air condition LEXUS RX330 2006 User Guide

OCCUPANT RESTRAINT SYSTEMS
195
Condition and operation in the front passenger occupant classification s\
ystem
Condition detected by the front
passenger occupant
classification system
Indicator/warning lightDevices
“AIRBAG ON” and
“AIRBAG OFF”
indicator lights
SRS
warning light
Front
passenger’s seat belt
reminder light
Front
passenger airbagSide airbag
on the frontpassenger seatCurtain
shield airbag in the frontpassenger sideFront
passenger’s seat belt
pretensioner
1Adult*1“AIRBAG ON”OffFlashing*4Activated
2Child *2 or child
restraint system*3“AIRBAG OFF”OffFlashing*4Deactivated
Activated
Activated
3UnoccupiedNot
illuminatedOffOffDeactivatedDeactivated
4There is a
malfunction in the
system“AIRBAG OFF”OnOffDeactivatedActivated
*1: The system judges a person of adult size as an adult. When a smaller ad\
ult sits in the front passenger seat, the system may recognize him/her as a child depending on his/her physique and posture.
*
2: When a larger child who has outgrown a child restraint system sits in the front\
passenger seat, the system may recognize him/her as an adult depending on his/her physique or posture.
*
3: Never install a rear −facing child restraint system on the front passenger seat. A forward −facing child restraint system should
only be installed on the front passenger seat when it is unavoidable. (\
See “Child restraint system” as for installing the chil d
restraint system.)
*
4: In the event the front passenger does not wear a seat belt.

OCCUPANT RESTRAINT SYSTEMS
196
CAUTION
To avoid potential death or serious injury when the front
passenger occupant classification system does not
detect the conditions correctly, observe the following.
Wear the seat belt properly.
 Make sure the front passenger’s seat belt tab has not
been left inserted into the buckle before someone
sits in the front passenger seat.
 Make sure the “AIRBAG OFF” indicator light is not
illuminated when using the seat belt extender for the
front passenger seat. If the “AIRBAG OFF” indicator
light is illuminated, disconnect the extender tongue
from the seat belt buckle, then reconnect the seat
belt. Reconnect the seat belt extender after making
sure the “AIRBAG ON” indicator light is illuminated.
If you use the seat belt extender while the “AIRBAG
OFF” indicator light is illuminated, the front
passenger airbag and side airbag on the front
passenger side may not activate correctly, which
could cause death or serious injury in the event of
collision.
 Do not apply a heavy load to the front passenger seat
or equipment (e.g. seatback pocket or armrest).
 Do not put weight on the front passenger seat by
putting your hands or feet on the front passenger
seat seatback from the rear passenger seat.
 Do not let a rear passenger lift the front passenger
seat with their feet or press on the seatback with their
legs.
 Do not put objects under the front passenger seat.
 Do not recline the front passenger seatback so far
that it touches a rear seat. This may cause the
“AIRBAG OFF” indicator light to be illuminated,
which indicates that the passenger’s airbags will not
deploy in the event of a severe accident. If the
seatback touches the rear seat, return the seatback
to a position where it does not touch the rear seat.
Keep the front passenger seatback as upright as
possible when the vehicle is moving. Reclining the
seatback excessively may lessen the effectiveness
of the seat belt system.

OCCUPANT RESTRAINT SYSTEMS
197
If an adult sits in the front passenger seat, the
“AIRBAG ON” indicator light is illuminated. If the
“AIRBAG OFF” indicator is illuminated, ask the
passenger to sit up straight, well back in the seat, feet
on the floor, and with the seat belt worn correctly. If
the “AIRBAG OFF” indicator still remain illuminated,
either ask the passenger to move to the rear seat, or
if that is not possible, move the front passenger seat
fully rearward.
 When it is unavoidable to install the forwardfacing
child restraint system on the front passenger seat,
install the child restraint system on the front
passenger seat in the proper order. (As for the
installation order, see “Child restraint system” on
page 199.)
 Do not remove the seat.
 Do not kick the front passenger seat or subject it to
severe impact. Otherwise, the SRS warning light may
come on to indicate a malfunction of the detection
system. In this case, contact your Lexus dealer
immediately.
 Child restraint systems installed on the rear seat
should not contact the front seatbacks.In addition to the precautions outlined above, the “AIRBAG
ON” indicator light may be illuminated when a child sits in the
front passenger seat or a forward −facing child restraint system
is installed in the front passenger seat. If the “AIRBAG ON”
indicator light is illuminated in these circumstances, the front
passenger airbag and side airbag on the front passenger side
are in an activated condition — the airbags will deploy if an
impact meets the deployment criteria. Refer to all the cautions
in this Section and “Child restraint system” on page 199.

OCCUPANT RESTRAINT SYSTEMS
207
5. Fully extend the shoulder belt to put it in the lock mode.
When the belt is then retracted even slightly, it cannot be
extended. To hold the seat securely, make sure the belt is in
the lock mode before letting the belt retract.
6. While pressing the convertible seat firmly against the seat
cushion and seatback, let the shoulder belt retract as far as it
will go to hold the convertible seat securely.
CAUTION
Push and pull the child restraint system in different
directions to be sure it is secure. Follow all the
installation instructions provided by its manufacturer.
7. Put a child on the child restraint system and secure the child,
complying with the instructions provided by the child restraint
system manufacturer.
The “AIRBAG OFF” indicator light is illuminated when the
ignition
key is “ON” and the child is in the child restraint system
after following these procedures. The “AIRBAG OFF” indicator
light indicates the SRS front passenger airbag and side airbag
on the passenger side will not deploy. If the “AIRBAG ON”
indicator light is illuminated, remove the child restraint system
and reinstall it with the ignition key in the “ACC” or “LOCK”
position. If the indicator light is not illuminated when the ignition
key is turned to the “ON” position, then the SRS front
passenger airbag and side airbag on the passenger side may
deploy in an accident. Do not drive the vehicle in this condition.
Remove the child restraint system and contact your Lexus
dealer.
CAUTION
When it is unavoidable to install the forwardfacing
child restraint system on the front passenger seat,
install the child restraint system on the front passenger
seat in the proper order. Otherwise, the front passenger
occupant classification system can not detect the
presence of the child restraint system and the front
passenger airbag and side airbag on the front
passenger seat could deploy.

SECTION 2 – 1
241
AIR CONDITIONING AND AUDIO
Air conditioning
Automatic air conditioning controls242
. . . . . . . . . . . . . . . . . . . . . . . . .
For vehicles equipped with Navigation System,
please refer to the separate “Navigation System
Owner’s Manual”.

AIR CONDITIONING
242
AUTOMATIC AIR CONDITIONING CONTROLS
You can adjust the brightness of the display. See “Multidisplay light control” on page 91 for details.

AIR CONDITIONING
243
The automatic air conditioning automatically maintains
the set temperature.
In the automatic operation mode, the air conditioning selects
the most suitable fan speed, air flow, air intake and on−
off the
air conditioning according to the temperature.
The ignition key must be in the “ON” position.
NOTICE
To prevent the battery from being discharged, do not
leave the air conditioning on longer than necessary
when the engine is not running.
1Driver side temperature display (in degrees
Fahrenheit or Centigrade)
2Air flow display
3Fan speed display
4Passenger side temperature display (in degrees
Fahrenheit or Centigrade)
5“TEMP” (driver side temperature control) button
(At the independent mode that display shows
“DUAL”; mainly for driver and secondarily for
front passenger)
(At the linked mode that display does not show
“DUAL”; for driver)
6“AUTO” button
7“OFF” button
8Air intake control button
9“A/C” button
10Fan speed control button
11“MODE”(air flow control) button
12“DUAL” (temperature setting mode change) button
13Windshield air flow button
14“PASSENGER TEMP” (passenger side temperature
control) button
(Only for the independent mode that display
shows “DUAL”; mainly for front passenger and
secondarily for driver)

AIR CONDITIONING
244
Air flow selection

AIR CONDITIONING
245
(a) Climate control
SETTING OPERATION — automatic control
1. Push the “AUTO” button.
An indicator light will illuminate to show that the automatic
operation mode has been selected.
Air flow quantity, switching of the diffusers, on−off of the air
conditioning and switching of the air intake between
RECIRCULATED AIR and OUTSIDE AIR are automatically
adjusted. When you press the “AUTO” button with the air
intake mode at OUTSIDE AIR, internal circulation may be
applied for maximum cooling. The operation status is shown
by each indicator. When one of the manual control buttons is depressed while
operating in automatic mode, the operation corresponding to
the depressed button is set. Other conditions continue to be
adjusted automatically.
Push the “OFF” button to turn the air conditioning system off.

AIR CONDITIONING
246
INFORMATION
This automatic control has additional function as
described below, when the “AUTO” button is pushed.
The fan speed is stopped for a little while until warm
air preparation, when outside temperature is cold like
a winter season in the “Floor”, “Bilevel” or
“Floor/Windshield” air flow mode. If quick removal
for exterior frost, fog and inside fog on the windshield
is desired, use the high fan speed setting after the
“Windshield” air flow mode has been selected.
The fan speed is stopped few seconds until cool air
preparation, when outside temperature is hot like a
summer season in the “Panel” or “Bilevel” air flow
mode.
 The internal circulation may be applied for maximum
cooling in the automatic operation mode, when
outside temperature is hot like a summer season.
If fresh outside air is desired into the vehicle, push
the air intake control button to select the OUTSIDE
AIR mode.
The “Floor/Windshield” air flow mode may be applied
automatically, if the outside temperature is lowered
down to below 0C (32F).
This is not malfunction. The “Floor/Windshield” air
flow mode turns on the defogging and defrosting
function with the purpose of cleaning your front view
for safe driving.
If the “Floor” air flow mode is desired with the main
purpose of heating, “Floor” air flow mode can be
selected manually by pushing the “MODE” (air flow
control) button.