headlights MAZDA MODEL 3 HATCHBACK 2015 (in English) Owner's Manual
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2015, Model line: MODEL 3 HATCHBACK, Model: MAZDA MODEL 3 HATCHBACK 2015Pages: 689, PDF Size: 7.08 MB
Page 259 of 689
4–109
When Driving
i-ACTIVSENSE
NOTE
Under the following conditions, the LDWS may not be able to detect white or yellow
lines correctly and the LDWS may not operate correctly.
If an object placed on the instrument panel is refl ected in the windscreen and picked
up by the camera.
Heavy luggage is loaded in the luggage compartment or on the rear seat and the
vehicle is inclined.
The tyre pressures are not adjusted to the specifi ed pressure.
When the vehicle is driven on the entry and exit to or from the rest area or tollgate of
a highway.
The white or yellow lines are less visible because of dirt or paint fl aking.
The vehicle ahead is running near a white or yellow line and the line is less visible.
A white or yellow line is less visible because of bad weather (rain, fog, or snow).
The vehicle is driven on a temporary lane or section with a closed lane due to
construction.
A misleading line is picked up on the road such as a temporary line for construction,
or because of shade, lingering snow, or grooves fi lled with water.
The surrounding brightness suddenly changes such as when entering or exiting a
tunnel.
The illumination of the headlights is weakened because of dirt or the optical axis is
deviated.
The windscreen is dirty or foggy.
Back-light is refl ecting from the road surface.
The road surface is wet and shiny after rain, or there are puddles on the road.
The shade of a guardrail parallel to a white or yellow line is on the road.
The width of a lane is excessively narrow or wide.
The road is excessively uneven.
The vehicle is shaken after hitting a road bump.
There are two or more adjacent white or yellow lines.
There are various road markings or lane markings of various shapes near an
intersection.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 546 of 689
6–50
Maintenance and Care
Owner Maintenance
Light Bulbs
Saloon HatchbackWith Xenon Fusion Headlights
With Halogen Headlights
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 547 of 689
*Some models.6–51
Maintenance and Care
Owner Maintenance
Headlights (Low/High beam)
Running lights
Headlights (Low beam)
Headlights (High beam)/Running lights *
Front fog lights *
Front direction indicator lights
Position lights
Side direction indicator lights
Brake lights (With xenon fusion headlights)
Tail lights (With xenon fusion headlights)
Brake lights/Tail lights (With halogen headlights)
Rear direction indicator lights
Tail lights (With xenon fusion headlights)
Reverse lights
Rear fog light *
Reverse light (Left-hand drive model)
Reverse light (Right-hand drive model)
Rear fog light *1 /Reverse light *2 (Left-hand drive model)
Rear fog light *1 /Reverse light *2 (Right-hand drive model)
High-mount brake light
Number plate lights
Overhead lights (Front)/Map lights
Vanity mirror lights *
Overhead lights (Rear) *
Boot light (Saloon)
Luggage compartment light (Hatchback)
*1 With rear fog light
*2 Without rear fog light
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 548 of 689
6–52
Maintenance and Care
Owner Maintenance
WARNING
Do not replace the xenon fusion bulbs
yourself:
Replacing the xenon fusion bulbs
yourself is dangerous. Because the
xenon fusion bulbs require high
voltage, you could receive an electric
shock if the bulbs are handled
incorrectly. Consult an expert repairer,
we recommend an Authorised Mazda
Repairer when the replacement is
necessary.
Never touch the glass portion of a
halogen bulb with your bare hands
and always wear eye protection when
handling or working around the bulbs:
When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurised gas. If one is broken, it will
explode and serious injuries could be
caused by the fl ying glass.
If the glass portion is touched with bare
hands, body oil could cause the bulb to
overheat and explode when lit.
Always keep halogen bulbs out of the
reach of children:
Playing with a halogen bulb is
dangerous. Serious injuries could be
caused by dropping a halogen bulb or
breaking it some other way.
NOTE
To replace the bulb, contact an
expert repairer, we recommend an
Authorised Mazda Repairer.
If the halogen bulb is accidentally
touched, it should be cleaned with
rubbing alcohol before being used.
Use the protective cover and carton
for the replacement bulb to dispose
of the old bulb promptly and out of
the reach of children.
Replacing Exterior Light Bulbs
Headlights (With xenon fusion
headlights)
Low/High beam bulbs
You cannot replace the low/high beam
bulbs by yourself. The bulbs must
be replaced at an expert repairer, we
recommend an Authorised Mazda
Repairer.
Headlights (With halogen headlights)
Low-beam bulbs
1. If you are changing the right bulb, start
the engine, turn the steering wheel all
the way to the left, and turn off engine.
If you are changing the left bulb, turn
the steering wheel to the right, and turn
off engine.
2. Make sure the headlight switch is off.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 551 of 689
6–55
Maintenance and Care
Owner Maintenance
Running lights/Position lights (With
xenon fusion headlights)
Due to the complexity and diffi culty
of the procedure, the LED bulbs must
be replaced by an expert repairer, we
recommend an Authorised Mazda
Repairer.
NOTE
LED bulb replacement is not possible
because it is built into the unit. Replace
the unit.
Front direction indicator lights, Position
lights (With halogen headlights)
1. If you are changing the right bulb, start
the engine, turn the steering wheel all
the way to the left, and turn off engine.
If you are changing the left bulb, turn
the steering wheel to the right, and turn
off engine.
2. Make sure the headlight switch is off.
3. Pull the centre of each plastic retainer
and remove the retainers.
Removal
Installation
4. Turn the screw anticlockwise and
remove it, and then partially peel back
the mudguard.
5. Turn the socket and bulb assembly
anticlockwise and remove it.
6. Disconnect the bulb from the socket.
Front direction indicator lights
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 552 of 689
*Some models.6–56
Maintenance and Care
Owner Maintenance
Position lights (With halogen
headlights)
7. Install the new bulb in the reverse order
of the removal procedure.
Front fog lights
*
1. If you are changing the right bulb, start
the engine, turn the steering wheel all
the way to the left, and turn off engine.
If you are changing the left bulb, turn
the steering wheel to the right, and turn
off engine.
2. Make sure the fog light switch is off.
3. Pull the centre of each plastic retainer
and remove the retainers.
Removal
Installation
4. Turn the screw anticlockwise and
remove it, and then partially peel back
the mudguard.
5. Disconnect the connector from the unit
by pressing the tab on the connector
with your fi nger and pulling the
connector downward.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 562 of 689
6–66
Maintenance and Care
Owner Maintenance
3. Pull the fuse straight out with the
fuse puller provided on the fuse block
located in the engine compartment.
4. Inspect the fuse and replace it if it is
blown.
NormalBlown
5. Insert a new fuse of the same amperage
rating, and make sure it fi ts tightly. If
it does not fi t tightly, have an expert
install it. We recommend an Authorised
Mazda Repairer.
If you have no spare fuses, borrow one
of the same rating from a circuit not
essential to vehicle operation, such as
the AUDIO or OUTLET circuit.
CAUTION
Always replace a fuse with a genuine
Mazda fuse or equivalent of the same
rating. Otherwise you may damage the
electric system.
6. Reinstall the cover and make sure that
it is securely installed.
Replacing the fuses under the bonnet
If the headlights or other electrical
components do not work and the fuses
in the cabin are normal, inspect the fuse
block under the bonnet. If a fuse is blown,
it must be replaced. Follow these steps:
1. Make sure the ignition is switched off,
and other switches are off.
2. Remove the fuse block cover.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 565 of 689
*Some models.6–69
Maintenance and Care
Owner Maintenance
DESCRIPTION FUSE
RATING PROTECTED COMPONENT
19 CNG 15 A —
20 AT 15 A Transaxle control system
21 R.WIPER 15 A Rear window wiper
*
22 A/C 7.5 A Air conditioner
23 ENGINE3 15 A Engine control system
24 ENGINE2 15 A Engine control system
25 ENGINE1 15 A Engine control system
26 GLOW SIG 5 A Engine control system
*
27 EVVT 20 A Engine control system *
28 WIPER 20 A Front window wiper and washer
29 DCDC REG 30 A For protection of various circuits *
30 FUEL PUMP2 30 A —
31 ADD FAN DE 40 A Cooling fan *
32 P.WINDOW1 30 A Power windows
33 H/L LOW R 15 A Headlight low beam (RH) *2
34 H/L LOW L
HID L 15 A Headlight (LH) *1 , Headlight low beam (LH) *2
35 METER1 10 A Instrument cluster
36 IG2 30 A For protection of various circuits
37 LPG 30 A —
38 FAN DE 40 A Cooling fan
*
39 DCDC DE 40 A For protection of various circuits *
40 SRS1 7.5 A Air bag
41 ENGINE. IG1 15 A Engine control system
42 C/U IG1 15 A For protection of various circuits
43 — — —
*1 With xenon fusion headlights
*2 With halogen headlights
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 666 of 689
*Some models.9–12
Specifi cations
Specifi cations
Light Bulbs
Exterior light
Light bulb Category
Wattage UNECE *1
(SAE)
Headlights With xenon
fusion bulb
headlights High/Low beam 35 D4S (D4S)
With
halogen bulb
headlights High beam With running
lights 55 H15 (—)
Without
running lights 60 HB3 (9005)
Low beam 55 H11 (H11)
Running lights With xenon fusion bulb headlights LED
*2 — (—)
With halogen bulb headlights * 15 H15 (—)
Position lights With xenon fusion bulb headlights LED *2 — (—)
With halogen bulb headlights 5 W5W (—)
Front fog lights
* 55 H11 (H11)
Front direction indicator lights 21 WY21W
(7443NA)
Side direction indicator lights LED
*2 — (—)
High-mount brake light LED *2 — (—)
Rear direction indicator lights 21 WY21W
(7443NA)
Brake lights (With xenon fusion bulb headlights) LED
*2 — (—)
Tail lights (With xenon fusion bulb headlights) LED *2 — (—)
Brake lights/Tail lights (With halogen bulb headlights) 21/5 W21/5W (7443)
Reverse lights Saloon 16 W16W (921)
Hatchback 21 W21W (7440)
Rear fog light
* 21 W21W (7440)
Number plate lights 5 W5W (—)
*1 UNECE stands for United Nations Economic Commission for Europe.
*2 LED is the abbreviation for Light Emitting Diode.
. B [ E B @ & ' & & " @ & E J U J P O J O E C
Page 674 of 689
9–20
Specifi cations
Personalisation Features
Item Feature Factory
Setting Available
Settings Settings change method
Vehicle Auto-light
control
Refer to
Headlights
on page
4-62 . The headlight
illumination on/
off timing based on
surrounding lightness/
darkness can be
changed. Medium High/
Med. High/
Medium/
Med. Low/
Low
Refer to
Settings
on page
5-71 . —
Auto
headlight
off
*4
Refer to
Headlights
on page
4-62 . The time required
for headlights to turn
off after ignition is
switched off can be
changed. 30 seconds 120 seconds/
90 seconds/
60 seconds/
30 seconds/
Off
*5
Refer to
Settings
on page
5-71 . —
High Beam
Control
System
(HBC)
Refer to
High Beam
Control
System
(HBC) on
page 4-104 . The High Beam Control
System (HBC) function
can be changed.
*1 On On/Off Refer to
Settings
on page
5-71 . —
Lights-on
reminder*6
Refer to
Lights-On
Reminder on
page 7-49 . The volume of the
lights-on reminder
warning alarm can be
changed. High or Off High/Low/
Off Refer to
Settings
on page
5-71 . —
Coming
home light
system
Refer to
Coming
Home Light
System on
page 4-68 . The time required for
the headlights to turn
off after closing all
of the doors can be
changed. 30 seconds 120 seconds/
90 seconds/
60 seconds/
30 seconds/
Off — —
Leaving
home light
system
Refer to
Leaving
Home Light
System on
page 4-68 . The leaving home light
system function can be
changed. On or Off On/Off — —
. B [ E B @ & ' & & " @ & E J U J P O J O E C