steering LEXUS LX570 2014 Owner's Manual

811-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L21U_(U) * : A warning will be shown on the multi-in formation display in the instrument clus-
ter.Indicator light and
buzzer Situation Correction procedure
Indicator light flashes Any of the tumbling or
return switch is pushed
when shift lever is not in
the “P” position with the
“ENGINE START
STOP” switch in IGNI-
TION ON mode. Move the shift lever in
the “P” position with the
“ENGINE START
STOP” switch in IGNI-
TION ON mode.
Indicator light flashes
3 times Table mode switch is
pushed when shift lever
is not in the “P” position
with the “ENGINE
START STOP” switch in
IGNITION ON mode.

821-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L21U_(U) CAUTION■
Seat adjustment
Do not recline the seat more than necessary when the vehicle is in motion to reduce
the risk of sliding under the lap belt.
If the seat is too reclined, during an accide nt the lap belt may sl ide past the hips and
apply restraint forces directly to the abdomen or your neck may contact the shoul-
der belt, increasing the risk of death or serious injury. ■
When the seatback is folded ●
Do not sit on or place anything on the seatback while driving. ●
Be sure to install the seat hook covers on the seat hooks, or you may get burned
when they become hot.■
When returning the seatbacks to their original position
Observe the following precautions. Failure to do so may result in death or serious
injury. ●
Be careful not to get your hands or feet pinched in the seat. ●
Make sure the seats are securely locked. Fa ilure to do so will prevent the seat belt
from operating properly. ●
Check that the seat belts are not twisted or caught under the seat.●
Arrange the seat belts in the proper positions for ready use.■
Avoiding damage to seat components
Do not hang or attach anythi ng on the seatback striker.
NOTICE■
Before tumbling, folding up the seats
The seat belts and buckles must be stowed. ■
After returning the third seat
Make sure that the handle on the re ar of the seatback has been secured.

8311-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
LX570_OM_OM60L21U_(U) Driving position memory system Your preferred driving position (the po sition of the driver’s seat, steering
wheel and outside rear view mirrors) can be entered into the computer’s
memory and recalled with the touch of a button. It is also possible to set this
function to activate automatica lly when the doors are unlocked.
Three different driving positions can be entered into memory.
■ Entering a position to memory
Turn the “ENGINE START STOP ” switch to IGNITION ON
mode.
Adjust the driver’s seat, steeri ng wheel, and outside rear view
mirrors to the desired positions.
While pressing the “SET” but-
ton, or within 3 seconds after
the “SET” button is pressed,
press and hold button “1”, “2” or
“3” until the signal beeps. If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
■ Recalling the memorized position
Check that the shift lever is set in “P”.
Turn the “ENGINE START STOP ” switch to IGNITION ON
mode.
Press button “1”, “2” or “3” to
recall the desired position.STEP 1
STEP 2
STEP 3
STEP 1
STEP 2

841-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L21U_(U) Linking driving position memory with door unlock operation
Record your driving position to butto n “1”, “2” or “3” before performing
the following:
Using the wireless remote control
Turn the “ENGINE START STOP” switch to OFF after closing the
driver’s door.
While pressing the desired button
(“1”, “2” or “3”), press on
the wireless remote control until
the signal beeps. The driving position is recalled
when the driver’s door is unlocked
using the entry function or wireless
remote control and the driver’s
door is opened.
To prevent unintended triggering of the alarm, open and close a door once after
a driving position has been recorded. (If a door is not opened within 60 seconds
after is pressed, the doors will be locked again and the alarm will auto-
matically be set.)
In case that the alarm is triggere d, immediately stop the alarm. (  P. 1 1 9 )STEP 1
STEP 2

851-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L21U_(U) Using the door lock switch
Carry only the key (including the ca rd key) to which you want to link
the driving position. If 2 or more keys are in the vehicle, the driving
position cannot be linked properly.
Turn the “ENGINE START STOP” switch to OFF after closing the
driver’s door.
While pressing the desired button
(“1”, “2” or “3”), press the lock or
unlock side on the door lock
switch (either the driver or passen-
ger side) until the signal beeps. The driving position is recalled
when the driver’s door is unlocked
using the enter function or wireless
remote control and the driver’s
door is opened.STEP 1
STEP 2
■
Canceling the linked do or unlock operation
Turn the “ENGINE START STOP” switch to OFF after closing the driver’s
door.
Using the wireless remote control: While pressing “SET” button, press
button on the wireless remote control until the signal beeps.
Using the door lock switch: While pressing “SET” button, press the lock or
unlock side on the door lock switch until the signal beeps.STEP 1
STEP 2

861-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L21U_(U) ■
Retained accessory power ●
Each memorized position (except for the steering wheel position) can be acti-
vated within 3 minutes after the driver’s door is opened, even if the “ENGINE
START STOP” switch is turned off. ●
Each memorized position (except for the steering wheel position) can be acti-
vated within 60 seconds after the driver’s door is closed, even if the “ENGINE
START STOP” switch is turned off.■
To cancel seat position recall
Perform any one of the following operations. ●
Press the “SET” button ●
Press button “1”, “2” or “3”. ●
Adjust the seat using the switches (only cancels seat position recall) ●
Adjust the steering wheel using the tilt and telescopic steering control switch
(only cancels steering wheel position recall) ■
If the battery is disconnected
The memorized positions must be reset because the computer’s memory is erased
when the battery is disconnected.
CAUTION■
Seat adjustment caution
Take care during seat adjustment that the seat does not strike the rear passenger or
squeeze your body against the steering wheel.

8711-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
LX570_OM_OM60L21U_(U) Head restraints Head restraints are provided for all seats.
Front seats
Vertical adjustment
Up
Down Push the head restraint up or
down while pressing the lock
release button.
Angle adjustment (if equipped)
Second seats
Vertical adjustment
Up Pull the head restraints up.
Down Push the head restraint down
while pressing the lock release
button.Lock release button
Lock release button

881-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L21U_(U) ■
Adjusting the height of the head restraints
■
Adjusting the second center seat head restraint
Always raise the head restraint one level from the stowed position when using.Third outboard seats
To fold Pull the head restraint angle
lever to fold the head restraint.
Make sure that the head restraints are
adjusted so that the center of the head
restraint is closest to the top of your ears.

891-3. Adjustable components (s eats, mirrors, steering wheel)
1
Before driving
LX570_OM_OM60L21U_(U) ■
Removing the head restraints
Front seats
While pressing in the flathead screwdriver, pull up the head restraint.
Second seats
Third center seat
Third outboard seats
The head restraint cannot be removed.■
Installing the head restraints (except third outboard seats)
Align the head restraint with the installation holes.
Push down the head restra int to the lock position. Push a flathead screwdriver into the slot. The
slot is located on the right side of the right
head restraint anchor.STEP 1
STEP 2
Pull the head restraint up while pressing the
lock release button.
Lock release button
Pull the head restraint up while pressing the
lock release button.Lock
release
button
STEP 1
STEP 2

901-3. Adjustable components (s eats, mirrors, steering wheel)
LX570_OM_OM60L21U_(U) ■
When not using the third center seat head restraint
CAUTION■
Head restraint precautions
Observe the following precautions regarding the head restraints. Failure to do so
may result in death or serious injury. ●
Use the head restraints design ed for each respective seat.●
Adjust the head restraints to the correct position at all times. ●
After adjusting the head restraints, push down on them and make sure they are
locked in position. ●
Do not drive with the head restraints removed. Open the zipper on the back of the third seat
and stow the head restraint inside.