oil type LINCOLN CONTINENTAL 1996 Customer Assistance Guide

Use only the type of engine oil that Ford
recommends. See Engine oil recommendations
in the Index. Do not use special "break-in" oils.
Cleaning the Outside of Your
Vehicle
Washing and Polishing Your Vehicle
Wash the outside of your vehicle, including the
underside, with a mild detergent.
DO NOT: Wash your vehicle with hot water Wash your vehicle while it sits in direct
sunlight Wash your vehicle while the body is hot
Pollen, bird droppings a . nd tree sap can damage
the paint, especially in hot weather. Wash your
vehicle as often as necessary to keep it clean.Take similar precautions if your vehicle is
exposed to chemical industrial fallout.
Paint damage resulting from fallout is not related
to a defect in paint materials or workmanship and
therefore is not covered by warranty. Ford,
however, believes that continual improvement in
customer satisfaction is a high priority. For this
reason, Ford has authorized its dealers to repair,
at no charge to the owner, the surfaces of new
vehicles damaged by environmental fallout within
12 months or 12,000 miles (20,000 km) of
purchase, whichever comes first. Customers may
be required to bring their vehicle in for inspection
by a Ford representative.
Polish your vehicle to remove harmful deposits
and protect the finish.
7

Brake Fluid
Under normal circumstances, your vehicle should
not use up brake fluid rapidly. However, expect the
level of the brake fluid to slowly fall as you put
more mileage on your vehicle and the brake lining
wears.
You should check the brake fluid at every scheduled
engine oil change, but be sure to check it at least
once a year. You can do this by looking at the fluid
level in the plastic reservoir on the master cylinder.
(See The Engine Type in this chapter to locate the
master cylinder.) The fluid level should be at or near
the MAX mark./!\ WARNINGBrake fluid is toxic.If brake fluid contacts eyes, flush eyes with running
water for 15 minutes. Get medical attention ifirritation persists. If taken internally, drink water and
induce vomiting. Get medical attention immediately.
If the fluid is low, carefully clean and remove the cap
from the reservoir. Fill the reservoir to the MAX
line with Ford High Performance DOT 3 Brake Fluid
C6AZ-19542-AA, C6AZ-19542-BA, or equivalent
DOT 3 fluid meeting Ford specification ESA-
M6C25-A./!\ WARNINGIf you use a brake fluid that is not DOT 3, youwill cause permanent damage to your brakes.Do not fill the reservoir above the MAX line.
If you find that the fluid level is excessively low
below the seam or ridge on the outside of the plastic
reservoir - have the brake system inspected.
263