ECO mode LEXUS RX200T 2017 Owners Manual

8
RX350/RX200t_EE_OM48F32E
Please note that this manual applies to all models and explains all equipment, including options. Therefore, you may find some expl anations for equipment not installed on your vehicle.
All specifications provided in this manual are current at the time of printing. However, because of the Lexus policy of continual pr oduct improvement, we reserve the right to make changes at any time without notice.
Depending on specifications, the vehicle sh own in the illustrations may differ from your vehicle in terms of color and equipment.
Both genuine Lexus and a wide variety of other spare parts and accessories for Lexus vehicles are currently available in the market. Should it be determined that any of the
genuine Lexus parts or accessories supplied wi th the vehicle need to be replaced, Lexus recommends that genuine Lexus parts or acce ssories, be used to replace them. Other parts or accessories of matching quality can also be used.
Lexus cannot accept any liability or guarantee spare parts and accessories which are not genuine Lexus products, nor for replacement or installation involving such parts. In addi- tion, damage or performance problems re sulting from the use of non-genuine Lexus
spare parts or accessories may not be covered under warranty.
The installation of an RF-transmitter system in your vehicle could affect electronic sys- tems such as:
●Multiport fuel injection system/seque ntial multiport fuel injection system
●Dynamic radar cruise control with full-speed range
●Cruise control system
●Anti-lock brake system
●Vehicle dynamics integrated management
●SRS airbag system
●Seat belt pretensioner system
Be sure to check with any authorized Lexus de aler or repairer, or another duly qualified and equipped professional for precautionary measures or special instructions regarding
installation of an RF-transmitter system.
Further information regarding frequency ba nds, power levels, antenna positions and installation provisions for the installation of RF-transmitters, is available on request at any
authorized Lexus dealer or repairer, or anot her duly qualified and equipped professional.
For your information
Main Owner’s Manual
Accessories, spare parts and modification of your Lexus
Installation of an RF-transmitter system

331-1. For safe use
1
For safety and security
RX350/RX200t_EE_OM48F32E
WARNING
Observe the following precautions. Failure to do so may cause the driver’s floor mat to slip, possibly interfering with the ped-als while driving. An unexpect edly high speed may result or it may become difficult to
stop the vehicle. This could lead to an acci dent, resulting in death or serious injury.
■When installing the driver’s floor mat
●Do not use floor mats designed for other models or different model year vehicles,
even if they are Lexus Genuine floor mats.
●Only use floor mats designed for the driver’s seat.
●Always install the floor mat securely us ing the retaining hooks (clips) provided.
●Do not use two or more floor mats on top of each other.
●Do not place the floor mat bottom-side up or upside-down.
■Before driving
●Check that the floor mat is securely fixed in the correct place with all the provided retain-
ing hooks (clips). Be especially careful to per- form this check after cleaning the floor.
●With the engine stopped and the shift lever in
P, fully depress each pedal to the floor to make sure it does not interfere with the floormat.

631-2. Child safety
1
For safety and security
RX350/RX200t_EE_OM48F32E
◆Child restraint system suitability table (Installed using seat belts)
If your child restraint system is of “universal” category, you can install it on the
positions mentioned by U or UF in the table below (UF is for forward-facing
child restraint systems only). Child re straint systems category and mass group
can be found in the child restraint system manual.
If your child restraint system is not of the “universal” category (or if you cannot
find information in the table below), please refer to the child restraint system
“vehicle list” for compatibility information or ask the retailer of your child seat.
Except F SPORT models
Mass groups
Seating position
Recommended Child Restraint Systems
Front passenger seatRear seat
Airbag manual on-off switchOut-boardCenter
ONOFF
0
Up to 10 kg (22 lb.)
X U*1 L*1UL X “LEXUS G 0+, BABYSAFE PLUS”
“LEXUS MINI” “LEXUS G 0+, BABYSAFEPLUS with SEAT BELT FIX-
ATION, BASE PLATFORM”
0+
Up to 13 kg (28 lb.)
X U*1 L*1UL X
I
9 to 18 kg (20 to
39 lb.)
Rear-
ward- facing — X U*1, 2U*2X—
Forward-
facing —
UF*1, 2
II, III 15 to 36 kg
(34 to 79 lb.)
UF*1, 2U*1 , 2U*2X “LEXUS KIDFIX XP SICT” (Can be fitted to the vehicle’s
ISOFIX mountings.)

641-2. Child safety
RX350/RX200t_EE_OM48F32E
F SPORT models
Mass
groups
Seating position
Recommended
Child Restraint Systems
Front passenger seatRear seat
Airbag manual
on-off switchOut-
boardCenter
ONOFF
0 Up to 10 kg
(22 lb.)
X U*1 L*1UL X “LEXUS G 0+, BABYSAFE
PLUS” “LEXUS MINI”“LEXUS G 0+, BABYSAFE
PLUS with SEAT BELT FIX- ATION, BASE PLATFORM”
0+ Up to 13 kg
(28 lb.)
X U*1 L*1UL X
I 9 to 18 kg
(20 to 39 lb.)
Rear- ward-facing —
X U*1, 2U*2X—
Forward- facing —
UF*1, 2
II, III 15 to
36 kg (34 to79 lb.)
UF*1, 2U*1 , 2U*2X—

922. Instrument cluster
RX350/RX200t_EE_OM48F32E
*1: These lights turn on when the engine switch is turned to IGNITION ON mode to
indicate that a system check is being performed. They will turn off after the engine is
started, or after a few seconds. There may be a malfunction in a system if a light does
not come on, or turn off. Have the vehicle inspected by any authorized Lexus dealer
or repairer, or another duly qualified and equipped professional.
*2: When the start-up display is displayed on the multi-information display, this light may
not turn on even though the engine swit ch has been turned to IGNITION ON mode.
*3: The light flashes to indicate a malfunction.
*4: This light illuminates on the center panel.
The indicators inform the driver of the operating state of the vehicle’s various sys-
tems.
Indicators
Turn signal indicator ( P. 258)
Cruise control “SET”
indicator ( P. 329, 341)
Tail light indicator
( P. 265)(if equipped)
LKA indicator (P. 313)
Headlight high beam indicator ( P. 265)(if equipped)
LKA indicator (P. 313)
*1
(if equipped)
Automatic High Beam
indicator ( P. 274) Adaptive High-beam System indicator ( P. 269)
*5
(if equipped)
LKA indicator (P. 313)
Front fog light indicator ( P. 278)

(if equipped)
Lexus parking
assist-sensor indicator ( P. 371)
Rear fog light indicator
( P. 278)
*1, 6
(if equipped)
ICS OFF indicator
( P. 383)
Cruise control indicator
( P. 329, 341)(if equipped)
“BSM” indicator (P. 355)
(if equipped)
Radar cruise control indicator ( P. 329) (if equipped)
“RCTA” indicator ( P. 355)

932. Instrument cluster
2
Instrument cluster
RX350/RX200t_EE_OM48F32E
*3, 4
(if equipped)
BSM outside rear view
mirror indicators
(  P. 355)*1
Brake hold operated
indicator ( P. 263)
*1, 5
Slip indicator
(  P. 424)
(if equipped)
Gear Shift Indicator
(  P. 254)
*1, 6
VSC OFF indicator
(  P. 425)*1Eco Driving Indicator Light
(  P. 120)
*1, 6
(if equipped)
PCS warning light
(  P. 304)
*7
Security indicator
(  P. 77, 83)
*1, 2
(if equipped)
Stop & Start indicator
(  P. 345)
*1
(AWD
models only)
All-wheel drive lock
indicator ( P. 421)
*1, 2, 6
(if equipped)
Stop & Start cancel
indicator ( P. 348)
*8
Low outside temperature
indicator ( P. 96)
Parking brake indicator
(  P. 259)
*1, 7“PASSENGER AIR BAG”
indicator ( P. 51)
*1
Brake hold standby
indicator ( P. 263)

942. Instrument cluster
RX350/RX200t_EE_OM48F32E
●Drive mode indicators
Except F SPORT models
F SPORT models
*1: These lights turn on when the engine switch is turned to IGNITION ON mode to indicate that a system check is being performed. They will turn off after the engine is
started, or after a few seconds. There may be a malfunction in a system if a light does
not come on, or turn off. Have the vehicle inspected by any authorized Lexus dealer
or repairer, or another duly qualified and equipped professional.
*2: When the start-up display is displayed on the multi-information display, this light may
not turn on even though the engine swit ch has been turned to IGNITION ON mode.
*3: In order to confirm operation, the BSM outside rear view mirror indicators illuminate
in the following situations:
• When the BSM function is enabled on of the multi-information display, the
engine switch is turned to IGNITION ON mode.
• When the engine switch is in IGNITION ON mode, the BSM function is enabled
on of the multi-information display.
If the system is functioning correctly, the BSM outside rear view mirror indicators will
turn off after a few seconds.
If the BSM outside rear view mirror indicators do not illuminate or do not turn off,
there may be a malfunction in the system.
If this occurs, have the vehicle inspected by any authorized Lexus dealer or repairer,
or another duly qualified and equipped professional. Eco drive mode indicator
(  P. 417)
(if equipped)
“SPORT” indicator
(  P. 417)
(if equipped)
“SPORT S” indicator
(  P. 417)
(if equipped)
“SPORT S+” indicator
(  P. 417)
(if equipped)
“Customize” indicator
(  P. 417)
Eco drive mode indicator
(  P. 417) “SPORT S” indicator
(  P. 417)
“SPORT S+” indicator
(  P. 417) “CUSTOMIZE” indicator
(  P. 417)

982. Instrument cluster
RX350/RX200t_EE_OM48F32E
■Rev indicator (F SPORT models)
When the engine reaches a set
speed, a ring-shaped indicator will
be displayed on the tachometer.
The desired engine speed at which the Rev indicator will begin to be dis-
played can be set on of the multi-
information display. ( P. 110)
■Rev peak (F SPORT models)
The engine speed reaches or
exceeds 5000 rpm, an afterimage
of the tachometer will be displayed
at the highest engine speed for
approximately 1 second.
The brightness of the instrument panel lights can be adjusted.
Darker
Brighter
The brightness of the instrument panel lights can be adjusted individually for
day mode and night mode*.
*: Day mode and night mode: P. 99
Instrument panel light control
1
2

1182. Instrument cluster
RX350/RX200t_EE_OM48F32E
◆Display items
■Odometer
Displays the total distance the vehicle has been driven.
■Trip meter A/trip meter B
Displays the distance the vehicle has been driven since the meter was last
reset. Trip meters A and B can be used to record and display different dis-
tances independently.
To reset, display the desired trip meter and press and hold the “ODO/TRIP”
switch.
■ Distance until next engine oil change
Displays the distance the vehicle can be driven until an oil change is neces-
sary.
◆Pop-up display
In some situations the following will be temporarily displayed:
■ Stop & Start system operation time (current) (if equipped)
This display will be displayed when the engine is stopped due to the operation
of the Stop & Start system.
■ Distance until next engine oil change
Displays the distance until the next engine oil change. This display will be dis-
played in the following situations:
• When the engine switch is turned to IGNITION ON mode.
• When a warning message indicating that oil maintenance should be performed
soon or is required is displayed.
◆Speed warning
When set to on, the vehicle speed at which the speed warning will start oper-
ating will be displayed. If the vehicle exceeds the set speed, the speed display
will flash and a buzzer will sound.
• To display the odometer, etc. while the speed warning is set to on, press the “ODO/ TRIP” switch. (If the switch has not been operated for a certain amount of time, the
speed warning will be displayed.)
• The speed at which the speed warning w ill start operating can be changed on .
(  P. 110)
Odometer/trip meter display area

1202. Instrument cluster
RX350/RX200t_EE_OM48F32E
■Eco Driving Indicator
Eco Driving Indicator will not operate under the following conditions:
●The shift lever is in any position other than D.
●A paddle shift switch (if equipped) is operated.
●Sport mode is selected.
●The vehicle speed is approximately 130 km/h (80 mph) or higher.
■Background color of the indicator/shift position display area (except F SPORT models)
The background color of the indicator/shift position display area is changed according to the driving mode as follows ( P. 417):
●Eco drive mode: Blue
●Sport mode: Red
■G-force display (if equipped)
●The G-force values may not be zero even when the vehicle is parked, such as when it is parked on an incline.
●Depending on the vehicle usage conditions, the brake fluid pressure display may not
reach its maximum reading even though the brake pedal is fully depressed.
●If a battery terminal is disconnected and reconnected, the steering amount display may be disabled temporarily. After driving the ve hicle for a while, the display will be enabled.
■Suspension of the settings display
●Some settings cannot be changed while driving. When changing settings, park the vehicle in a safe place.
●If a warning message is displayed, operation of the settings display will be suspended.
Eco Driving Indicator Light During Eco-friendly acceleration (Eco driv-
ing), the Eco Driving In dicator Light will turn on. When the acceleration exceeds the Zoneof Eco driving, or when the vehicle is stopped,
the light turns off.
Eco Driving Indicator Zone Display Suggests the Zone of Eco driving with current
Eco driving ratio based on acceleration.
Eco driving ratio based on acceleration
If the acceleration exceeds the Zone of Eco
driving, the right side of the Eco Driving Indi- cator Zone Display will illuminate.
Zone of Eco driving
1
2
3
4