lights LEXUS RX350 2015 Workshop Manual

6103-7. Other interior features
Vanity mirrors ■
To prevent battery discharge
When the “ENGINE START STOP” switch is turned off, the lights will go off auto-
matically after 20 minutes.
NOTICE■
When not in use
Keep the vanity mirror closed. Slide the cover to open. The light turns on when the
cover is opened.

6524-1. Maintenance and care
NOTICE■
To prevent paint deterioration and corros ion on the body and components (alu-
minum wheels etc.) ●
Wash the vehicle immediately in the following cases:
• After driving near the sea coast
• After driving on salted roads
• If you see coal tar or tree sap on the paint surface
• If you see dead in sects, insect droppings or bird droppings on the paint
• After driving in an area contaminated with soot, oily smoke, mine dust, iron
powder or chemical substances
• If the vehicle becomes heavily soiled in dust or mud
• If liquids such as benzene and gasoline are spilled on the paint surface●
If the paint is chipped or scratched, have it repaired immediately.●
To prevent the wheels from corroding, remove any dirt and store in a place with
low humidity when storing the wheels.■
Cleaning the exterior lights ●
Wash carefully. Do not use organic substances or scrub with a hard brush.
This may damage the surfaces of the lights.●
Do not apply wax to the surfaces of the lights.
Wax may cause damage to the lenses.■
To prevent damage to the windshield wiper arms
When lifting the wiper arms away from th e windshield, pull the driver side wiper
arm upward first, and repeat for the passenger side. When returning the wipers to
their original position, do so from the passenger side first.■
When using an automatic car wash (vehicle s with rain-sensing windshield wipers)
Set the wiper switch to the off position.
If the wiper switch is in , the wipers may operate and the wiper blades may
be damaged.

6614-2. Maintenance
4
Maintenance and care Items Check points
Indicators/buzzers • Do the indicators and buzzers
function properly?
Lights • Do all the lights come on?
• Are the headlights aimed cor-
rectly? (  P. 7 1 6 )
Pa r k i n g b r a ke • Does the parking brake pedal
move smoothly?
• When parked on a slope and the
parking brake is on, is the vehicle
securely stopped?
Seat belts • Do the seat belts operate
smoothly?
• The seat belts should not be dam-
aged.
Seats • Do the seat controls operate prop-
erly?
Steering wheel • Does the steering wheel rotate
smoothly?
• Does the steering wheel have the
correct amount of free play?
• There should not be any strange
sounds coming from the steering
wheel.

7084-3. Do-it-yourself maintenance
23
ETCS 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem24
RAD NO. 1 10 A Audio system, navigation system25
AM2 7. 5 A Starter system26
ECU-B NO. 2 7. 5 A Air conditioning system, front passen-
ger occupant classification system,
audio system, vehicle stability control
system, power windows27
MAYDAY/TEL 7. 5 A MAYDAY/TEL28
IMMOBI 7. 5 A IMMOBI29
ALT-S 7. 5 A Charging system30
DRL 7. 5 A Daytime running light system31
IGN 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem32
DOME 10 A Vanity mirror lights, luggage compart-
ment lights, interior lights, personal
lights, door courtesy lights, footwell
lights, scuff lights
33
ECU-B NO. 1 10 A Tilt and telescopic steering, multiplex
communication system, meters and
gauges, driving position memory,
power seats, power back door, head-
up display, starter system, outside rear
view mirror, steering sensor, garage
door openerFuse Ampere Circuit

7094-3. Do-it-yourself maintenance
4
Maintenance and care 34
EFI NO. 1 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem, electronic controlled transmis-
sion35
WIP-S 7. 5 A Cruise control36
ECU-IG1 NO. 4 10 A Air conditioning system, rear window
defogger, vehicle stability control sys-
tem, electric cooling fans37
BK/UP LP 7. 5 A Back-up lights38
ECU-IG1 NO. 5 15 A Air conditioning system39
ECU-IG1 NO. 6 10 A Head light cleaner, cruise control,
vehicle stability control, air condition-
ing system, Blind Spot Monitor40
EFI NO. 2 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem41
F/ P M P 15 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem42
DEICER 25 A Windshield wipers and washer
43
STOP 7. 5 A Vehicle stability control, vehicle
dynamics integrated management,
stop lights, electronic controlled
transmission, multiport fuel injection
system/sequential multiport fuel injec-
tion system, shift lock control system,
starter system
44
TOW I N G BAT T 20 A Trailer battery
45
TOW I N G 30 A Trailer lightsFuse Ampere Circuit

7124-3. Do-it-yourself maintenance
7
ECU-IG1 NO. 1 10 A Multiplex communication system,
steering sensor, shift lock control sys-
tem, tilt and telescopic steering, auto-
matic transmission system, power
back door, pre-collision system, vehi-
cle stability control system, tire pres-
sure warning system8
S/ROOF 30 A Moon roof9
FUEL OPN 7. 5 A Fuel filler door opener10
PSB 30 A Pre-collision seat belt11
TI & TE 30 A Tilt and telescopic steering system12
DR LOCK 10 A13
FR FOG 7. 5 A Front fog lights14
P-S E AT L H 30 A Po w e r s e a t ( l e f t - s i d e )15
4WD 7. 5 A AW D s y s t e m16
INVERTER 20 A Po w e r o u t l e t17
RR FOG 7. 5 A18
D/L ALT B 25 A Multiplex communication system,
power door lock system, power back
door19
EPS 10 A Electric power steering system20
ECU-IG1 NO. 2 10 A Intuitive parking assist, AWD system,
pre-collision seat beltFuse Ampere Circuit

7134-3. Do-it-yourself maintenance
4
Maintenance and care 21
PA N E L 10 A Switch illumination, navigation system,
automatic transmission system, audio
system, multi-information display, air
conditioning system, multiplex com-
munication system22
TA I L 10 A Parking lights, front side marker lights,
tail lights, license plate lights, front fog
lights, towing converter23
AIR SUS 20 A24
P-S E AT R H 30 A Power seat (right-side)25
OBD 7. 5 A On-Board diagnosis26
FR DOOR 25 A Front power window (right-side), out-
side rear view mirror27
RR DOOR 25 A Rear power window (right-side)28
FL DOOR 25 A Front power window (left-side), out-
side rear view mirror29
RL DOOR 25 A Rear power window (left-side)30
FR WASH 25 A Windshield wipers and washer31
RR WIP 15 A Windshield wipers and washer32
RR WASH 20 A Windshield wipers and washer33
FR WIP 30 A Windshield wipers and washer
34
ECU IG2 10 A Multiport fuel injection system/
sequential multiport fuel injection sys-
tem, front passenger occupant classi-
fication system, SRS airbag system,
stop lights, electronic controlled
transmission, steering lock systemFuse Ampere Circuit

7154-3. Do-it-yourself maintenance
4
Maintenance and care ■
After a fuse is replaced ●
If the lights do not turn on even afte r the fuse has been replaced, a bulb may
need replacement. (  P. 7 1 9 )●
If the replaced fuse blows again, have the vehicle inspected by your Lexus
dealer.■
If there is an overload in the circuit
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION■
To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage, and possibly a fire or injury. ●
Never use a fuse of a higher amperage rating than indicated, or use any other
object in place of a fuse.●
Always use a genuine Lexus fuse or equivalent.
Never replace a fuse with a wire, even as a temporary fix.
This can cause extensive damage or even fire.●
Do not modify fuse or fuse boxes.
NOTICE■
Before replacing fuses
Have the cause of electrical overload determined and repaired by your Lexus
dealer.

7164-3. Do-it-yourself maintenance
Headlight aim ■ Removing the engine compartment cover
 P. 6 7 1
■ Vertical movement adjusting bolts
Vehicles with halogen headlights
Adjustment bolt A
Adjustment bolt B
Vehicles with discharge headlights
Adjustment bolt A
Adjustment bolt B
■ Before checking the headlight aim
Make sure the vehicle has a full tank of gas and the area around
the headlight is not deformed.
Park the vehicle on level ground.
Sit in the driver’s seat.
Bounce the vehicle several times.STEP 1
STEP 2
STEP 3
STEP 4

7174-3. Do-it-yourself maintenance
4
Maintenance and care ■ Adjusting the headlight aim
Vehicles with halogen headlights
Turn bolt A in either direction
using a Phillips-head screw-
driver. Remember the turning direction
and the number of turns.
Turn bolt B the same number of
turns and in the same direction
as in step 1 using a Phillips-head
screwdriver. If the headlight cannot be
adjusted using this procedure,
take the vehicle to your Lexus
dealer to adjust the headlight
aim.STEP 1
STEP 2