recommended oil LINCOLN TOWN CAR 1998 Owners Manual
[x] Cancel search | Manufacturer: LINCOLN, Model Year: 1998, Model line: TOWN CAR, Model: LINCOLN TOWN CAR 1998Pages: 188, PDF Size: 1.29 MB
Page 137 of 188
Ford production and aftermarket
(Motorcraft) oil filters are designed
for added engine protection and
long life. If a replacement oil filter
is used that does not meet Ford
material and design specifications,
startup engine noises or knock
may be experienced.
It is recommended you use the
appropriate Motorcraft oil filter (or
another brand meeting Ford
specifications) for your engine
application.
BRAKE FLUID
Checking and adding brake
fluid
Brake fluid should be checked and
refilled as needed at least once
each year:
1. Clean the reservoir cap before
removal to prevent dirt or water
from entering the reservoir.
2. Visually inspect the fluid level.
3. If necessary, add brake fluid
until the level reaches MAX. Do
not fill above this line.
4. Use only a DOT 3 brake fluid
certified to meet Ford
specifications. Refer toLubricant
specificationsin theCapacities
and specificationschapter.
MAX
MIN
Maintenance and care
138
Page 188 of 188
Recommended fuel Refer to9Octane recommendations9in the
Maintenance and carechapter
Fuel tank capacity 71.9L (19.0 gallons)
Engine oil capacity (with
filter change)4.7L (5.0 quarts). Use Motorcraft 5W30
Super Premium Motor Oil, Ford
Specification WSS-M2C153-G
Automatic transmission
fluid capacity13.1L (13.9 quarts). Use Motorcraft
MERCONtV ATF (part# XT-5-QM), Ford
Specification WSS-M2C202-B
Tire pressure and size Refer to the Safety Compliance
Certification Label located on the front
face of the driver's door jamb
Hood release Pull handle under the left side of the
instrument panel
Coolant capacity 13.3L (14.1 quarts)
Power steering fluid
capacityFill to line in reservoir. Use Motorcraft
MERCONtAT F
Ensure correct automatic
transmission fluid is used for a
specific application. Check the
container to verify the fluid is
MERCONtand/or MERCON Vt
approved. Some fluids have been
approved as meeting both
MERCONtand MERCONtV
requirements and will be labeled as
such. Fluids labeled as meeting
only MERCONtor only MERCONt
V requirements must not be used
interchangeably. DO NOT mix
MERCONtand MERCONtV.
Transmission fluid requirements
are indicated on the dipstick or on
the dipstick handle. Refer to your
ªService Guideº to determine the
correct service interval.
Filling station information
192