tow LEXUS RX330 2006 User Guide

INTERIOR EQUIPMENT
120
Removing luggage cover
To remove the luggage cover, lift it up after pushing
forward the lock release knobs on both sides.
You can stow the luggage cover in the auxiliary box in the
luggage compartment as shown in the illustration.
After removing the luggage cover, stow it in the auxiliary box
or place it somewhere other than the passenger compartment.
This will prevent passengers from being injured in the event of
a sudden stop or accident.

INTERIOR EQUIPMENT
122
TIEDOWN HOOKS
To secure your luggage, use the tiedown hooks as shown
above.
See “Stowage precautions” on page 490 for precautions when
loading luggage.
NOTICE
Do not use the anchor brackets on the back of the rear
seatback instead of the tiedown hooks.

EXTERIOR EQUIPMENT
128
MOON ROOF (normal type)
1Open2Close
To slide open the moon roof, push the slide control switch
toward the back. The moon roof will open and stop
partway 45 mm (1.8 in.) from the fully opened position.
When you push the switch once again, the moon roof will
fully open. To stop partway , push either side of the slide
control switch.
As driving with the moon roof opened fully will cause wind
throbs, we recommend you to drive with the moon roof partway
45 mm (1.8 in.) from the fully opened position. The sunshade can be opened or closed manually. However,
if you open the moon roof, the sunshade will be opened with
the moon roof.
To close the moon roof, push the slide control switch
toward the front. The moon roof will fully close. To stop
partway, push the either side of the slide control switch.

EXTERIOR EQUIPMENT
131
If the moon roof does not operate
automatically
If the moon roof does not operate automatically or jam
protection function does not operate correctly, you should
normalize the moon roof.
To normalize the moon roof, push and hold the slide control
switch toward the front or “TILT” switch on the rear side. The
moon roof will tilt up and down, then slide open and close. After
the slide close operation, release the switch.
Make sure that the moon roof opens and closes automatically.
If the moon roof cannot be operated properly, have it checked
by your Lexus dealer.
CAUTION
To avoid serious personal injury, you must do the
following.
 While the vehicle is moving, always keep the heads,
hands and other parts of the bodies of all occupants
away from the roof opening. Otherwise, they could
be seriously injured if the vehicle stops suddenly or
if the vehicle is involved in an accident.
 Before you close the moon roof, always make sure
there is nobody around the moon roof. You must also
make sure nobody places his or her head, hands and
other parts of the body in the roof opening. If
someone’s neck, head or hands get caught in the
closing roof, it could result in death or serious injury.
When anyone closes the moon roof, first make sure
it is safe to do so.
 Be sure to remove the ignition key when you leave
your vehicle.
 Never leave anyone (particularly a small child) alone
in your vehicle, especially with the ignition key still
inserted. Otherwise, he/she could use the moon roof
switches and get trapped in the roof opening.
Unattended person (particularly a small child) can be
involved in a serious accident.
 Never sit on top of the vehicle around the roof
opening.
 Never try jamming any part of your body to activate
the jam protection function intentionally, as it could
result in a serious injury.
 The jam protection function may not work if
something gets caught just before the moon roof is
fully closed.

EXTERIOR EQUIPMENT
132
MOON ROOF (multipanel type)
To open the moon roof, push the slide control switch
toward the back. The front panel tilts up and the center
and rear panels fully open. To stop partway, push either
side of the slide control switch or the “TILT” switch briefly.
The sunshade can be opened or closed manually. However,
if you open the moon roof, the sunshade will be opened with
the moon roof.
Before opening the moon roof, make sure the radio antenna is
in the lock position. Otherwise, the antenna may get caught
between the moon roof and frame.
To close the moon roof, push the slide control switch
toward the front. The center and rear panels fully close.
Then push and hold the slide control switch toward the
front or the “TILT” switch on the front side until the front
panel is fully down. To stop partway, push either side of
the slide control switch or the “TILT” switch briefly.
The center and rear panels will not close automatically when
the center panel position is near its closed position. In this
case, push the slide control switch toward the front until the
panels fully close.

EXTERIOR EQUIPMENT
133
1Tilt up2Tilt down
To tilt up the front panel, push the “TILT” switch on the rear
side. The moon roof will fully tilt up. To stop partway, push
either side of the “TILT” switch or the slide control switch
briefly.
To tilt down the front panel, push and hold the “TILT”
switch on the front side or the slide control switch toward
the front until the panel is fully down. To operate the moon roof, the
ignition key must be in the “ON”
position.
If the moon roof is left open when you turn the ignition key to
the “ACC” or “LOCK” position and open the driver’s door, a
buzzer will remind you to close the moon roof.
Retained accessory power operation: Even if the ignition
key is turned to the “ACC” or “LOCK” position, the moon roof
can be operated until either front door is opened (or for 43
seconds).

EXTERIOR EQUIPMENT
134
Jam protection function
If something gets caught between the moon roof and frame
during slide closing operation, the moon roof stops and
opens half way.
 If something gets caught between the moon roof and frame
during tilting down operation, the moon roof stops and
opens fully.
If the moon roof receives a strong impact, this function may
work even if nothing is caught.
If the moon roof does not operate
automatically
If the moon roof does not operate automatically or jam
protection function does not operate correctly, you should
normalize the moon roof.
To normalize the moon roof, push the slide control switch
toward the front or the “TILT” switch on the front side until the
front panel fully closes, and hold the switch for about 1 second.
Make sure that the moon roof opens and closes automatically.
If the moon roof cannot be operated properly, have it checked
by your Lexus dealer.
CAUTION
To avoid serious personal injury, you must do the
following.
 While the vehicle is moving, always keep the heads,
hands and other parts of the bodies of all occupants
away from the roof opening. Otherwise, they could
be seriously injured if the vehicle stops suddenly or
if the vehicle is involved in an accident.

OCCUPANT RESTRAINT SYSTEMS
141
Slightly recline the back of the seat. Although vehicle
designs vary, many drivers can achieve the 250 mm
(10 in.) distance, even with the driver seat all the way
forward, simply by reclining the back of the seat
somewhat. If reclining the back of your seat makes
it hard to see the road, raise yourself by using a firm,
nonslippery cushion, or raise the seat if your vehicle
has that feature.
 If your steering wheel is adjustable, tilt it downward.
This points the airbag toward your chest instead of
your head and neck.
The seat should be adjusted as recommended by
NHTSA above, while still maintaining control of the foot
pedals, steering wheel, and your view of the instrument
panel controls.Front passenger seat
CAUTION
The SRS front passenger airbag also deploys with
considerable force, and can cause death or serious
injury especially if the front passenger is very close to
the airbag. The front passenger seat should be as far
from the airbag as possible with the seatback adjusted,
so the front passenger sits upright.

OCCUPANT RESTRAINT SYSTEMS
149
Folding down rear seatbacks
Before folding down rear seatbacks
Stow the rear seat belt buckles as shown above.
 Seat belt hanger
For the outer seat belts, use the seat belt hangers to
prevent the belts from being tangled.
NOTICE
The seat belts and the buckles must be stowed before
you fold down the rear seatbacks.

STEERING WHEEL AND MIRRORS
236
The vehicle is in a place where the earth’s magnetic field is
subject to interference by artificial magnetic fields
(underground parking, under a steel tower, between
buildings, roof parking, near a crossing, near a large vehicle,
etc.).
 The vehicle is magnetized. (There is a magnet or a metal
object on or near the inside rear view mirror.)
 The battery has been disconnected.
If your vehicle is out of the set zone, refer to “Calibrating the
compass” in this Section to set the zone number.
If the deviation is small, the compass works to calibrate the
direction automatically while the vehicle is in motion.
For obtaining additional precision or for complete calibrating,
see “Calibrating the compass” below.
If the direction is not indicated or the system does not operate
properly, contact your Lexus dealer.
 Compass sensor
NOTICE
Do not put magnets or a metal object on or near the
inside rear view mirror of the vehicle. Doing this may
cause malfunction of the compass sensor in the mirror.