check oil MAZDA MODEL 2 2019 Owners Manual (in English)

¾The front doors or the boot is not fully closed.
¾The vehicle is on a road incline.
¾The door mirrors are retracted.
¾Do not hit the front/rear camera, front bumper, and door mirrors forcefully. The camera
position or installation angle may shift.
¾The cameras are of a waterproof structure. Do not disassemble, modify, or remove a
camera.
¾The camera cover is made of hard plastic, therefore do not apply oil film remover, organic
solvents, wax, or coating agents. If any such agent gets on the camera cover, wipe it off
using a soft cloth immediately.
¾Do not rub the camera lens forcefully, or clean it with an abrasive or hard brush. Otherwise,
it could scratch the camera lens and negatively affect the images.
¾Consult an expert repairer (we recommend an Authorised Mazda Repairer) for repair,
painting, or replacement of the front/rear camera, front bumper and door mirrors.
¾Heed the following cautions to assure that the 360°View Monitor operates normally.
¾Do not modify the vehicle suspensions or lower/raise the vehicle body, or both.
¾Always use wheels of the specified type and size for the front and rear wheels. Consult an
expert repairer (we recommend an Authorised Mazda Repairer) for tyre replacement.
¾When the display is cold, images may leave trails or the screen might be darker than usual,
making it difficult to check the vehicle surroundings. Always confirm the safety at the front
and around the vehicle visually when driving.
¾The method for parking/stopping the vehicle using the 360°View Monitor differs depending
on the road circumstances/conditions and the vehicle conditions. When and how much you
turn the steering wheel will differ depending on the situation, , therefore always check the
vehicle surroundings directly with your eyes while using the system.
Also, before using the system, always make sure that the vehicle can be parked/stopped in
the parking/stopping space.
NOTE
xIf there are water droplets, snow, or mud on the camera lens, wipe it off using a soft cloth.
If the camera lens is especially dirty, wash it off with mild detergent.
xIf the area where the camera is installed, such as the boot (Saloon)/rear bumper
(Hatchback) or door mirrors, has been damaged in a vehicle accident, the camera
(position, installation angle) may have shifted. Always consult an expert repairer (we
recommend an Authorised Mazda Repairer) to have the vehicle inspected.
xIf the camera is subjected to excessive changes in temperature such as by pouring hot
water on the camera during cold weather, the 360°View Monitor may not operate
normally.
xIf the battery voltage is low, the screen might be temporarily difficult to view, however,
this does not indicate a problem.
:KHQ'ULYLQJ
L$&7,96(16(