start stop button LUCID AIR 2023 Owners Manual

total distance, and traffic conditions along the
route. If the route requires charging stops to reach the destination, then charging stops will
automatically be added and shown on this
screen as well.
Note: Because the Auto )add Charging
feature is enabled by default, the system
automatically calculates the battery power
needed for the trip and the recommended charging time for each charging stop.
Once the route has started, the turn-by-
turn guidance instructions are shown on the
top navigation screen. Lane guidance, exit
numbers, and other guidance details will be
displayed when appropriate. While routing, if the navigation is replaced with media or
phone, navigation instructions will remain in
view in the Center Cockpit Panel while a route
is in progress.
The MANAGE tab summarizes the stops and their specific details. The DETAILS tab lists
every turn and stop along your route.
When the system automatically adds charging stops, extra details are provided for eachstop such as estimated percent on arrival,
suggested plug type to use, suggested number
of minutes to charge for, and suggested
minimum percent to charge up to. This
information will persistently show in both the
DETAILS tab and the MANAGE tab until your
route ends.You can also tap each Waypoint on
the Route directly from the map view to see
more details.
When starting a trip, we initially show you in
the smart drawer a full list of instructions.
This list automatically minimizes after thirty
seconds, to use the full screen for viewing
your maps and route. The route will display all
of your stops and traffic conditions. The smart
drawer with the list of instructions and details
about your stops can be manually reopened.
You can add, reorder, or delete stops.
If at any point you deviate from the route,
the system will quickly and automatically
recalculate a new route and immediately give
new guidance instructions.
While routing, if you have to stop and turn
off the vehicle, and you come back and turn on the vehicle, the route will continue to be
present on the screen.
Press END or use voice commands ("Alexa,
cancel navigation") to end navigation.
The Lucid navigation system will periodically
check that predicted charge on arrival is
still correct. It checks everytime you finish
charging, everytime you reach a low state
of charge, and every fifteen minutes while
routing. If the EV routing conditions have
significantly changed and the route needs to
be refreshed, a notification will appear and
will ask you to agree to a new route.
If for some reason the EV route requires
charging, but a fast charger could not be
automatically added along the route, then
an Insufficient Charge notification will be
shown inside navigation. In this case, we
recommend that you manually search for charging. Usually, slow chargers can be found
along the route and can be used.
Note: When Routing starts, a Mute button will
appear on the top navigation screen, which
enables you to turn off the audio guidance.
Adjusting the Map
The maps on either the ICR and CID
screen can be individually rotated, panned,
or zoomed in and out via the touchscreen.
Any time the map is manipulated beyond your vehicle