light LEXUS LS460L 2016 Owners Manual

6387-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
Start the engine of the second vehicle. Increase the engine speed
slightly and maintain at that level for approximately 5 minutes to
recharge the battery of your vehicle.
Open and close any of the doors of your vehicle with the engine switch
off.
Maintain the engine speed of the second vehicle and start the engine of
your vehicle by turning the engine switch to IGNITION ON mode.
Once the vehicle’s engine has started, remove the jumper cables in the
exact reverse order from which they were connected.
Once the engine starts, have the vehicle inspected at your Lexus dealer as
soon as possible.
4
5
6
7

6397-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
■Starting the engine when the battery is discharged
The engine cannot be started by push-starting.
■To prevent battery discharge
●Turn off the headlights and the audio system while the engine is off.
●Turn off any unnecessary electrical components when the vehicle is running at a
low speed for an extended period, such as in heavy traffic.
■Charging the battery
The electricity stored in the battery will discharge gradually even when the vehicle is
not in use, due to natural discharge and the draining effects of certain electrical
appliances. If the vehicle is left for a long time, the battery may discharge, and the
engine may be unable to start. (The battery recharges automatically during driving.)
■When recharging or replacing the battery
In some cases, it may not be possible to unlock the doors using the smart entry &
start system when the battery is discharged. Use the wireless remote control or the
mechanical key to lock or unlock the doors.
■If the battery is discharged
The information stored in the computer will be deleted.
If the battery is discharged, have the vehicle inspected by your Lexus dealer.

6407-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
CAUTION
■Avoiding battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flammable
gas that may be emitted from the battery:
●Make sure each jumper cable is connected to the correct terminal and that it is
not unintentionally in contact with any other than the intended terminal.
●Do not allow the other end of the jumper cable connected to the “+” terminal to
come into contact with any other parts or metal surfaces in the area, such as
brackets or unpainted metal.
●Do not allow the + and - clamps of the jumper cables to come into contact with
each other.
●Do not smoke, use matches, cigarette lighters or allow open flame near the bat-
tery.
■Battery precautions
The battery contains poisonous and corrosive acidic electrolyte, while related
parts contain lead and lead compounds. Observe the following precautions when
handling the battery:
●When working with the battery, always wear safety glasses and take care not to
allow any battery fluids (acid) to come into contact with skin, clothing or the vehi-
cle body.
●Do not lean over the battery.
●In the event that battery fluid comes into contact with the skin or eyes, immedi-
ately wash the affected area with water and seek medical attention.
Place a wet sponge or cloth over the affected area until medical attention can be
received.
●Always wash your hands after handling the battery support, terminals, and other
battery-related parts.
●Do not allow children near the battery.
NOTICE
■When handling jumper cables
When connecting the jumper cables, ensure that they do not become entangled in
the cooling fans or engine drive belt.

659
8
8-1. Specifications
Vehicle specifications
LS460/LS460L_GE (OM50G06E)
*: Minimum pedal clearance when depressed with a force of 500 N (51 kgf, 112 lbf)
while the engine is running.
When performing the brake pedal inspection, also be sure to check that the
brake system warning light is not illuminated when the engine is running (If the
brake system warning light is illuminated, refer to P. 605).
Brakes
Pedal clearance*147 mm (5.8 in.) Min.
Pedal free play1.0 - 2.0 mm (0.04 - 0.08 in.)
Fluid typeSAE J1703 or FMVSS No.116 DOT 3 or,
SAE J1704 or FMVSS No.116 DOT 4
Steering
Free playLess than 30 mm (1.2 in.)

6648-1. Specifications
LS460/LS460L_GE (OM50G06E)
*1: Left-hand drive vehicles without Adaptive High-beam System
*2: Left-hand drive vehicles with Adaptive High-beam System and right-hand drive
vehicles
*3: If equipped
Light bulbs
Light bulbsWType
Exterior
Headlights (vehicles with discharge head-
lights)
High beam*1
High beam or high beam/near-infrared ray
transmitters*2
Low/high beam
60
65
35
A
B
C
Rear fog lights*321D
Interior
Vanity lights
Front
Rear
8
3
D
E
Trunk lid light3.8D
Trunk light3.8D
A: HB3 halogen bulbs
C: D4S discharge bulbs
E: Double end bulbs
B: H9 halogen bulbs
D: Wedge base bulbs

6668-1. Specifications
LS460/LS460L_GE (OM50G06E)
■Use of ethanol blended gasoline in a gasoline engine (except for Korea)
Lexus allows the use of ethanol blended gasoline where the ethanol content is up to
10%. Make sure that the ethanol blended gasoline to be used has a Research
Octane Number that follows the above.
■Use of ethanol blended gasoline in a gasoline engine (for Korea)
●Make sure that the ethanol blended gasoline to be used has a suitable Research
Octane Number.
■If your engine knocks
●Consult your Lexus dealer.
●You may occasionally notice light knocking for a short time while accelerating or
driving uphill. This is normal and there is no need for concern.
●Use only gasoline containing up to 15% eth-
anol.
DO NOT use any flex-fuel or gasoline that
could contain more than 15% ethanol,
including from any pump labeled E30, E50,
E85 (which are only some examples of fuel
containing more than 15% ethanol).
NOTICE
■Notice on fuel quality
●Do not use improper fuels. If improper fuels are used, the engine will be dam-
aged.
●Do not use leaded gasoline.
Leaded gasoline will cause the three-way catalytic converter to lose its effective-
ness and the emission control system to function improperly.
●Do not use the methanol blended gasoline such as M15, M85, M100.
The use of gasoline containing methanol may cause engine damage or failure.
DO NOT use gasoline con-
taining more than 15% ethanol.
(30% ethanol)
(50% ethanol)
(85% ethanol)

6688-2. Customization
LS460/LS460L_GE (OM50G06E)
ItemFunctionDefault
setting
Custom-
ized setting
Multi-infor-
mation
display
( P. 129)
Language*1American
English*2
British
English*2
—OO
French*2
Spanish*2
German*2
Italian*2
Russia*2
Simplified
Chinese*2
Traditional
Chinese*2
Units*1km
(L/100km)km (km/L)—OO
ECO lamp
ON
(Self-light-
ing)
OFF
—OOON
(Always)
Drive monitorCruising
range
Fuel
consump-
tion
—OO
Lamp brightnessStandardBright—OO
SPORT lampONOFF—OO
Background screenONOFF—OO
Default settingsOFFON—OO
123

6708-2. Customization
LS460/LS460L_GE (OM50G06E)
Smart entry
& start
system
( P. 153)
Smart entry & start systemOnOffO—O
Smart door unlocking*1All the
doors
Driver’s
door
O—OEach door
Same side
doors
Welcome light illumination
controlOnOff——O
Opening trunk without the
electronic key when all
doors are unlocked
OnOff——O
Wireless
remote
control
( P. 177)
Wireless remote controlOnOff——O
Unlocking operation*1All doors
unlocked in
one step
Driver’s
door
unlocked in
one step, all
doors
unlocked in
two steps
O—O
Trunk unlocking operationOne long
press
One short
press
——OPush twice
Off
Front seats
( P. 198)
Driver’s seat movement
when exiting the vehicleStandard
Off
O—O
Partial
Driver’s seat lumbar sup-
port movement when exit-
ing the vehicle
OnOff——O
ItemFunctionDefault
setting
Custom-
ized setting123

673
8
8-2. Customization
Vehicle specifications
LS460/LS460L_GE (OM50G06E)
Power
windows
( P. 236)
and moon
roof*1
( P. 240)
One-touch close opera-
tion using the power win-
dow switches on the front
passenger door and each
rear door
OnOff——O
One-touch front passen-
ger window or rear win-
dow close operation using
the power window switch
on the driver’s door
OnOff——O
Mechanical key linked
operationOnOff——O
Wireless remote control
linked operation*2OffOn——O
Linked entry functionOnOff——O
Turn signal
lever
( P. 278)
Times of flashing of the lane
change signal flashers3
5
O—O
7
9
11
Off
Automatic
light control
system
( P. 285)
Light sensor sensitivityStandard-2 to 2O—O
Time elapsed before head-
lights automatically turn off
after doors are closed*2
30 sec-
onds
0 second
O—O
60 sec-
onds
90 sec-
onds
ItemFunctionDefault
setting
Custom-
ized setting123

6748-2. Customization
LS460/LS460L_GE (OM50G06E)
Automatic
light control
system
( P. 285)
Time elapsed before head-
lights and tail lights auto-
matically turn off*2
30
seconds
60
seconds
——O90
seconds
120
seconds
Time elapsed before head-
lights automatically turn
on*2StandardLong——O
AFS (Adap-
tive Front-
lighting Sys-
tem)
( P. 288)
Adaptive Front-lighting
SystemOnOff——O
Adaptive
High-beam
System*2
( P. 291)
Changing to variable
shade beamOnOff——O
Vehicle speed at which
Adaptive High-beam Sys-
tem operates and variable
shade beam adaptation
angle
Normal
driving
Normal
driving
(Speed:
low)*3
——O
For ease of
operation
under
mountain
road driv-
ing condi-
tions
For ease of
operation
under
mountain
road driv-
ing condi-
tions
(Speed:
low)*3
ItemFunctionDefault
setting
Custom-
ized setting123