lock LEXUS LS460L 2016 Owners Manual

6027-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
NOTICE
■To prevent damage to the vehicle when towing using a wheel-lift type truck
●Do not tow the vehicle from the rear when the engine switch is off. The steering
lock mechanism is not strong enough to hold the front wheels straight.
●When raising the vehicle, ensure adequate ground clearance for towing at the
opposite end of the raised vehicle. Without adequate clearance, the vehicle
could be damaged while being towed.
■To prevent damage to the vehicle when towing with a sling-type truck
Do not tow with a sling-type truck, either from the front or rear.
■To prevent damage to the vehicle during emergency towing
Do not secure cables or chains to the suspension components.

6287-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
One of the following may be the cause of the problem:
●One or both of the battery terminals may be disconnected.
●The battery may be discharged. (P. 636)
●There may be a malfunction in the steering lock system.
Contact your Lexus dealer if the problem cannot be repaired, or if repair proce-
dures are unknown.
When the engine does not start, the following steps can be used as an
interim measure to start the engine if the engine switch is functioning nor-
mally:
Turn the engine switch to IGNITION ON mode ( P. 260) and check
that the parking brake is set.
Shift the shift lever to P.
Turn the engine switch to ACCESSORY mode.
Press and hold the engine switch for about 15 seconds while depress-
ing the brake pedal firmly.
Even if the engine can be started using the above steps, the system may be
malfunctioning. Have the vehicle inspected by your Lexus dealer.
The starter motor does not turn over, the interior lights and head-
lights do not turn on, or the horn does not sound.
Emergency start function
1
2
3
4

6307-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
Remove the plug.
Insert the tool and press it down
firmly while turning it counter-
clockwise until it stops.
■Manual operation of the parking brake
The parking brake cannot be set manually.
4
5
CAUTION
■When releasing the parking brake manually
●Shift the shift lever to P, turn the engine switch off and chock the tires.
Failure to do so may cause the vehicle to move, resulting in an accident.
●Turn the engine switch off and check that the parking brake indicator is off.
Failure to do so may cause the system to operate and turn the inserted parking
brake release tool, resulting in an injury.

6317-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
Use the mechanical key built in to the electronic keys to operate the
doors. ( P. 145)
On some models: An alarm will sound if the alarm is set when the trunk or doors
are unlocked. ( P. 112)
■Doors
Remove the cover on the
driver’s door handle.
If the electronic key does not operate properly
If communication between the electronic key and vehicle is inter-
rupted ( P. 163) or the electronic key cannot be used because the
battery is depleted, the smart entry & start system and wireless remote
control cannot be used. In such cases, the doors and trunk can be
opened and the engine can be started by following the procedure
below.
Locking and unlocking the doors, unlocking the trunk and key
linked functions
1

6327-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
Locks and unlocks the doors
Locks all the doors
Closes the windows and
moon roof*1 (turn and hold)
Unlocks the door*2
Turning the key rearward
unlocks the driver’s door. Turn-
ing the key once again unlocks
the other doors.
Unlocks all doors*3
Opens the windows and
moon roof*1 (turn and hold)
*1: If equipped
*2:For USF40L-AEZGHA,
USF45L-AEZGHA, USF41L-
AEZGHA, USF40L-AEZGHV,
USF41L-AEZGHV and
USF41L-AEZGKV models
*3: Except for USF40L-AEZGHA,
USF45L-AEZGHA, USF41L-
AEZGHA, USF40L-AEZGHV,
USF41L-AEZGHV and
USF41L-AEZGKV models
The model code is indicated on
the manufacturer’s label.
( P. 650)
2
1
2
3
4

6337-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
After the operation is com-
pleted, reinstall the cover.
Hook the upper claw of the
cover onto the upper catch on
the vehicle side, and then push
on the lower side of the cover.
Make sure that the lower claw of
the cover is securely fastened to
the lower catch on the vehicle side.
If the cover is not securely
attached, it may fall off while driv-
ing.
■Trunk
Turn the mechanical key clock-
wise to open.
3

6347-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
Ensure that the shift lever is in P and depress the brake pedal.
Touch the Lexus emblem side of
the electronic key to the engine
switch.
If any of the doors is opened or closed
after the key was touched to the
switch to start the vehicle, an alarm
will sound to indicate that the start
function cannot detect the key.
Press the engine switch within 10 seconds of the buzzer sounding,
keeping the brake pedal depressed.
In the event that the engine still cannot be started, contact your Lexus
dealer.
■Stopping the engine
Shift the shift lever to P and press the engi ne switch as you normally do when stop-
ping the engine.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted. ( P. 575)
■Alarm (on some models)
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set, the
alarm may be triggered.
■Changing engine switch modes
Within 10 seconds of the buzzer sounding, release the brake pedal and press the
engine switch.
The engine does not start and modes will be changed each time the switch is
pressed. ( P. 260)
Starting the engine
1
2
3

6367-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
If you have a set of jumper (or booster) cables and a second vehicle with a
12-volt battery, you can jump start your vehicle by following the steps
below.
Confirm that the electronic key is
being carried.
When connecting the jumper (or
booster) cables, depending on the sit-
uation, the alarm may activate and
doors locked. (P. 114)
Open the hood. Remove the engine compartment covers and battery
cover. ( P. 536, 541, 543)
If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehi-
cle’s battery is discharged.
You can also call your Lexus deal er or a qualified repair shop.
1
2

6397-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
■Starting the engine when the battery is discharged
The engine cannot be started by push-starting.
■To prevent battery discharge
●Turn off the headlights and the audio system while the engine is off.
●Turn off any unnecessary electrical components when the vehicle is running at a
low speed for an extended period, such as in heavy traffic.
■Charging the battery
The electricity stored in the battery will discharge gradually even when the vehicle is
not in use, due to natural discharge and the draining effects of certain electrical
appliances. If the vehicle is left for a long time, the battery may discharge, and the
engine may be unable to start. (The battery recharges automatically during driving.)
■When recharging or replacing the battery
In some cases, it may not be possible to unlock the doors using the smart entry &
start system when the battery is discharged. Use the wireless remote control or the
mechanical key to lock or unlock the doors.
■If the battery is discharged
The information stored in the computer will be deleted.
If the battery is discharged, have the vehicle inspected by your Lexus dealer.

651
8
8-1. Specifications
Vehicle specifications
LS460/LS460L_GE (OM50G06E)
■Year of manufacture and coun try of origin (GCC countries*, Yemen
and Lebanon)
The year of the manufacture and country of origin are shown on the
Certification Regulation label.
*: Saudi Arabia, Sultanate of Oman, Bahrain, United Arab Emirates, Qatar,
Kuwait
■Engine number
2WD models
The engine number is stamped
on the engine block as shown.
AWD models
The engine number is stamped
on the engine block as shown.