battery LINCOLN MKX 2013 Rear Seat Entertainment System Supplement Manual
[x] Cancel search | Manufacturer: LINCOLN, Model Year: 2013, Model line: MKX, Model: LINCOLN MKX 2013Pages: 32, PDF Size: 3.87 MB
Page 6 of 32
6Welcome
Welcome
Thank you for purchasing this REVOLUTION
headrest video monitor with built-in DVD player.
Before operating this system, read this manual
thoroughly and retain it for future reference.
Important Notice
It is unlawful in most jurisdictions for a person
to drive a motor vehicle which is equipped with
a television viewer or screen that is located in
the motor vehicle at any point forward of the
back of the driver’s seat, or that is visible, dire
ct-
ly or indirectly, to the driver while operating the
vehicle. In the interest of safety, the unit should
never be installed where it will be visible, direct -
ly or indirectly, by the operator of the motor
vehicle. If your vehicle is equipped with a wire-
less rear seat audio system or any other wireless
IR device, power system of in order to operate
the DVD headrest system. If system is powered
on, the two systems may interfere with each
other canceling out or creating undesirable
audio through the wireless headphones.
Safety Precaution
For safety reasons, when changing video disc
it is recommended that the vehicle not be in
motion, and that you do not allow children
to unfasten safety belts to change disc or
make any adjustments to the system. System
adjustments can be accomplished using the
remote control unit, while safety belts remain
fastened. Enjoy your entertainment system
but remember that safety of all passengers
remains the number one priority.
Product Features
t 7-inch Color TFT-LCD Panel
(480x234) with 16:9 aspect
t Built-in Top-Loading Slot load DVD Player
t Infrared Transmitters for IR Wireless Head-
phones
t Audio/Video Source Input- 3 RCA Jacks
t USB 2.0 (optional)
t 1/8-inch Stereo Headphone Jack
t Forward Remote Sensor on the Front Panel t
Full Function Remote Control
t 5 Control Buttons on the Front Panel-
POWER, SOURCE, STOP, PLAY, EJECT
t OSD (On Screen Display) Control
t 12V DC Power Input
t FM Transmitter (may be optional)
Caution:
t Do not touch the inner pins of the jacks on
the front panel. Electrostatic discharge may
cause permanent damage to the device.
t Be sure to run the vehicle engine while us-
ing the device. Using this device without
running the engine can result in battery
drainage. To avoid the risk of battery
drainage, please remember to turn of the
device when the vehicle is not in use for
long periods of time.
Page 11 of 32
11Remote Control Operations
EN
Remote Control Operations
Installing the Battery
Before attempting to operate your remote con-
trol, install the batteries as described below.
1. Turn the remote control face down. Press down on the ridged area of the battery
cover and slide it of.
2. Install two “AAA” batteries as shown. Make sure that proper polarity (+ or -) is
observed.
3. Slide the cover back until it clicks.
The remote control will only operate this device.
It is not a universal remote control and will not
control other equipment.
Warning/Caution on using batteries
t Always ensure that the batteries are
inserted with the positive and negative
terminals in the correct direction as shown
in the battery compartment.
t Diferent types of batteries have diferent
characteristics. Do not mix diferent types.
t Do not mix old and new batteries. Mixing
old and new batteries will shorten battery
life and/or cause chemical leaks from the
old batteries.
t When batteries fail to function, replace
them immediately.
t Keep the batteries out of the reach of
children. Should the batteries be swal-
lowed, immediately consult a doctor. Also,
when disposing of used batteries, please
comply with governmental regulations or
environmental public institution rules that
apply in your country/area.
t Remove the batteries if the remote control
is not used for a month or longer.
Page 24 of 32
24Connecting a MP3 Device
Connecting a MP3 Device
Connecting a MP3 Device to your REV LT
Unit via USB
Plug the MP3 Dock Connector to USB cable
into a high-power USB port on your REV LT
unit, and then connect the other end to the
player.
See the documentation that came with your
device for more information.
Charging the MP3 Player Battery
Connect the device to the USB port on your
REV LT unit. The REV LT unit must be turned on.
Depending on the device, it may or may not
charge when connected to the USB port.
Note: Not all devices are able to charge when
connected to the USB port.
Connecting a MP3 Device to your
REV LT Unit via AV cable
t Connect the device using an AV cable to
the headphones port . Note: Use the AV
cable made specifcally for the device.
Other similar RCA-type cables might not
work.
t Connect the video and audio connectors
to the AV-IN ports on your REV LT unit, as
shown. EN