brake fluid LEXUS SC300 1999 User Guide

SECTION 6 ± 3
353
SERVICE PROCEDURES AND
SPECIFICATIONS
Chassis
Specifications (SC400) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
355
Specifications (SC300) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
357
Checking brake fluid. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
359
Checking power steering fluid . . . . . . . . . . . . . . . . . . . . . . . .
361
Checking tire pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
363
Rotating tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. .
365
Checking and replacing tires . . . . . . . . . . . . . . . . . . . . . . . . . .
365
Installing snow tires and chains . . . . . . . . . . . . . . . . . . . . . . .
369
Replacing wheels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
372
Aluminum wheel precautions . . . . . . . . . . . . . . . . . . . . . . . . .
372
Suspension and chassis . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

CHASSIS
355
SPECIFICATIONS (SC400)
± AUTOMATIC TRANSMISSIONFluid capacity Drain and refill
Fluid type
1.9 L (2.0 qt., 1.7 lmp.qt.)
Automatic transmission fluid Type T ± IV or equivalent
± DIFFERENTIAL
Oil capacity
Oil type
Oil viscosity
1.35 L (1.42 qt., 1.19 lmp.qt.)
Hypoid gear oil API GL±5
Above ±18C (0F): SAE90
Below ±18C (0F): SAE80W or SAE80W±90
± BRAKES
Pedal clearance *
1
Pedal freeplay
Brake pad wear limit
Parking brake lining wear limit *
2
Parking brake adjustment
Fluid type
89 mm (3.5 in.) Min.
1 ± 6 mm (0.04 ± 0.24 in.)
1.0 mm (0.04 in.)
1.0 mm (0.04 in.)
5 ± 8 clicks
SAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 k\
gf, 110 lbf.) with the engine running
*
2: Parking brake adjustment when pulled with the force of 196 N (20 kgf, 4\
4 lbf.)

CHASSIS
357
SPECIFICATIONS (SC300)
± AUTOMATIC TRANSMISSIONFluid capacity Drain and refill
Fluid type
1.6 L (1.7 qt., 1.4 lmp.qt.)
Automatic transmission fluid D±II or DEXRONIII
(DEXRONII)
± DIFFERENTIAL
Oil capacity
Oil type
Oil viscosity
1.35 L (1.42 qt., 1.19 lmp.qt.)
Hypoid gear oil API GL±5
Above ±18C (0F): SAE90
Below ±18C (0F): SAE80W or SAE80W±90
± BRAKES
Pedal clearance *
1
Pedal freeplay
Brake pad wear limit
Parking brake lining wear limit *
2
Parking brake adjustment
Fluid type
89 mm (3.5 in.) Min.
1 ± 6 mm (0.04 ± 0.24 in.)
1.0 mm (0.04 in.)
1.0 mm (0.04 in.)
5 ± 8 clicks
SAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 k\
gf, 110 lbf.) with the engine running
*
2: Parking brake adjustment when pulled with the force of 196 N (20 kgf, 4\
4 lbf.)

CHASSIS
359
CHECKING BRAKE FLUID
To check the fluid level, simply look at the see±through
reservoir. The level should be between the ºMAXº and
ºMINº lines on the tank.

CHASSIS
360It is normal for the brake fluid level to go down slightly as the
brake pads wear. So be sure to keep the reservoir filled.
If the reservoir needs frequent refilling, it may indicate a
serious mechanical problem.
If the level is low, add FMVSS No.116 DOT 3 or SAE
J1703 brake fluid to the brake reservoir.
Remove and replace the reservoir cover by hand. Add brake
fluid up to the ºMAXº line.
Use only newly opened brake fluid. Once opened, brake fluid
absorbs moisture from the air, and excess moisture can cause
a dangerous loss of braking efficiency.
CAUTION
Take care when filling the reservoir because brake fluid can
harm your hands or eyes and damage painted surfaces. If
fluid gets in your hands or eyes, flush them with clean water.
NOTICE

If you spill some of the fluid, be sure to wipe it off to
prevent it from damaging the parts or paintwork.
 For vehicles with traction control system only:Idle
the engine while pouring brake fluid into the reservoir.