ECO LEXUS RX270 2014 User Guide

61
1-2. Opening, closing and locking the doors
1
Before driving
RX350/270_EE
Power back door switch (vehicles with a power back door)
Press the switch to close the back
door.
Pressing the switch again while the
power back door is closing will
cause it to open again.
However, the reverse operation
cannot be performed for the first
second after automatic operation
starts even if the switch is pressed
again.
When closing the back door
Lower the back door using the
back door handle, and make sure
to push the back door down from
the outside to close it.
RX350_270_EE_48D77E.book 61 ページ ２０１４年１月２４日　金曜日　午前１０時４分

65
1-2. Opening, closing and locking the doors
1
Before driving
RX350/270_EE
■If the back door opener is inoperative
The back door can be opened from the inside.
Move the lever.
Vehicles without a power back door
Vehicles with a power back door
■When reconnecting the battery or changing a fuse while the back door is open:
To enable the power back door to operate properly, initialize the system by com-
pletely closing the back door manually. If the battery is reconnected or a fuse is
changed while the back door is closed, initializing the system is not necessary.Remove the cover.
STEP1
STEP2
RX350_270_EE_48D77E.book 65 ページ ２０１４年１月２４日　金曜日　午前１０時４分

68
1-2. Opening, closing and locking the doors
RX350/270_EE
CAUTION
●Do not pull on the back door damper stay to close the back door, and do not
hang on the back door damper stay.
Doing so may cause hands to be caught or the back door damper stay to break,
causing an accident.
●If a bicycle carrier or similar heavy object is attached to the back door, it may sud-
denly shut again after being opened, causing someone’s hands, head or neck to
be caught and injured. When installing an accessory part to the back door, using
a genuine Lexus part is recommended.
■Back door closer
●Use caution when using the back door closer as it still operates when the power
back door system is cancelled.
●In the event that the back door is left slightly
open, the back door closer will automati-
cally close it to the fully closed position. It
takes several seconds before the back
door closer begins to operate. Be careful
not to catch fingers or anything else in the
back door, as this may cause bone frac-
tures or other serious injuries.
RX350_270_EE_48D77E.book 68 ページ ２０１４年１月２４日　金曜日　午前１０時４分

69
1-2. Opening, closing and locking the doors
1
Before driving
RX350/270_EE
CAUTION
■Power back door
Observe the following precautions when operating the power back door.
Failure to do so may cause death or serious injury.
●Check the safety of the surrounding area to make sure there are no obstacles or
anything that could cause any of your belongings to get caught.
●If anyone is in the vicinity, make sure they are safe and let them know that the back
door is about to open or close.
●If the power back door system is turned off with the main switch while the back
door is operating automatically, the automatic operation is stopped. The back
door then has to be operated manually. Take extra care when on an incline, as the
back door may open or close unexpectedly.
●If the operating conditions of the power back door are no longer met, a buzzer
may sound and the back door may stop opening or closing. The back door then
has to be operated manually. Take extra care when on an incline, as the back door
may open or close abruptly.
●On an incline, the back door may suddenly shut after it opens. Make sure the
back door is fully open and secure.
●In the following situations, the power back door may detect an abnormality and
automatic operation may be stopped. In this case, the back door has to be oper-
ated manually. Take extra care when on an incline, as the back door may open or
close abruptly.
• When the back door contacts an obstacle
• When the battery voltage suddenly drops, such as when the “ENGINE
START STOP” switch is turned to IGNITION ON mode or the engine is
started during automatic operation
●If a bicycle carrier or similar heavy object is attached to the back door, the power
back door may not operate, causing itself to malfunction, or the back door may
suddenly shut again after being opened, causing someone’s hands, head or neck
to be caught and injured. When installing an accessory part to the back door,
using a genuine Lexus part is recommended.
RX350_270_EE_48D77E.book 69 ページ ２０１４年１月２４日　金曜日　午前１０時４分

70
1-2. Opening, closing and locking the doors
RX350/270_EE
CAUTION
■Jam protection function
Observe the following precautions.
Failure to do so may cause death or serious injury.
●Be careful while the jam protection function is operating. Being hit by the back
door may result in an injury.
●Although the back door stops closing when the jam protection function detects
an object, take extra care as you may still be injured if part of your body is already
caught.
●If anything obstructs the power back door while it is closing, the jam protection
function will cause the back door to automatically operate in the opposite direc-
tion. However, be careful not to jam body parts in the doorframe, as an injury may
result.
●Never use any part of your body to intentionally activate the jam protection func-
tion.
●The jam protection function may not work if something gets caught just before
the back door fully closes. Be careful not to catch fingers or anything else.
●The jam protection function may not work depending on the shape of the object
that is caught. Be careful not to catch fingers or anything else.
●The sensors located on the right and left sides of the power back door detect
obstructions and prevent them from becoming jammed in the door. Some objects
may not be detected depending on their shape or how they are jammed. Be care-
ful not to get fingers or other body parts caught in the back door while it is oper-
ating as this may result in a serious injury.
RX350_270_EE_48D77E.book 70 ページ ２０１４年１月２４日　金曜日　午前１０時４分

80
1-3. Adjustable components (seats, mirrors, steering wheel)
RX350/270_EE
CAUTION
■After returning the rear seatback to the upright position
Observe the following precautions.
Failure to do so may result in death or serious injury.
●Make sure the seatback is securely locked by pushing it forward and rearward on
the top.
●Check that the seat belts are not twisted or caught in the seatback.
NOTICE
■Stowing the center seat belt buckle
Before folding down the rear seatbacks, stow the center seat belt buckle to prevent
it from becoming caught in the seatbacks.
RX350_270_EE_48D77E.book 80 ページ ２０１４年１月２４日　金曜日　午前１０時４分

81
1
1-3. Adjustable components (seats, mirrors, steering wheel)
Before driving
RX350/270_EE
Driving position memory∗
Your preferred driving position (the position of the driver's seat, steering
wheel and outside rear view mirrors) can be memorized and recalled with
the touch of a button. It is also possible to set this function to activate auto-
matically when the doors are unlocked.
Three different driving positions can be entered into memory.
On some models, the same buttons are found on the front passenger’s side,
allowing the position of the front passenger’s seat to be memorized.
■Entering a position to memory
Turn the “ENGINE START STOP” switch to IGNITION ON
mode.
Adjust the driver’s seat, steering wheel and outside rear view
mirrors to the desired positions.
Press the “SET” button, then
within 3 seconds press button
“1”, “2” or “3” until the signal
beeps.
If the selected button has
already been preset, the previ-
ously recorded position will be
overwritten.
STEP1
STEP2
STEP3
∗: If equipped
RX350_270_EE_48D77E.book 81 ページ ２０１４年１月２４日　金曜日　午前１０時４分

83
1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
RX350/270_EE
Linking driving position memory with door unlock operation (driver’s side only)
Record your driving position to button “1”, “2” or “3” before performing
the following.
Carry only the key (including the card key) to which you want to link the
driving position. If 2 or more keys are in the vehicle, the driving position
cannot be linked properly.
Shift the shift lever to P and close the driver's door. Turn the
“ENGINE START STOP” switch to IGNITION ON mode.
Press the desired button (“1”, “2” or
“3”) to recall the position. Then,
while keep pressing the button,
press the driver's door lock
switches (either lock or unlock)
until the signal beeps.
The driving position is recalled
when the driver's door is unlocked
using the entry function or wireless
remote control and the driver's
door is opened.
STEP1
STEP2
RX350_270_EE_48D77E.book 83 ページ ２０１４年１月２４日　金曜日　午前１０時４分

85
1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
RX350/270_EE
■When driving position memory is linked with door unlock operation
If the driver’s door is opened, the driver’s seat will move toward the memorized
position but stop slightly beforehand to allow easy access to the vehicle.
Turning the “ENGINE START STOP” switch to ACCESSORY mode or fastening
the driver’s seat belt moves the seat fully into the memorized position.
■Canceling the linked door unlock operation
Turn the “ENGINE START STOP” switch to IGNITION ON mode and
close the driver's door.
While pressing the “SET” button, press the driver’s door lock switches
(either lock or unlock) until the signal beeps.
■Operating the driving position memory after turning the “ENGINE START
STOP” switch off
Memorized positions (except for the steering wheel position) can be activated up
to 180 seconds after the driver’s door is opened and another 60 seconds after it is
closed again, even after turning the “ENGINE START STOP” switch off.
■Stopping seat position operation part-way through
Perform any of the following operations:
●Press the “SET” button.
●Press button “1”, “2” or “3”.
●Adjust the seat using the switches (only cancels seat position recall).
●Adjust the steering wheel using the tilt and telescopic steering control switch
(only cancels steering wheel position recall).
■Correct seat position
When the seat is in the most forward or most backward position, and the seat is
being moved in those directions, the system may not correctly recognize the cur-
rent position and the memorized position will not be correctly recalled.
■The auto away function for exiting the driver seat
If the seat is already close to the rearmost position, the auto away function may not
operate when the driver exits the vehicle.
■Customization
The distance that the driver’s seat moves backward during the auto away function
can be changed. (Customizable features →P. 6 2 2 )
STEP1
STEP2
RX350_270_EE_48D77E.book 85 ページ ２０１４年１月２４日　金曜日　午前１０時４分

91
1-3. Adjustable components (seats, mirrors, steering wheel)
1
Before driving
RX350/270_EE
■Emergency locking retractor (ELR)
The retractor will lock the belt during a sudden stop or on impact. It may also lock if
you lean forward too quickly. To allow the belt to extend, retract the belt and then
pull it slowly.
■Child seat belt usage
The seat belts of your vehicle were principally designed for persons of adult size.
●Use a child restraint system appropriate for the child, until the child becomes
large enough to properly wear the vehicle's seat belt. (→P. 1 4 2 )
●When the child becomes large enough to properly wear the vehicle's seat belt,
follow the instructions on P. 89 regarding seat belt usage.
■Replacing the belt after the pretensioner has been activated
If the vehicle is involved in multiple collisions, the pretensioner will activate for the
first collision, but will not activate for the second or subsequent collisions.
■Seat belt regulations
If seat belt regulations exist in the country where you reside, please contact any
authorized Lexus dealer or repairer, or another duly qualified and equipped profes-
sional, for seat belt replacement or installation.
RX350_270_EE_48D77E.book 91 ページ ２０１４年１月２４日　金曜日　午前１０時４分