brake LEXUS LS600H 2015 Manual Online

5217-2. Steps to take in an emergency
7
When trouble arises
LS600hL_U(OM50E41U)
Remove the plug.
Insert the tool and press it down
firmly while turning it counter-
clockwise until it stops.
Vehicles with run-flat tires
Take out the parking brake release tool and the screwdriver from the
trunk. ( P. 5 1 6 )
Check that the flathead end of
the screwdriver is exposed.
If the Phillips end is exposed, reinsert
the screwdriver shaft so the flathead
end is exposed.
4
5
1
Phillips end
Flathead end
2

5227-2. Steps to take in an emergency
LS600hL_U(OM50E41U)
Using the flathead end of the
screwdriver, remove the clips.
When installing the tool tray clips:
P. 5 2 3
Take out the tool tray and side
deck boards.
Remove the plug.
Replace the screwdriver head
with the parking brake release
tool.
3
4
5
6

5237-2. Steps to take in an emergency
7
When trouble arises
LS600hL_U(OM50E41U)
Insert the tool and press it down
firmly while turning it counter-
clockwise until it stops.
■When installing the tool tray cl ips (vehicles with run-flat tires)
■Manual operation of the parking brake
The parking brake cannot be set manually.
7
CAUTION
■When releasing the parking brake manually
●Shift the shift lever to P, turn the power switch off and chock the tires.
Failure to do so may cause the vehicle to move, resulting in an accident.
●Turn the power switch off and check that the parking brake indicator is off.
Failure to do so may cause the system to operate and turn the inserted parking
brake release tool, resulting in an injury.
Install the clips as shown in the illustration.

5267-2. Steps to take in an emergency
LS600hL_U(OM50E41U)
Ensure that the shift lever is in P and depress the brake pedal.
Touch the Lexus emblem side of
the electronic key to the power
switch.
If any of the doors is opened or closed
after the key was touched to the
switch to start the vehicle, an alarm
will sound to indicate that the start
function cannot detect the key.
Press the power switch within 10 seconds of the buzzer sounding,
keeping the brake pedal depressed.
In the event that the hybrid system still cannot be started, contact your
Lexus dealer.
■Stopping the hybrid system
Shift the shift lever to P and press the power switch as you normally do when stop-
ping the hybrid system.
■Replacing the key battery
As the above procedure is a temporary meas ure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted. ( P. 4 7 2 )
■Changing power switch modes
Within 10 seconds of the buzzer soundi ng, release the brake pedal and press the
power switch.
The hybrid system does not start and modes will be changed each time the switch is
pressed. ( P. 2 1 7 )
Starting the hybrid system
1
2
CAUTION
■When using the mechanical key and operating the power windows and moon
roof
Operate the power window or moon roof af ter checking to make sure that there is
no possibility of any passenger having any of their body parts caught in the window
or moon roof.
Also, do not allow children to operate the mechanical key. It is possible for children
and other passengers to get caught in the power window or moon roof.
3

5357-2. Steps to take in an emergency
7
When trouble arises
LS600hL_U(OM50E41U)
Stop the hybrid system. Set the parking brake and shift the shift lever to
P.
Remove the mud, snow or sand from around the rear wheels.
Place wood, stones or some other material under the rear wheels to
help provide traction.
Restart the hybrid system.
Shift the shift lever to D or R and release the parking brake. Then, while
exercising caution, depress the accelerator pedal.
■When it is difficult to free the vehicle
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt or snow:
Press to turn off TRAC.
1
2
3
4
5

5458-1. Specifications
8
Vehicle specifications
LS600hL_U(OM50E41U)
*: Your Lexus vehicle is filled with “Toyota Genuine Differential Gear Oil” at the fac-
tory. Use Lexus approved “Toyota Genuine Differential Gear Oil” or an equiva-
lent of matching quality to satisfy th e above specification. Please contact your
Lexus dealer for further details.
*: Minimum pedal clearance when depressed with a force of 112 lbf (500 N, 51 kgf)
while the hybrid system is operating.
When performing the brake pedal inspection, also be sure to check that the
brake system warning light is not illumina ted when the hybrid system is operating
(If the brake system warning light is illuminated, refer to P. 493).
Rear differential
Oil capacity1.42 qt. (1.35 L, 1.19 Imp. qt.)
Oil type and viscosity*Toyota Genuine Differential gear oil LX
75W-85 GL-5 or equivalent
Brakes
Pe d a l c l e a r a n c e*5.8 in. (147 mm) Min.
Pedal free play0.04 - 0.08 in. (1.0 - 2.0 mm)
Brake pad wear limit0.04 in. (1.0 mm)
Parking brake lining wear limit0.04 in. (1.0 mm)
Fluid typeSAE J1703 or FMVSS No.116 DOT 3
Steering
Free playLess than 1.2 in. (30 mm)

5598-1. Specifications
8
Vehicle specifications
LS600hL_U(OM50E41U)
Glossary of tire terminology
Tire related termMeaning
Cold tire inflation pres-
sureTire pressure when the vehicle has been parked for
three hours or more, or has not been driven more
than 1 mile or 1.5 km under that condition
Maximum inflation pres-
sureThe maximum cold inflated pressure to which a tire
may be inflated, shown on the sidewall of the tire
Recommended inflation
pressureCold tire inflation pressure recommended by a man-
ufacturer
Accessory weight
The combined weight (in excess of those standard
items which may be replaced) of hybrid transmission,
power steering, power brakes, power windows,
power seats, radio and heater, to the extent that these
items are available as factory-installed equipment
(whether installed or not)
Curb weight
The weight of a motor vehicle with standard equip-
ment, including the maximum capacity of fuel, oil and
coolant, and if so equipped, air conditioning and
additional weight optional engine
Maximum loaded vehicle
weight
The sum of:
(a) Curb weight
(b) Accessory weight
(c) Vehicle capacity weight
(d) Production options weight
Normal occupant weight150 lb. (68 kg) times the number of occupants speci-
fied in the second column of Table 1
* that follows
Occupant distributionDistribution of occupants in a vehicle as specified in
the third column of Table 1
* below
Production options weight
The combined weight of installed regular production
options weighing over 5 lb. (2.3 kg) in excess of the
standard items which they replace, not previously
considered in curb weight or accessory weight,
including heavy duty brakes, ride levelers, roof rack,
heavy duty 12-volt battery, and special trim
RimA metal support for a tire or a tire and tube assembly
upon which the tire beads are seated

5728-2. Customization
LS600hL_U(OM50E41U)
*1:If equipped
*2: The default setting varies according to countries.
*3: U.S.A. only
*4: Refer to the “NAVIGATION AND MULTIMEDIA SYSTEM OWNER’S MAN-UAL”.
■Vehicle customization
●When the smart access system with push-button start is off, the entry unlock func-
tion cannot be customized.
●When the doors remain closed after un locking the doors and the timer activated
automatic door lock function activates, signals will be generated in accordance
with the operation buzzer volume and operational signal (Emergency flashers)
function settings.
■When customizing using the Remote Touch
Stop the vehicle in a safe place, apply the parking brake, and shift the shift lever to P.
Also, to prevent 12-volt battery discharge, leave the hybrid system operating while
customizing the features.
Illumination
(  P. 3 6 0 )
Operation of the outer foot
lights when you approach
the vehicle with the elec-
tronic key on your person
OnOff——O
Operation of the outer foot
lights when the doors are
unlocked with the power
door lock switch
OnOff——O
Seat belt
reminder
(
P. 4 9 6 )
Vehicle speed linked seat
belt reminder buzzerOnOff——O
ItemFunctionDefault
settingCustom-
ized setting123

594What to do if... (Troubleshooting)
LS600hL_U(OM50E41U)●
Did you press the power switch
while firmly depressing the
brake pedal? ( P. 2 1 6 )
●Is the shift lever in P? ( P. 2 1 6 )
●Is the electronic key anywhere detectable inside the vehicle?
( P. 1 2 9 )
●Is the steering wheel unlocked? ( P. 2 1 8 )
●Is the electronic key battery weak or depleted?
In this case, the hybrid system can be started in a temporary
way. ( P. 5 2 6 )
●Is the 12-volt battery discharged? ( P. 5 2 7 )
●Is the power switch in ON mode?
If you cannot release the shift lever by depressing the brake
pedal with the power switch in ON mode ( P. 5 1 9 )
●It is locked automatically to prevent theft of the vehicle.
( P. 218)
If you think something is wrong
The hybrid system does not start
The shift lever cannot be shifted from P even if you depress the
brake pedal
The steering wheel cannot be turn ed after the hybrid system is
stopped

595What to do if... (Troubleshooting)
LS600hL_U(OM50E41U)●
Is the window lock switch pressed?
The power window except for the one at the driver’s seat can-
not be operated if the window
lock switch is pressed. (P. 1 8 9 )
●The auto power off function will be operated if the vehicle is left
in ACCESSORY mode for a period of time. ( P. 218)
●The seat belt remind er light is flashing
Are the driver and the front passenger wearing the seat belts?
( P. 4 9 6 )
●The parking brake indicator is on
Is the parking brake released? ( P. 2 2 8 )
Depending on the situation, ot her types of warning buzzer may
also sound. ( P. 493, 503)
The windows do not open or close by operating the power win-
dow switches
The power switch is turned off automatically
A warning buzzer sounds during driving