instrument cluster LEXUS SC300 1991 Service Repair Manual

15. REMOVE CENTER PADUsing a screwdriver, pry out the panel and remove it.
HINT: Tape screwdriver tip before use.
16. REMOVE ENGINE HOOD RELEASE LEVER (a) Remove two screws and the engine hood release lever.
(b) Disconnect the release cable from the lever.
17. REMOVE NO. 1 LOWER FINISH PANEL (a) Using a screwdriver, remove the end pad.
HINT: Tape the screwdriver tip before use.
(b) Remove the bolt and two screws.
(c) Disconnect the connectors and remove the panel.
18. REMOVE COMBINATION SWITCH
19. REMOVE CLUSTER FINISH PANEL Pull out the panel and disconnect the connector.
20. REMOVE COMBINATION METER (a) Remove two caps.
(b) Remove two screws and the meter.
(c) Disconnect the connectors from the meter.
BO±112
±
BODY Instrument Panel
WhereEverybodyKnowsYourName

Parts Inspection
(Combination Meter Assembly)
REMOVAL AND INSTALLATION OF
COMBINATION METER ASSEMBLY
1. REMOVE COMBINATION METER ASSEMBLY(a) Lower the steering wheel fully and set it in the far position.
(b) Turn the ignition switch to LOCK and disconnect battery terminals.
CAUTION: Work must be started after approx. 20 se-
conds or longer from the time the ignition switch is
turned to the ºLOCKº position and negative (±) terminal
cable is disconnected from the battery.
(c) Remove instrument cluster finish panel.
(d) Remove four screws and disconnect three connectors.
(e) Remove combination meter assembly.
2. INSTALL COMBINATION METER ASSEMBLY For installation, follow the removal procedure in reverse.
±
BODY ELECTRICAL SYSTEM Combination MeterBE±103
WhereEverybodyKnowsYourName