warning light LEXUS LS600H 2017 User Guide

511-1. For safe use
1
For safety and security
LS600h/LS600hL_EE(OM50G20E)
SRS airbag system components
Front passenger’s seat belt
buckle switch
Side impact sensors (front)
“PASSENGER AIR BAG” indi-
cator light
Airbag manual on-off switch
Front passenger airbag
Curtain shield airbags
Knee airbags
Front side airbags
Active head restraints
(if equipped)
SRS warning light
Rear side airbags (if equipped)
Seat belt pretensioners and
force limiters
Driver airbag
Seat cushion airbag
(if equipped)
Side impact sensors (rear)
Driver’s seat belt buckle switch
Driver’s seat position sensor
Airbag sensor assembly
Front impact sensors
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19

911-2. Hybrid system
1
For safety and security
LS600h/LS600hL_EE(OM50G20E)
■If a warning light comes on, a warning message is displayed, or the 12-volt battery is
disconnected
The hybrid system may not start. In that case, try to start the system again. If the
“READY” indicator does not come on, contact any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
■Running out of fuel
When the vehicle has run out of fuel and the hybrid system cannot be started, refuel
the vehicle with at least enough gasoline to make the low fuel level warning light
( P. 558) go off. If there is only a small amount of fuel, the hybrid system may not be
able to start. (The minimum amount of fuel to add to make the low fuel level warning
light go out is about 13 L [3.4 gal., 2.8 Imp. gal.], when the vehicle is on a level sur-
face. This value may vary when the vehicle is on a slope.)
■Electromagnetic waves
●High voltage parts and cables on the hybrid vehicles incorporate electromagnetic
shielding, and therefore emit approximately the same amount of electromagnetic
waves as conventional gasoline powered vehicles or home electronic appliances.
●Your vehicle may cause sound interference in some third party-produced radio
parts.
■Hybrid battery (traction battery)
The hybrid battery (traction battery) has a limited service life. The lifespan of the
hybrid battery (traction battery) can change in accordance with driving style and
driving conditions.
■Declaration of conformity
This model conforms to hydrogen emissions according to regulation ECE100 (Bat-
tery electric vehicle safety).

109
2Instrument cluster
LS600h/LS600hL_EE(OM50G20E)
2. Instrument cluster
Warning lights and
indicators.......................................110
Gauges and meters ..................... 115
Multi-information display .......... 121
Energy monitor/
consumption screen ............... 130

110
LS600h/LS600hL_EE(OM50G20E)
2. Instrument cluster
◆Instrument cluster
The units used on the speedometer may differ depending on the target region.
◆Center panel
Warning lights and indicators
The warning lights and indicators on the instrument cluster, center
panel and outside rear view mirrors inform the driver of the status of
the vehicle’s various systems.
For the purpose of explanation, the following illustration displays all
warning lights and indicators illuminated.

1122. Instrument cluster
LS600h/LS600hL_EE(OM50G20E)
Warning lights inform the driver of malfunctions in the indicated vehicle’s
systems.
*1: These lights come on when the power switch is turned to ON mode to indicate
that a system check is being performed. They will go off after the hybrid system is
on, or after a few seconds. There may be a malfunction in a system if the lights do
not come on, or go off. Have the vehi cle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and equipped professional.
*2: The light flashes to indicate a malfunction.
Warning lights
*1
Brake system warning light
( P. 555)
*1, 2
(if equipped)
Brake hold operated indi-
cator ( P. 557)
*1Charging system warning
light ( P. 556)
*1, 2Parking brake indicator
( P. 557)
*1Malfunction indicator
lamp ( P. 556)
*1Brake system warning light
( P. 557)
*1SRS warning light
( P. 556)
Open door warning light
( P. 558)
*1ABS warning light
( P. 556)
Low fuel level warning light
( P. 558)
*1Electric power steering
system warning light
( P. 557)
Seat belt reminder light
( P. 558)
*1, 2
(if equipped)
Pre-crash safety system
warning light ( P. 557)
*1
Master warning light
( P. 558)
*1
Slip indicator (P. 557)*1Tire pressure warning light
( P. 559)

1132. Instrument cluster
2
Instrument cluster
LS600h/LS600hL_EE(OM50G20E)
The indicators inform the driver of the operating state of the vehicle’s vari-
ous systems.
Indicators
Turn signal indicator
( P. 262)
*1Brake hold standby indica-
tor ( P. 266)
Tail light indicator
( P. 269)
*1Brake hold operated indi-
cator ( P. 266)
Headlight high beam indi-
cator ( P. 269)
Cruise control “SET” indi-
cator
( P. 289, 293, 307)
Adaptive High-beam Sys-
tem indicator ( P. 273)
Cruise control indicator
( P. 289, 293, 307)
Front fog light indicator
( P. 280)(if equipped)
Radar cruise control indi-
cator ( P. 293, 307)
Rear fog light indicator
( P. 280)(if equipped)
LKA (Lane-Keeping
Assist) indicator
( P. 326)
“READY” indicator
( P. 247)
*1“HEIGHT HIGH” indica-
tor ( P. 336)
EV indicator ( P. 87)*1, 2
Slip indicator (P. 340)
EV drive mode indicator
( P. 252)
*1VSC (Vehicle Stability
Control) OFF indicator
( P. 341)
Snow mode indicator
( P. 258)
*1, 3
(if equipped)
Pre-crash safety system
warning light ( P. 348)

1142. Instrument cluster
LS600h/LS600hL_EE(OM50G20E)
*1: These lights come on when the power switch is turned to ON mode to indicate
that a system check is being performed. They will go off after the hybrid system is
on, or after a few seconds. There may be a malfunction in a system if the lights do
not come on, or go off. Have the vehi cle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and equipped professional.
*2: The light flashes to indicate that the system is operating.
*3: The light comes on when the system is turned off. The light flashes faster than
usual to indicate that the system is operating.
*4: In order to confirm operation, the BSM outside rear view mirror indicators illumi-
nate in the following situations:
• When the power switch is turned to ON mode while the BSM main switch is
set to ON.
• When the BSM main switch is set to ON while the power switch is in ON
mode.
If the system is functioning correctly, the BSM outside rear view mirror indicators
will turn off after a few seconds.
If the BSM outside rear view mirror indicators do not illuminate or do not turn off,
there may be a malfunction with the system.
If this occurs, have the vehicle inspected by any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
*1Parking brake
indicator ( P. 263)
*1“PASSENGER
AIR BAG” indica-
tor ( P. 61)
*4
(if equipped)
BSM (Blind Spot Monitor)
outside rear view mirror
indicators ( P. 366)
CAUTION
■If a safety system warning light does not come on
Should a safety system light such as the ABS and SRS warning light not come on
when you start the hybrid system, this could mean that these systems are not avail-
able to help protect you in an accident, which could result in death or serious injury.
Have the vehicle inspected by any authorized Lexus dealer or repairer, or another
duly qualified and equipped professional immediately if this occurs.

2654-2. Driving procedures
4
Driving
LS600h/LS600hL_EE(OM50G20E)
■Parking brake indicator light
●Depending on the power switch mode, the parking brake indicator light will come
on and stay on as described below:
ON mode: Comes on until the parking brake is released.
Not in ON mode: Stays on for approximately 15 seconds.
●When the power switch is turned off with the parking brake set, the parking brake
indicator light will stay on for about 15 seconds. This does not indicate a malfunc-
tion.
■Parking brake engaged warning buzzer
A buzzer will sound if the vehicle is driven at a speed of approximately 5 km/h (3
mph) or more with the parking brake engaged.
■When there is a malfunction in the system
Warning lights and/or warning message will turn on or flash. ( P. 555, 563)
Depending on the condition, the parking brake indicator light may flash.
■Usage in winter time
 P. 384
NOTICE
■When parking the vehicle
Before you leave the vehicle, set the parking brake, shift the shift lever to P and
make sure that the vehicle does not move.
■When the system malfunctions
Stop the vehicle in a safe place and check the warning messages.
■When the parking brake cannot be released due to a malfunction
Use the parking brake release tool to manually release the parking brake.
( P. 599)
Driving the vehicle with the parking brake set will lead to brake components over-
heating, which may affect braking performance and increase brake wear.

2664-2. Driving procedures
LS600h/LS600hL_EE(OM50G20E)
Turns the brake hold system on
The brake hold standby indicator
(green) comes on. While the system is
holding the brake, the brake hold
operated indicator (yellow) comes on.
■Brake hold system operating conditions
The brake hold system cannot be turned on in the following conditions:
●The trunk or hood is not closed.
●The driver’s door is not closed.
●The driver is not wearing the seat belt.
If any of the conditions above are detected when the brake hold system is enabled,
the system will turn off and the brake hold standby indicator light will go off. In addi-
tion, if any of the conditions are detected while the system is holding the brake, a
warning buzzer will sound and a message will be shown on the multi-information dis-
play. The parking brake will then be set automatically.
■Brake hold function
●If the brake pedal is left released for a period of about 3 minutes after the system
has started holding the brake, the parking brake will be set automatically. In this
case, a warning buzzer sounds and a message is shown on the multi-information
display.
●To turn the system off while the system is holding the brake, firmly depress the
brake pedal and press the switch again.
●The brake hold function may not hold the vehicle when the vehicle is on a steep
incline. In this situation, it may be necessary for the driver to apply the brakes. The
multi-information display will inform the driver of this situation.
Brake Hold
The brake hold system keeps the brake applied when the shift lever is in
D, S or N with the system on and the brake pedal has been depressed to
stop the vehicle. The system releases the brake when the accelerator
pedal is depressed with the shift lever in D or S to allow smooth start off.

2674-2. Driving procedures
4
Driving
LS600h/LS600hL_EE(OM50G20E)
■When the parking brake is set automatically while the system is holding the brakes
The parking brake will not be released automatically. Release the parking brake by
operating the parking brake switch, making sure that the parking brake indicator
light goes off. ( P. 263)
■When there is a malfunction in the system
Warning lights and/or warning messages will turn on or flash. ( P. 557, 563)
CAUTION
■When the vehicle is on a steep incline
When using the brake hold system on a steep incline exercise caution. The brake
hold function may not hold the vehicle in such a situation.
■When stopped on a slippery road
The system cannot stop the vehicle when the gripping ability of the tires has been
exceeded. Do not use the system when stopped on a slippery road.
NOTICE
■When parking the vehicle
The brake hold system is not designed for use when parking the vehicle for a long
period of time. Turning the power switch off while the system is holding the brake
may release the brake, which would cause the vehicle to move. When operating
the power switch, depress the brake pedal, set the parking brake and shift the shift
lever to P.