rear view mirror LEXUS SC300 1999 User Guide

COMFORT ADJUSTMENT
112
Folding rear view mirrors
To fold the rear view mirror, push backward.
The rear view mirrors can be folded backward for parking in
restricted areas.
CAUTION
Do not drive with the mirrors folded backward. Both the
driver and passenger side rear view mirrors must be extended
and properly adjusted before driving.

COMFORT ADJUSTMENT
113
INSIDE REAR VIEW MIRROR
Adjust the mirror so that you can just see the rear of your
vehicle in the mirror.
Pushing the switch changes the mode between ºAUTOº
and ºDAYº.
The indicator comes on when the ºAUTOº mode is selected.
ºDAYº mode: The mirror surface is normal.
ºAUTOº mode: If the mirror detects light from the
headlights of the vehicle behind you, the mirror surface
darkens slightly to reduce the reflected light.
When the inside rear view mirror surface changes, the outside
rear view mirror surfaces will also become darker.
When the ignition key is inserted and turned on, the inside rear
view mirror always turns on in the ºAUTOº mode. When the outside air temperature is low, it may take a little
longer for the mirror to darken in response to the detection of
headlights.

COMFORT ADJUSTMENT
168
2. To remove the child restraint system, press the
buckle±release button and allow the belt to retract.DRIVING POSITION MEMORYSYSTEM
The micro computer can memorize the position of the driver's
seat, the positions of the tilt and telescopic steering, and
outside rear view mirrors. Two different driving position
profiles can be entered into the computer's memory.
This can only be done when the ignition key is in the ºONº
position, and the selector lever is in the ºPº position.
Setting a driving position

COMFORT ADJUSTMENT
169
1. Adjust the driver's seat, tilt and telescopic steering and
outside rear view mirrors to the desired position.
2. While pushing the ºSETº button, push button º1º or
º2º until the signal beeps.
The beep sound means that the positions are recorded in the
computer 's memory.
By repeating these two steps and pressing the remaining
button, the driving position for another driver can be
recorded.
To set a new memorized position, select the desired position
and perform step 2. The previous memory will be erased and
the new position will be set.
To make only slight changes to an already memorized
position, the easiest way is to first activate the memorized
position, then make the desired changes and perform step 2
above.Activating a memorized position

STARTING AND DRIVING
212
To allow proper operation of your vehicle's
ventilation system, keep the inlet grilles in front of
the windshield clear of snow, leaves, or other
obstructions.
 If you smell exhaust fumes in the vehicle, drive with
the windows open and the trunk lid closed. Have the
cause immediately located and corrected.
BEFORE STARTING THE
ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint height
and steering wheel angle.
3. Adjust inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators
function when turning the key to ºONº, and check the fuel
gauge to see that you have sufficient fuel.
IGNITION SWITCH WITH
STEERING LOCK

DRIVING TIPS
266
Tires

Ensure that your vehicle's tires are properly inflated.
Adjust the tire pressure to the recommended cold tire
pressure indicated below:
SC400, SC 300 ± Front 220 kPa (2.2 kgf/cm
2 or bar, 32 psi)
Rear 220 kPa (2.2 kgf/cm2 or bar, 32
psi)

The trailer tires should be inflated to the pressure
recommended by the trailer manufacturer in respect to the
total trailer weight.
Trailer lights

Trailer lights must comply with federal, state/provincial
and local regulations. See your local recreational vehicle
dealer or rental agency for the correct type of wiring and
relays for your trailer. Check for correct operation of the
turn signals and stop lights each time you hitch up. Direct
splicing may damage your vehicle's electrical system and
cause a malfunction of your lights.
Break±in schedule

Lexus recommends that you do not tow a trailer with a new
vehicle or a vehicle with any new power train component
(engine, transmission, differential, wheel bearing, etc.) for
the first 800 km (500 miles) of driving.
Maintenance

If you tow a trailer, your vehicle will require more frequent
maintenance due to the additional load. For this
information, please refer to the scheduled maintenance
information in the ºOwner's Manual Supplement/
Maintenance Scheduleº.

Retighten all fixing bolts of the towing ball and bracket
after approximately 1000 km (600 miles) of trailer driving.
Pre±towing safety check

Check that your vehicle remains level when a loaded or
unloaded trailer is hitched. Do not drive if the vehicle has
an abnormal nose±up or nose±down condition, and check
for improper tongue load, overload, worn suspension or
other possible causes.

Make sure the trailer cargo is securely loaded so that it
cannot shift.

Check that your rear view mirrors conform to any federal,
state/provincial or local regulation. If they do not, install
required rear view mirrors appropriate for towing
purposes.

Engine compartment
ELECTRICAL COMPONENTS
377
No.FUSEAMPERECIRCUIT
1ENGINE7.5Charging system
2HTR10Air conditioning system, rear
window defogger
3WIPER20Windshield wipers and washer
4ST7.5
Starting system, cruise control
system, multiport fuel injection
system/sequential multiport fuel
injection system, instrument panel
lights
5IGN7.5
Discharge warning light, multiport
fuel injection system/sequential
multiport fuel injection system,
SRS airbag system
6PANEL7.5Instrument panel lights, glovebox
light
7MIR±HTR10Outside rear view mirror defogger
8TURN7.5Turn signal lights
9STOP15Stop lights, cruise control system
cancel device
10CIG15
Cigarette lighter, theft deterrent
system, shift lock system, SRS
airbag system, instrument panel
lights

ELECTRICAL COMPONENTS
378
No.FUSEAMPERECIRCUIT
11RADIONO.27.5Radio, cassette tape player,
compact disc player, power
antenna, power rear view mirrors
12TAIL7.5Tail lights, parking lights, side
marker lights, license plate lights
13ECU±IG15
Cruise control system, power
steering control system, shift lock
system, anti±lock brake system,
SRS airbag system, power door
lock system, preset steering system,
traction control system,
electronically controlled
hydraulic±driven cooling system,
passenger 's seat control system
14GAUGE10
Gauges and meters, service
reminder indicators and warning
buzzers (except discharge and open
door warning lights), back±up
lights, electronically controlled
automatic transmission system,
automatic transmission overdrive
system, headlight
15ECU±B15SRS airbag system, power rear
view mirrors
16OBD7.5On±board diagnosis system
17FOG15Fog lights
18SEAT±HT R15Seat heater

ELECTRICAL COMPONENTS
379
No.FUSEAMPERECIRCUIT
19PWR30Preset steering, electronic
moon roof, power windows,
theft deterrent system
20IG SW40Starting system
21DOOR30
Theft deterrent system, seat
control system, fuel opener
control system, power door
lock system
22DOME10
Interior light, personal lights,
door courtesy lights, ignition
switch light, open door
warning light, trunk light,
electronic moon roof system,
preset steering system, seat
belt reminder system, cruise
control system, air
conditioning system, inside
rear view mirror, door lock
and theft deterrent system,
foot light, power rear view
mirror, locking with wireless
remote control system,
passenger 's seat control
system.
23EFI30Multiport fuel injection
system/sequential multiport
fuel injection system
24HAZ±HORN15Emergency flashers, horns
No.FUSEAMPERECIRCUIT
25RADIONO.120Radio, cassette tape player,
compact disc player, power
antenna
26TEL15Telephone
27ALT
SENCING7.5Charging system
28ETCS15Traction control system
29HEAD(RH±LWR)*115Right±hand headlight (low
beam)
30HEAD(LH±LWR)*215Left±hand headlight (low
beam)
30DRL7.5Daytime Running Light
System
29HEAD(RH±LPR)15Right±hand headlight (high
beam)
30HEAD(LH±LPR)15Left±hand headlight (high
beam)
31INJ30SC300
Starting system
*1 SC300: HEAD (RH)
*2 SC300: HEAD (LH)