gas LEXUS SC300 1999 User Guide

ENGINE
334
SPECIFICATIONS (SC300)
± GENERALModel
Type
Bore and stroke
Displacement
Valve clearance (engine cold) Intake
Exhaust
Drive belt tension
2JZ±GE
6 cylinder in line, 4 cycle, gasoline
86.0 X 86.0 mm (3.39 X 3.39 in.)
2997 cm
3 (182.9 cu.in.)
0.15 ± 0.25 mm (0.006 ± 0.010 in.)
0.25 ± 0.35 mm (0.010 ± 0.014 in.)
Automatic adjustment
± LUBRICATION SYSTEM

ENGINE
337
FUEL
Fuel type
Your vehicle must use only unleaded gasoline.
To help prevent gas station mixups, your Lexus has a smaller
fuel tank opening. The special nozzle on pumps with
unleaded fuel will fit it, but the larger nozzle on pumps with
leaded gas will not.
At a minimum, the gasoline you use should meet the
specifications of ASTM D4814 in the U.S.A. and CGSB
3.5±M93 in Canada.
NOTICE
Do not use leaded gasoline. Use of leaded gasoline will
cause the three±way catalytic converter to lose its
effectiveness and the emission control system to function
improperly. Also, this can increase maintenance costs.
Octane rating
Select premium unleaded gasoline with an Octane Rating
of 91 (Research Octane Number 96) or higher for
optimum engine performance. However, if such premium
type cannot be obtained, you may temporarily use
unleaded gasoline with an Octane Rating as low as 87
(Research Octane Number 91). Use of unleaded fuel with an octane number or rating lower
than stated above will cause persistent heavy knocking. If
severe, this will lead to engine damage.
If your engine knocks ...
If you detect heavy knocking even when using the
recommended fuel, or if you hear steady knocking while
holding a steady speed on level roads, consult your Lexus
dealer.
However, now and then, you may notice light knocking for a
short time while accelerating or driving up hills. This is no
cause for concern.
Gasolines containing detergent additives
Lexus r
ecommends use of gasolines that contain detergent
additives to avoid build±up of engine deposits.
For further details, ask your Lexus dealer or a local gasoline
retailer.
Improved gasolines
The American Automobile Manufacturers Association
(AAMA) has developed a specification of improved
gasolines. The AAMA specification offers optimal fuel
information for better vehicle performance and better
protection of your engine.
Lexus recommends the use of gasolines that meet the AAMA
specification, if available, for improved drivability and
emission control system.

ENGINE
338
Gasolines containing MTBE
Gasolines that contain MTBE (Methyl Tertiary±Butyl
Ether) are available in the market. If you use a gasoline
mixed with MTBE, make certain that it does not contain
more than 15% of MTBE.
Gasolines containing MMT
Some gasolines contain an octane±enhancing additive
called MMT (methylcyclopentadienyl manganese
tricarbonyl).
Lexus does not recommend the use of gasolines that contain
MMT. If fuels containing MMT are used, your emission
control system may be adversely affected. The Malfunction
Indicator Lamp on the instrument cluster may come on. If this
happens, contact your Lexus dealer for service.
Gasolines containing alcohol
Gasohol is a mixture of gasoline and ethanol. If you use
gasohol in your Lexus, be sure that it is unleaded, has an
octane rating no lower than 87 and does not contain more
than 10% ethanol. Lexus does not recommend the use of
gasolines containing methanol.
If you use gasoline containing methanol, use only gasoline
meeting the requirements above and also containing less than
5% methanol with cosolvents and corrosion inhibitors for
methanol.

ENGINE
339
Gasolines quality
In a very few cases, you may experience driveability
problems caused by the particular gasoline that you are using.
If you continue to have unacceptable driveability, try
changing gasoline brands. If that does not rectify your
problem, then consult your Lexus dealer.
NOTICE

Do not use gasohol other than stated above. It will
cause fuel system damage or vehicle performance
problems.

If drivability problems are encountered (poor hot
starting, vaporizing, engine knock, etc.), discontinue
its use.

Take care not to spill gasohol during refueling.
Gasohol may cause paint damage.
Fuel tank capacity
78 L (20.6 gal., 17.2 lmp.gal.)
FACTS ABOUT ENGINE OIL
CONSUMPTION
Functions of engine oil
Engine oil has the primary function of lubricating and cooling
the inside of the engine, and plays a major role in maintaining
the engine in proper working order.
Engine oil consumption
It is normal that an engine should consume some engine
oil during normal engine operation. The causes of oil
consumption in a normal engine are as follows.

Oil is used to lubricate pistons, piston rings and cylinders.
A thin film of oil is left on the cylinder wall when a piston
moves downwards in the cylinder. High negative pressure
generated when the vehicle is decelerating sucks some of
this oil into the combustion chamber. This oil as well as
some part of the oil film left on the cylinder wall is burned
by the high temperature combustion gases during the
combustion process.

Oil is also used to lubricate the stems of the intake valves.
Some of this oil is sucked into the combustion chamber
together with the intake air and is burned along with the
fuel. High temperature exhaust gases also burn the oil
used to lubricate the exhaust valve stems.

ELECTRICAL COMPONENTS
380
CHECKING BATTERYCONDITION
Precautions
CAUTION
BATTERY PRECAUTIONS
The battery produces flammable and explosive hydrogen gas.

Do not cause a spark by contacting the battery terminals
with tools.

Do not smoke or light a match near the battery.
The electrolyte contains poisonous and corrosive sulfuric acid.

Avoid contact with eyes, skin or clothes.

Never inhale or swallow electrolyte.

Wear protective safety glasses when working near the
battery.

Keep children away from the battery.
EMERGENCY MEASURES

If electrolyte gets in your eyes, flush your eyes with clean
water for at least 15 minutes and get immediate medical
attention. If possible, continue to apply water with a sponge
or cloth while traveling to the medical office.

ELECTRICAL COMPONENTS
386
Adding distilled water
(Maintenance type battery only)
1. Remove the vent plugs.
2. Add distilled water to cells needing fluid.
If the side of your battery is covered, check the water level by
looking down directly above the cell as illustrated above.
3. Retighten the vent plugs securely.
NOTICE

Do not overfill the cells. Excess electrolyte could
squirt out of the battery during heavy charging,
causing corrosion or damage.

Use a cover on the battery for longer life.
BATTERY RECHARGING
PRECAUTIONS
During recharging, the battery is producing hydrogen
gas.
Therefore, before recharging:
1. Maintenance type batteries ± Remove the vent plugs.
2. If recharging with the battery installed on the vehicle, be
sure to disconnect the ground cable.
3. Make sure the power switch on the recharger is off when
connecting the charger cables to the battery and when
disconnecting them.

ELECTRICAL COMPONENTS
399
2. Look at the beam angle gauge (horizontal movement).
The blue mark should not deviate by more than one mark on
either side of the gauge.
If the error is over the value specified above, take the vehicle
to your Lexus dealer to adjust the headlight aim.REPLACING LIGHT BULBS
The illustration on the following pages show the locations of
light bulbs. If it is necessary to replace a bulb, take your
vehicle to your Lexus dealer as soon as possible. Use bulbs
with the bulb numbers and wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas inside and r equire special
handling. They can burst or shatter if scratched or dropped.
Hold a bulb only by its plastic or metal case. Do not touch the
glass part of a bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
Light BulbsBulb
No.WType
Headlights (low beam)900655A
Headlights (high beam)900565B
Fog lights±±±±55C

BODY
408Aluminum wheels:
Use only a mild soap or neutral
detergent.
Urethane bumpers and side moldings: Wash carefully. Do
not scrub with abrasive cleaners. The bumper and side
molding faces are soft.
Road tar: Remove with turpentine or cleaners that are
marked safe for painted surfaces.
NOTICE
Do not use gasoline or strong solvents, which may be
toxic or cause damage.
3. Rinse thoroughly ± dried soap can cause streaking. In hot
weather you may need to rinse each section right after you
wash it.
4. To prevent water spots, dry the vehicle using a clean soft
cotton towel. Do not rub or press hard ± you might scratch the
paint.
Automatic car wash
NOTICE
To prevent damage to the antenna, make sure it is
retracted before driving your vehicle through an
automatic car wash.
Your vehicle may be washed in an automatic car wash, but
remember that the paint can be scratched by some type of
brushes, unfiltered washing water, or the washing process
itself. Scratching reduces paint durability and gloss,
especially on darker colors. The manager of the car wash
should be able to advise you whether the process is safe for
the paint on your vehicle.
Waxing your Lexus
Polishing and waxing is recommended to maintain the
original beauty of your Lexus' finish.
Once a month or if the vehicle does not repel water well, apply
wax.
1. Always wash and dry the vehicle before you begin waxing,
even if you are using a combined cleaner and wax.
2. Use a good quality polish and wax. If the finish has
become extremely weathered, use a car±cleaning polish,
followed by a separate wax. Carefully follow the
manufacturer's instructions and precautions. Be sure to
polish and wax the chrome trim as well as the paint.
3. Wax the vehicle again when water does not bead but
remains on the surface in large patches.

BODY
411


Dirt or sand adhered to the leather may damage the
treated surface and cause it to wear earlier. Remove
dirt or sand using a vacuum cleaner.

If a stain should fail to come out with a neutral
detergent, apply a cleaner that does not contain an
organic solvent.

Never use organic substances such as benzine, alcohol
or gasoline, or alkaline or acid solutions for cleaning
the leather as these could cause discoloring.

Use of a nylon brush or synthetic fiber cloth, etc. may
scratch the fine grained surface of the leather.

Mildew may develop on soiled leather upholstery. Be
especially careful to avoid oil spots. Try to keep your
upholstery always clean.

Long exposure to direct sunlight may cause the leather
surface to harden and shrink. Keep your vehicle in a
shaded area, especially in the summer.

The interior of your vehicle is apt to heat up on hot
summer days, so avoid placing on the upholstery items
made of vinyl or plastic or containing wax as these
tend to stick to leather when warm.

Improper cleaning of the leather upholstery could
result in discoloration or staining.
Synthetic Leather Areas (Dash)
The synthetic leather areas may be easily cleaned with a
mild soap or detergent and water.
First vacuum over the upholstery to remove loose dirt. Then,
using a sponge or soft cloth, apply the soap solution to the
synthetic leather. After allowing it to soak in for a few
minutes to loosen the dirt, remove the dirt and wipe off the
soap with a clean damp cloth. If all the dirt does not come off,
repeat the procedure. Commercial foaming±type cleaners are
also available which work well. Follow the manufacturer's
instructions.
NOTICE
Do not use solvent, thinner, gasoline or window cleaner
on the interior.

BODY
412
Carpets, Windows and Seat Belts
Begin by vacuuming thoroughly to remove as much dirt as
possible. Several types of foam cleaners are available; some
are in aerosol cans and others are powders or liquids which
you mix with water to produce a foam. To shampoo the
carpets, use a sponge or brush to apply the foam. Rub in
overlapping circles. Do not apply water ± the best results are
obtained by keeping the carpet as dry as possible. Read the
shampoo instructions and follow them closely.
The seat belts may be cleaned with mild soap and water or
with lukewarm water.
Use a cloth or sponge. As you are cleaning, check the belts
for excessive wear, fraying or cuts.
NOTICE

Use a good foam±type shampoo to clean the carpets.

Do not use dye or bleach on the belts ± it may weaken
them.

Do not use the belts until they become dry.

The windows may be cleaned with any household
window cleaner.

When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires.
Air Conditioning Control Panel, Car Audio,
Instrument Panel, Console Panel, and
Switches
Use a soft damp cloth for cleaning.
Soak a clean soft cloth in water or lukewarm water then
lightly wipe off any dirt.
NOTICE

Do not use organic substances (solvents, kerosene,
alcohol, gasoline, etc.) or alkaline or acidic solutions.
These chemicals can cause discoloring, staining or
peeling of the surface.

If you use cleaners or polishing agents, make sure
their ingredients do not include the substances
mentioned above.

If you use a liquid car freshener, do not spill the liquid
onto the vehicle's interior surfaces. It may contain the
ingredients mentioned above. Immediately clean any
spill using the method mentioned above.
If you have any questions about the cleaning of your
Lexus, your local Lexus dealer will be pleased to answer
them.