CHASSIS
420– STEERING
Free play
Less than 40 mm (1.6 in.)
Power steering fluidAutomatic transmission fluid DEXRONII or III
– SUSPENSION
Fluid type
Suspension fluid AHC
– TIRES AND WHEELS
Tire sizeP275/60R18 111H
Tire inflation pressure
Recommended cold tire inflation pressure
Normal driving
Trailer towing
Front 200 kPa (2.0 kgf/cm2 or bar, 29 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Spare 220 kPa (2.2 kgf/cm2 or bar, 32 psi)
Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 240 kPa (2.4 kgf/cm2 or bar, 35 psi)
Spare 240 kPa (2.4 kgf/cm2 or bar, 35 psi)
Wheel size18 x 8J
Wheel nut torque131 N·m (13.4 kgf·m, 97 ft·lbf.)
NOTE:
For complete information on tires (e.g. replacing tires or replacing wh\
eels), see “Checking tire inflation pressure”
through “Aluminum wheel precautions” on page 424 through 443.
CHASSIS
422
CHECKING POWER STEERINGFLUID
63X002a
Check the fluid level on the dipstick. If necessary, add
automatic transmission fluid DEXRONII or III .
If the vehicle has been driven around 80 km/h (50 mph) for 20
minutes (a little more in frigid temperatures), the fluid is hot
(60 C − 80C or 140F − 175F). You may also check the level
when the fluid is cold (about room temperature, 10 C − 30C
or 50F − 85F) if the engine has not been run for about five
hours.
63X003a
1 If hot O.K. 2If hot add 3If cold O.K.
4If cold add
Clean all dirt off the reservoir and look at the fluid level. If the
fluid is cold, the level should be in the “COLD” range. Similarly,
if it is hot, the fluid level should be in the “HOT” range. If th\
e
level is at the low side of the appropriate range, add automatic
transmission fluid DEXRON
II or III to bring the level within
the range.
To remove the reservoir cap, turn it counterclockwise and lift
up. To reinstall it, turn it clockwise. After replacing the reservoir
cap, visually check the steering box case, vane pump and hose
connections for leaks or damage.
CAUTION
The reservoir may be hot so be careful not to burn
yourself.
