steering wheel LEXUS LS430 2005 Owner's Manual

STEERING WHEEL AND MIRRORS
235
16L784
To ensure correct functioning of antiglare mirror sensors
located on both sides of the mirror, do not touch or cover
the sensors with your finger or a piece of cloth, etc.
157.VANITY MIRRORS
Front
14L206
To use the front vanity mirrors, swing the sun visor down
and open the cover.
The vanity light comes on when you open the cover. However
if the sun visor is not hooked securely, the light may not come
on.

STEERING WHEEL AND MIRRORS
236
Rear
14L228a
To use the rear vanity mirrors, open the cover.
The vanity light comes on when you open the cover.
NOTICE
Keep the rear vanity mirrors closed when not in use.
Otherwise you may hit your head on the mirror when
you get in or out of the vehicle.
 To prevent the battery from being discharged, do not
leave the cover open for a long time while the engine
is stopped.

AUDIO
288(c) When the “CD” mode is selected
“CH” button: Use this button to search a desired CD.
”
“ button: Use this button to search a desired track or
push this button and hold it to fast forward or reverse.
Audio remote controls (Steering switches)
20L353
The steering switches are installed on the left side of the
steering wheel.
“MODE” switch: Use this switch to change the mode. If a tape
or CD is not inserted, the “TAPE” or “CD” mode is skipped.
When you push the switch with the audio system turned off, the
audio system turns on.
“VOL” switches: Use these switches to adjust the volume.
Push “
” to increase the volume and “ ” to decrease the
volume. The volume continues to increase or decrease while
the switch is being pressed.
“SET” switch: Use this switch to adjust the preset volume.
To preset the volume, adjust the volume and then push and
hold this switch until you hear a beep.

STARTING AND DRIVING
298
BEFORE STARTING THE ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat cushion length, seat position, seatback angle,
seat cushion angle, seat cushion height, head restraint height
and steering wheel angle.
3. Adjust the inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators
function when turning the ignition switch to “ON”, and check the
fuel gauge to see that you have sufficient fuel.
SMART IGNITION SWITCH WITH STEERING LOCK
31L345a
Carrying a smart key allows you to start the engine
without the key being inserted into the ignition switch.
The smart key system can be deactivated using a key cancel
switch. For details, see “Deactivating the smart key system”
on page 34.

STARTING AND DRIVING
299
31L346a
When you enter the vehicle carrying a sm art key and push
the ignition switch, the electronic code in the key is
automatically checked as to whether it corresponds to the
registered ID code for the vehicle. The key indicator light
comes on, the steering column lock is released, and the
engine immobilizer system is cancelled.
At this time, the security indicator light goes off and you can
start the engine when you turn the ignition switch and the key
indicator light does not come on. When you turn the ignition
switch, turn it slowly and surely. If you turn it quickly, it may
become stuck. To free it, see the following “If the ignition switch
seems to be stuck”.
If you push the ignition switch when the smart key is not within
the effective range of the smart key system, a warning tone
sounds and “Key is not Detected” appears on the display. If the ignition switch seems to be stuck:
To free the ignition switch, perform the following:
31L638
1. Push the ignition switch.
31L639
2. Be sure to push the ignition switch while turning the
steering wheel slightly in either direction, and then turn
the switch.

STARTING AND DRIVING
300“START” Starter motor on. The ignition switch will
return to the “ON” position when released.
For starting tips, see page 304.
“ON” Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the ignition switch in the “ON” position if
the engine is not running. The battery will discharge
and the electronic ignition system could be damaged.
“ACC” Accessories such as the radio operate, but the
engine is off.
31L347
“LOCK” Engine is off and the steering wheel is locked.
When
you leave your vehicle, be sure to turn the ignition switch
to the “LOCK” position and carry the smart key.
 If you open the driver’s door without returning the ignition
switch to the “LOCK” position, beeps keep sounding while
the door is opened.
 If you close a door to leave your vehicle while carrying a key
on which the ignition switch has not been returned to the
“LOCK” position, “Key is not Detected” appears on the
multi−information display, a warning tone sounds inside and
beeps sound outside.
 If the selector lever is in a position other than “P”, you cannot
turn the ignition switch to the “LOCK” position. At this time,
when you open the driver’s door and are going to get out of
the vehicle, “Shift to P Range” appears on the
multi−information display and a warning tone sounds inside.

STARTING AND DRIVING
302If the ignition switch seems to be stuck:
Ty p e A
To free the ignition switch, perform the following:
31L640
1. Be sure the key is pushed all the way in.
31L641
2. Push the key while turning the steering wheel slightly
in either direction, and then turn the key.
Type B
31L642
1. Be sure the key is pushed all the way in.
31L643
2. Turn the key while turning the steering wheel slightly in
either direction.

STARTING AND DRIVING
303
“START” Starter motor on. The key will return to the
“ON” position when released.
For starting tips, see page 304.
“ON” Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the key in the “ON” position if the engine
is not running. The battery will discharge and the
electronic ignition system could be damaged.
“ACC” Accessories such as the radio operate, but the
engine is off.
If you leave the key in the “ACC” or “LOCK” position and open
the driver’s door, a buzzer will remind you to remove the key.*
NOTE:
* The volume or interval of beep sound can be changed.
Ask your Lexus dealer for details.
31L349
 1 Type A 2Type B
“LOCK” Engine is off and the steering wheel is locked.
The ignition key can be removed only at this position.
To turn the ignition switch from “ACC” to the “LOCK” position,\
you must put the transmission selector lever in the “P” position.
Once you remove the key, the engine immobilizer system is
automatically set. See “Engine immobilizer system” on page
17.
If, in an emergency, you must turn the engine off while the
vehicle is moving, turn the key only to “ACC”.

STARTING AND DRIVING
345
CAUTION
Deceleration cruising function and approach
warning do not operate when the vehicle ahead is at
a stop or driving very slowly
 While vehicletovehicle distance control (followup
cruising) is on, acceleration and deceleration are
automatically performed in proportion to the speed
of the vehicle ahead detected. However, if the vehicle
ahead of you decelerates abruptly or if another
vehicle cuts in ahead of you, your vehicle may collide
with the vehicle ahead unless you manually depress
the brake pedal to slow down your vehicle. If you
need to accelerate because the vehicle ahead or you
changes lanes, then depress the acceleration pedal.
 Depending on the road configuration (curved roads,
left and right continuous curved roads, driving at the
start or end of the curve, narrow driving lanes due to
road construction) or your vehicle condition
(steering wheel maneuvering, position in the lane or
unstable driving because of an accident or
breakdown), vehicles in other lanes or surrounding
objects will be detected, resulting in a control failure
or the activated approach warning. This may also
result in a very close distance between vehicles due
to a failure to detect the vehicle ahead. Maneuvering
the steering wheel in response to a violent lateral
wind will cause similar conditions.
31L588
CAUTION
If other vehicles are driving outside of the millimeter
wave radar or laser radar detection range, a delay in the
detection of the vehicle cutting in at short range or
detection failure of the motorcycle running on the side
of the same lane will occur. In this case, the dynamic
radar/laser cruise control system will not function
properly.

STARTING AND DRIVING
364
“Check VSC” warning message
31L337a
If the vehicle stability control system or the traction
control system malfunctions, the master warning light
and “TRAC OFF” indicator light come on. At this time a
warning tone sounds and the above message appears.
If the message appears, the vehicle stability control system
and traction control system do not work. Although it is no
problem to continue driving, have your vehicle checked by
your Lexus dealer as soon as possible.
VEHICLE STABILITY CONTROLSYSTEM
The vehicle stability control system helps provide
comprehensive control of the systems such as antilock
brake system, traction control, engine control, etc. This
system automatically controls the brakes and engine to
help prevent the vehicle from skidding when cornering on
a slippery road surface or operating steering wheel
abruptly.
This system activates when the vehicle speed is about more
than 15 km/h (9 mph).
You may hear a sound in the engine compartment for a few
seconds just after the vehicle begins to move. This means that
the system is in the self −check mode, but does not indicate a
malfunction.