engine LEXUS RX270 2014 Owners Manual

486
4-3. Do-it-yourself maintenance
RX350/270_EEPress and hold the tire pressure
warning reset switch until the tire
pressure warning light blinks
slowly 3 times.
Wait for a few minutes in “ENGINE START STOP” switch to on,
and then turn the “ENGINE START STOP” switch off.
Registering ID codes
The tire pressure warning valve and transmitter is equipped with a unique
ID code. When replacing a tire pressure warning valve and transmitter, it
is necessary to register the ID code. Have the ID code registered by any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional.
STEP4
STEP5
RX350_270_EE_48D77E.book 486 ページ ２０１４年１月２４日　金曜日　午前１０時４分

488
4-3. Do-it-yourself maintenance
RX350/270_EE
■The initialization operation
●Make sure to carry out initialization after adjusting the tire inflation pressure.
Also, make sure the tires are cold before carrying out initialization or tire infla-
tion pressure adjustment.
●If you have accidentally turned the “ENGINE START STOP” switch off during
initialization, it is not necessary to press the reset switch again as initialization
will restart automatically when the “ENGINE START STOP” switch has been
turned to IGNITION ON mode for the next time.
●If you accidentally press the reset switch when initialization is not necessary,
adjust the tire inflation pressure to the specified level when the tires are cold,
and conduct initialization again.
■Warning performance of the tire pressure warning system
The warning of the tire pressure warning system will change in accordance with
driving conditions. For this reason, the system may give a warning even if the tire
pressure does not reach a low enough level, or if the pressure is higher than the
pressure that was adjusted to when the system was initialized.
■When initialization of the tire pressure warning system has failed
Initialization can be completed in a few minutes. However, in the following cases,
the settings have not been recorded and the system will not operate properly. If
repeated attempts to record tire inflation pressure settings are unsuccessful, have
the vehicle inspected by any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional.
●When operating the tire pressure warning reset switch, the tire pressure warn-
ing light does not blink 3 times.
●After carrying out the initialization procedure, the tire pressure warning light
blinks for 1 minute then stays on after driving for 10 minutes.
RX350_270_EE_48D77E.book 488 ページ ２０１４年１月２４日　金曜日　午前１０時４分

499
4-3. Do-it-yourself maintenance
4
Maintenance and care
RX350/270_EE
Air conditioning filter
The air conditioning filter must be changed regularly to maintain air condi-
tioning efficiency.
■Removal method
Turn the “ENGINE START STOP” switch off.
Open the glove box. Lift and
remove the partition.
Remove the glove box cover.
Remove the filter cover.
STEP1
STEP2
STEP3
STEP4
RX350_270_EE_48D77E.book 499 ページ ２０１４年１月２４日　金曜日　午前１０時４分

504
4-3. Do-it-yourself maintenance
RX350/270_EE
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown.
If this happens, check and replace the fuses as necessary.
Turn the “ENGINE START STOP” switch off.
After a system failure, see “Fuse layout and amperage ratings”
for details about which fuse to check. (→P. 507)
Remove the engine compartment cover. (→P. 4 7 0 )
Open the fuse box cover.
Engine compartment
Push the tab in and lift the lid off.
Driver’s side instrument panel
Remove the lid.STEP1
STEP2
STEP3
STEP4
RX350_270_EE_48D77E.book 504 ページ ２０１４年１月２４日　金曜日　午前１０時４分

507
4-3. Do-it-yourself maintenance
4
Maintenance and care
RX350/270_EE
Fuse layout and amperage ratings
■Engine compartment
FuseAmpereCircuit
1RDI FAN NO. 180 AElectric cooling fans
2RR DEF50 ARear window defogger
3AIR SUS50 AElectronically modulated air suspen-
sion
4HEATER50 AAir conditioning system
5SPARE30 A
6SPARE40 A
7ABS NO. 230 AVehicle stability control
8H-LP CLN30 AHeadlight cleaner
9PBD30 APower back door
10ST30 AStarter system
11PD50 A
A/F, H-LP RH HI, H-LP LH LO, H-LP
RH LO, H-LP LH HI, HORN, S-
HORN, EFI MAIN NO. 2
RX350_270_EE_48D77E.book 507 ページ ２０１４年１月２４日　金曜日　午前１０時４分

516
4-3. Do-it-yourself maintenance
RX350/270_EE
Light bulbs
You may replace the following bulbs by yourself. The difficulty level of
replacement varies depending on the bulb. If necessary bulb replacement
seems difficult to perform, contact any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
For more information about replacing other light bulbs, contact any autho-
rized Lexus dealer or repairer, or another duly qualified and equipped pro-
fessional.
■Preparing for light bulb replacement
Check the wattage of the light bulb to be replaced. (→P. 6 1 9 )
■Removing the engine compartment covers
→P. 4 7 0
■Turning off the power back door main switch (if equipped).
→P. 6 2
■Front bulb locations
Vehicles with halogen headlights
Headlight high beam Headlight low beam
Front turn signal light
Front fog light
RX350_270_EE_48D77E.book 516 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5When trouble arises
531
RX350/270_EE
5-1. Essential information
Emergency flashers .............. 532
If your vehicle needs to
be towed ................................ 533
If you think something
is wrong ................................... 541
Fuel pump shut off
system..................................... 5425-2. Steps to take in an
emergency
If a warning light turns
on or a warning buzzer
sounds... ................................ 543
If a warning message is
displayed ................................ 552
If you have a flat tire ............... 572
If the engine will not
start.......................................... 587
If the shift lever cannot be
shifted from P....................... 589
If you lose your keys .............. 590
If the electronic key
does not operate
properly ................................... 591
If the vehicle battery is
discharged ............................. 594
If your vehicle
overheats .............................. 598
If the vehicle becomes
stuck ......................................... 601
If your vehicle has to
be stopped in an
emergency ............................ 603
RX350_270_EE_48D77E.book 531 ページ ２０１４年１月２４日　金曜日　午前１０時４分

532
RX350/270_EE
5-1. Essential information
Emergency flashers
■Emergency flashers
If the emergency flashers are used for a long time while the engine is not operating,
the battery may discharge.
The emergency flashers are used to warn other drivers when the vehicle
has to be stopped in the road due to a breakdown, etc.
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch
once again.
RX350_270_EE_48D77E.book 532 ページ ２０１４年１月２４日　金曜日　午前１０時４分

5
533
5-1. Essential information
When trouble arises
RX350/270_EE
If your vehicle needs to be towed
Situations needs to contact dealers before towing
The following may indicate a problem with your transmission. Contact
any authorized Lexus dealer or repairer, before towing.
●The engine is running but the vehicle will not move.
●The vehicle makes an abnormal sound.
If towing is necessary, we recommend having your vehicle towed by any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional, or a commercial towing service, using a lift-type
truck or flatbed truck.
Use a safety chain system for all towing, and abide by all state/provincial
and local laws.
2WD models: If towing your vehicle with a wheel-lift type truck from the
front, the vehicle's rear wheels and axles must be in good conditions.
(→P. 534, 539)
If they are damaged, use a towing dolly or flatbed truck.
AWD models: If towing your vehicle with a wheel-lift type truck, use a tow-
ing dolly. (→P. 5 3 4 , 5 3 9 )
RX350_270_EE_48D77E.book 533 ページ ２０１４年１月２４日　金曜日　午前１０時４分

538
5-1. Essential information
RX350/270_EESecurely attach a cable or chain to the towing eyelet.
Take care not to damage the vehicle body.
Enter the vehicle being towed and start the engine.
If the engine does not start, turn the “ENGINE START STOP” switch to
IGNITION ON mode.
For models with electronically modulated air suspension: Change
the vehicle height to “N” mode and end the vehicle height opera-
tion. (
→P. 2 5 6 )
Shift the shift lever to N and release the parking brake.
When the shift lever cannot be shifted: →P. 589
■While towing
If the engine is not running, the power assist for the brakes and steering will not
function, making steering and braking more difficult.
■Wheel nut wrench
Wheel nut wrench is installed in the luggage compartment. (→P. 5 7 2 )
STEP5
STEP6
STEP7
STEP8
RX350_270_EE_48D77E.book 538 ページ ２０１４年１月２４日　金曜日　午前１０時４分