distance cannot
be accurately detected in the following cases,
resulting in improper vehicletovehicle distance.
 The vehicle ahead has higher ground clearance,
which means that the placement of the reflectors
is in a higher position.
 The rear section of the vehicle ahead is extremely
dirty.
 The vehicle ahead or other vehicles around you
are flinging up water or snow.
 Excessive exhaust gas (black smoke) is coming
from the vehicle ahead or other vehicles around
you, obscuring your front view.
 Protective film is attached to the reflectors on the
vehicle ahead, or reflectors are not installed on the
vehicle ahead or are damaged.
 Heavy luggage which is loaded in your trunk or on
top of your rear seats is raising up the nose of your
vehicle.
 The laser radar sensor automatically detects dirt if it
is sticking to the sensor glass of your vehicle, and if
detected, a message is shown on the
multiinformation display. However, if the sensor
glass is covered with a transparent or translucent
vinyl bag, icicle, etc., dirt may not be detected,
resulting in improper vehicletovehicle distance.
Continue driving with due care to the vehicle ahead.
If dirt is detected, the dynamic laser cruise control
function is automatically cancelled. Always keep the
sensor glass clean.