instrument panel LEXUS LX470 2006 User Guide

INTERIOR EQUIPMENT
71
IGNITION SWITCH LIGHT
14X004a
For easy access to the ignition switch, the ignition switch
light comes on when any of the doors are opened.
The light remains on for about 15 seconds and goes out after
all the doors are closed. However, the light goes out
immediately when all the doors are locked or the ignition key
is in the “ACC” or “ON” position.
CLOCK
14X500
The digital clock indicates the time when the ignition key
is at the “ACC” or “ON” position. To reset the hour, press
the “H” button. To reset the minutes, press the “M”
button. To adjust the time to the nearest hour, press the
“:00” button.
For example, if the “:00” button is pressed when the time is
between 9:30 − 9:59 or between 10:01 − 10:29, the time will
change to 10:00.
If the electrical power source has been disconnected from the
clock, the time display will automatically be set to 1:00.
When the headlight switch is in the first or second click stop,
you can also adjust the brightness of the display using the
instrument panel light control dial.

INTERIOR EQUIPMENT
72
OUTSIDE TEMPERATURE DISPLAY
14X501
This display shows the outside temperature when the
ignition switch is on.
The displayed temperature ranges from −30C (− 22F) up to
50 C (122F). If the temperature does not appear on the
display or it shows “− − ”, take your vehicle to your Lexus dealer.
When the headlight switch is in the first or second click stop,
you can also adjust the brightness of the display using the
instrument panel light control dial.
The unit shown on the display can be changed. For details,
see “Trip information display” on page 63.
CIGARETTE LIGHTER AND ASHTRAY
Front
14X006c
To use the cigarette lighter, press in the cigarette lighter.
After it finishes heating up, it automatically pops out ready
for use.
Do not hold the cigarette lighter pressed in.
If the engine is not running, the ignition key must be in the
“ACC” position to use the lighter.
When finished with your cigarette, thoroughly extinguish it in
the ashtray to prevent other cigarette butts from catching fire.
After using the ashtray, close the lid completely.
To remove the ashtray, press down on the lock spring plate and
pull out.
Use a Lexus genuine cigarette lighter or equivalent for
replacement.

EXTERIOR EQUIPMENT
92
HOOD
15X001a
1. To open the hood, pull the hood lock release lever
under the instrument panel. The hood will spring up
slightly.
15X014c
2. Insert your fingers under the hood, push up the
auxiliary catch lever and lift the hood.
Before closing the hood, check to see that you have not
forgotten any tools, rags, etc. Then lower the hood and make
sure it locks.
CAUTION
Before driving, be sure that the hood is closed and
securely locked. Otherwise, the hood may open
unexpectedly while driving and an accident may occur.

EXTERIOR EQUIPMENT
93
FUEL TANK CAP
15x500
The arrow head next to as shown indicates on which
side of your vehicle the fuel filler door is located.
15X003a
1. To open the fuel filler door, pull the lever under the
instrument panel.
When refueling, turn off the engine.
CAUTION
 Do not smoke, cause sparks or allow open flames
when refuelling. The fumes are flammable.
 When opening the cap, do not remove the cap
quickly. In hot weather, fuel under pressure could
cause injury by spraying out of the filler neck if the
cap is suddenly removed.

OCCUPANT RESTRAINT SYSTEMS
103
If your steering wheel is adjustable, tilt it downward.
This points the airbag toward your chest instead of
your head and neck.
The seat should be adjusted as recommended by
NHTSA above, while still maintaining control of the foot
pedals, steering wheel, and your view of the instrument
panel controls.
Front passenger seat
CAUTION
 The SRS front passenger airbag also deploys with
considerable force, and can cause death or serious
injury especially if the front passenger is very close
to the airbag. The front passenger seat should be as
far from the airbag as possible with the seatback
adjusted, so the front passenger sits upright.
 Do not use seat accessory, such as a cushion or seat
cover, that covers the front seat, or do not modify or
replace the upholstery of the front seat. Such
accessories or changes may prevent the front
passenger airbag system from activating correctly,
disable the system or cause the front passenger
airbag to inflate accidentally, resulting in death or
serious injury.
Front seats
CAUTION
The SRS side airbags are installed in the driver and front
passenger seats. Observe the following precautions.
 Do not lean against the front door when the vehicle
is in use, since the side airbag inflates with
considerable speed and force. Otherwise, you may
be killed or severely injured.
 Do not use seat accessories which cover the area
where the side airbags inflate. Such accessories may
prevent the side airbags from activating correctly,
causing death or serious injury.
 Do not modify or replace the seats or upholstery of
the seats with side airbags. Such change may
prevent the side airbag system from activating
correctly, disable the system, or cause the side
airbags to inflate accidentally, resulting in death or
serious injury.

AIR CONDITIONING
202
AUTOMATIC AIR CONDITIONING CONTROLS
20X017e
You can adjust the brightness of the display. See
“Instrument panel light control” on page 66 for details.
The automatic air conditioning automatically maintains
the set temperature.
This air conditioning features automatic fan speed and air flow
control which automatically se lects the most suitable fan
speed and air flow to control the temperature. The ignition key
must be in the “ON” position.NOTICE
To prevent the battery from being discharged, do not
leave the air conditioning on longer than necessary
when the engine is not running.

AIR CONDITIONING
206SETTING OPERATION manual control
When one of the manual control buttons is depressed
while operating in automatic mode, the mode relevant to
the depressed button is set. Other conditions continue to
be adjusted automatically.
If manual air flow selection is desired
20X021a
The outlets from which air is delivered can be selected
manually by pressing the button. The function of each mode
is as follows:
1
Panel − Air flows mainly from the instrument panel vents.
2
Bilevel − Air flows from both the floor vents and the
instrument panel vents.
3 Floor − Air flows mainly from the floor vents.
It is recommended that you close the lower vent. For details
about this, see page 212.
4 Floor/Windshield − Air flows mainly from the floor vents
and windshield vents.
It is recommended that you close the lower vent. For details
about this, see page 212.
If quick heating or cooling is desired
Turn the “TEMP” knob until “MAX. HOT” or “MAX. COLD”
appears on the display.
If manual fan speed control is desired
21x600
 1 Fan speed at low 2Fan speed at high
The fan speed can be set to your desired speed by pushing the
appropriate side of fan speed control button. The higher the
fan speed is, the more air is delivered. Pushing the “OFF”
button turns off the fan.
To remove exterior windshield frost, use the high speed
setting.

AUDIO
218
AUDIO SYSTEM
Quick reference for your audio system
22X611a
You can adjust the brightness of the display. See “Instrument panel light control” on page 66 for details.

STARTING AND DRIVING
273
While the
system is on, pushing the knob turns off the “MAIN”
indicator light and the system. If you turn the ignition off with
the system turned on, the system will be turned off
automatically.
CAUTION
If the image in the headup display (night view display)
is too bright, you cannot see the surroundings through
the windshield clearly. To avoid glare, do not make the
display brighter than necessary.
31x533c
 1 Nearinfrared floodlight (Night view projector)
2Nearinfrared camera (Night view camera)
3Headup display (Night view display)
4Automatic light control sensor
The nearinfrared floodlight (night view projector which
irradiates nearinfrared light not seen by people) located
near the fog lights irradiates the area reaching from the tip
of the low beam to high beam. The nearinfrared camera
(night view camera) located on top of the windshield
converts irradiated light into an image. This image is
shown on the headup display (night view display)
located on the bottom of the windshield.
The automatic light control sensor is on top of the passenger
side instrument panel.
Do not place anything on the instrument panel and do not affix
anything on the windshield to block this sensor.

DRIVING TIPS
330
Never allow anyone to ride in the luggage
compartment. It is not designed for
passengers. They should ride in their seats
with their seat belts properly fastened.
Otherwise, they are much more likely to suffer
serious bodily injury, in the event of sudden
braking or a collision.
 Do not drive with objects left on top of the
instrument panel. They may interfere with the
driver’s field of view. Or they may move during
sharp vehicle acceleration or turning, and
impair the driver’s control of the vehicle. In an
accident they may injure the vehicle occupants.
NOTICE
Do not load the vehicle beyond the vehicle
capacity weight specified on the tire pressure
label.
Capacity and distribution
Cargo capacity depends on the total weight of the
occupants.
(Cargo capacity) = (Total load capacity) – (Total weight
of occupants)
Steps for Determining Correct Load Limit –
(1) Locate the statement “The combined weight of
occupants and cargo should never exceed XXX kg or
XXX lbs.” on your vehicle’s placard.
(2) Determine the combined weight of the driver and
passengers that will be riding in your vehicle.
(3) Subtract the combined weight of the driver and
passengers from XXX kg or XXX lbs.
(4) The resulting figure equals the available amount of
cargo and luggage load capacity. For example, if the
“XXX” amount equals 1400 lbs. and there will be five 150
lb passengers in your vehicle, the amount of available
cargo and luggage load capacity is 650 lbs. (1400 – 750
(5 x 150) = 650 lbs.)
(5) Determine the combined weight of luggage and
cargo being loaded on the vehicle. That weight may not
safely exceed the available cargo and luggage load
capacity calculated in Step 4.