brake MAZDA MODEL 626 2001 Owner's Guide

Form No. 8P95-EA-00G
*Some models.
In Case of Emergency
6-15
DESCRIPTION
FUSE
RATING
PROTECTED COMPONENT
13
P. WIND
30A
Power windows*
14
—
—
—
15
RADIO
15A
Audio system*, Socket, outside mirror
16
ENGINE
10A
Engine control system
17
ILLUMI
10A
Tail light, License plate lights, parking lights, Dashboard
illumination
18
STOP
15A
Brake lights, Horn, Cruise control*
19
CIGAR
15A
Accessory socket, clock*, radio*, outside mirror
20
—
—
—
21
—
—
—
22
P. SEAT
30A
Power seat*
23
M. DEF
15A
Mirror defroter*
24
P. POINT
15A
Power point

Form No. 8P95-EA-00G
In Case of Emergency6-16
Q075-1A1E
Towing
Wheel dollies
J94S6005We recommend that towing be done
only by an Authorized Mazda Dealer
or a commercial tow-truck service.
Proper lifting and towing are
necessary to prevent damage to the
vehicle. State and local laws must be
followed.A towed vehicle usually should have
its front wheels off the ground. If
excessive damage or other conditions
prevent this, use wheel dollies.
When towing with the rear wheels on
the ground, release the parking brake.
075-2AE
J94S6001
CAUTION
!
Don’
t tow the vehicle backward
with driving wheels on the ground.
This may cause internal damage to
the transaxle.

Form No. 8P95-EA-00G
In Case of Emergency
6-21

076-6A3E
 Changing a Flat TireNOTEIf the following occurs while
driving, it could indicate a flat tire.
•Steering becomes difficult.
• The vehicle begins to vibrate
excessively.
• The vehicle pulls in one
direction.If you have a flat tire, drive slowly to a
level spot that is well off the road and
out of the way of traffic to change the
tire. Stopping in traffic or on the
shoulder of a busy road is dangerous.
WARNING
!
Jacking a Vehicle:Changing a tire can be
dangerous. The vehicle can slip
off the jack and seriously injure
someone.
Be sure to follow the directions
for changing a tire, and never get
under a vehicle that is supported
only by a jack.

076-31AE
To change a flat tire, follow procedure
1 through 15 carefully.
Q076-7A1E
Wheel block Flat tireJ94A50161. Park on a level surface off the
right-of-way and firmly set the
parking brake.
2. Shift an automatic transaxle to P or shift a manual transaxle to R, and
turn off the engine.

Form No. 8P95-EA-00G
Appearance Care7-8Pay special attention to removing salt,
dirt, mud, and other foreign material
from the underside of the wings, and
make sure the drain holes in the lower
edges of the doors and rocker panels
are clean.
Insects, tar, tree sap, bird droppings,
industrial fallout, and similar deposits
can damage the finish if not removed
immediately. When prompt washing
with plain water is ineffective, use a
mild soap made for use on vehicles.
Thoroughly rinse off all soap with
lukewarm or cold water. Don’t allow
soap to dry on the finish. After washing the vehicle, dry it with a
clean chamois to prevent water spots
from forming.
WARNING
!
Driving with Wet Brakes:Driving with wet brakes is
dangerous. Increased stopping
distance or the vehicle pulling to
one side when braking could
result in a serious accident. Light
braking will indicate whether the
brakes have been affected. Dry
the brakes by driving very slowly
and applying the brakes lightly
until brake performance is
normal.

Waxing
Your vehicle needs to be waxed when
water no longer beads on the finish.
Always wash and dry the vehicle
before waxing it. In addition to the
vehicle body, wax the metal trim to
maintain its luster.
1. Use wax which contains no abrasives. Waxes containing
abrasive will remove paint and
could damage bright metal parts.
2. Use a good grade of natural wax for metallic, mica, and solid colors.
3. When waxing, coat evenly with the sponge supplied or a soft cloth.

Form No. 8P95-EA-00G
Appearance Care7-10
078-5A1E

Underbody Maintenance
Road chemicals and salt used for ice
and snow removal and solvents used
for dust control may collect on the
underbody. If not removed, they will
speed up rusting and deterioration of
such underbody parts as fuel lines,
frame, floor pan, and exhaust system,
even though these parts may be coated
with anticorrosive material.
Thoroughly flush the underbody and
wheel housings with lukewarm or cold
water at the end of each winter. Try
also to do this every month.
Pay special attention to these areas
because they easily hide mud and dirt. It will do more harm than good to
wet down the road grime without
removing it.
The lower edges of doors, rocker
panels, and frame members have drain
holes that should not be clogged.
Water trapped there will cause rusting.
WARNING
!
Driving with Wet Brakes:Driving with wet brakes is
dangerous. Increased stopping
distance or the vehicle pulling to
one side when braking could
result in a serious accident. Light
braking will indicate whether the
brakes have been affected. Dry
the brakes by driving very slowly
and applying the brakes lightly
until brake performance is
normal.

Form No. 8P95-EA-00G
Maintenance
8-3


082-1AE
Scheduled MaintenanceFollow Schedule 1 if the vehicle is operated mainly where none of the followin\
g conditions applies.
If any of them apply, follow Schedule 2 (Puerto Rico residents follow Schedule 2).
• Repeated short-distance driving
• Driving in dusty conditions
• Driving with an extended use of brakes
• Driving in areas where salt or other corrosive materials are being used
• Driving on rough or muddy roads
• Extended periods of idling or low-speed operation
• Driving for a prolonged period in cold temperatures or extremely humid c\
limates

Form No. 8P95-EA-00G
I: Inspect and repair, clean, adjust, or replace if necessary
(Oil-permeated air filter cannot be cleaned using the air-blow method.)
R : Replace
Maintenance
8-5
Schedule 1 (Cont’d)
MAINTENANCE
INTERVALS
Number of months or miles (kilometers), whichever comes first
INTERVALS
Months
6
12
18
24
30
36
42
48
MAINTENANCE

1000 km
12
24
36
48
60
72
84
96
MAINTENANCE

ITEM
(
1000 miles)
(7.5)
(15)
(22.5)
(30)
(37.5)
(45)
(52.5)
(60)
Hoses and tubes for emission
I*
1
Air filter
R
R
Spark plugs
2.0-liter engine
R
R
Spark plugs
2.5-liter engine
Replace every 96,000 km (60,000 miles)
Idle speed
I
I
Fuel lines and hoses
I*1
I*1
Cooling system
I
I
Engine coolant
Replace at first 168,000 km (105,000 miles) or 60 months;
after that, every 48,000 km (30,000 miles) or 24 months
Brake lines, hoses and connections
I
I
*1 According to state and federal regulations, failure to perform maintenan\
ce on these items will not void your emissions warranties. However, Mazda
recommends that all maintenance services be performed at the recommended\
time or kilometrage (mileage) period to ensure long-term reliability.

Form No. 8P95-EA-00G
I: Inspect and repair, clean, adjust, or replace if necessary
L : Lubricate
Maintenance8-6Schedule 1 (Cont ’d)
MAINTENANCE
INTERVALS
Number of months or miles (kilometers), whichever comes first
INTERVALS
Months
6
12
18
24
30
36
42
48
MAINTENANCE

1000 km
12
24
36
48
60
72
84
96
MAINTENANCE

ITEM
(
1000 miles)
(7.5)
(15)
(22.5)
(30)
(37.5)
(45)
(52.5)
(60)
Drum brakes
I
I
Disc brakes
I
I
Steering operation and linkages
I
I
Front suspension ball joints
I
I
Driveshaft dust boots
I
I
Bolts and nuts on chassis and body
I
I
Exhaust system heat shields
I
I
All locks and hinges
L
L
L
L
L
L
L
L
Air-conditioner refrigerant (if installed)
I
I
I
I
Air-conditioner compressor (if installed)
I
I
I
I

Form No. 8P95-EA-00G
I: Inspect and repair, clean, adjust, or replace if necessary
(Oil-permeated air filter cannot be cleaned using the air-blow method.)
R : Replace
Maintenance8-8Schedule 2 (Cont ’d)
MAINTENANCE
INTERVALS
Number of months or miles (kilometers), whichever comes first
INTERVALS
Months
4
8
12
16
20
24
28
32
36
40
44
48
MAINTENANCE

1000 km
8
16
24
32
40
48
56
64
72
80
88
96
MAINTENANCE

ITEM
(
1000 miles)
(5)
(10)
(15)
(20)
(25)
(30)
(35)
(40)
(45)
(50)
(55)
(60)
Spark plugs
2.0-liter engine
R
R
Spark plugs
2.5-liter engine
Replace every 96,000 km (60,000 miles)
Idle speed
I
I
Fuel lines and hoses
I*1
I*
1
Cooling system
I
I
Engine coolant
Replace at first 168,000 km (105,000 miles) or 60 months;
after that, every 48,000 km (30,000 miles) or 24 months
Engine coolant level
I
I
I
I
I
I
I
I
I
I
I
I
Function of all lights
I
I
I
I
I
I
I
I
I
I
I
I
Brake lines, hoses and connections
I
I
*1 According to state and federal regulations, failure to perform maintenan\
ce on these items will not void your emissions warranties. However, Mazda
recommends that all maintenance services be performed at the recommended\
time or kilometrage (mileage) period to ensure long-term reliability.

Form No. 8P95-EA-00G
I: Inspect and repair, clean, adjust, or replace if necessary
L : Lubricate
Maintenance
8-9
Schedule 2 (Cont ’d)
MAINTENANCE
INTERVALS
Number of months or miles (kilometers), whichever comes first
INTERVALS
Months
4
8
12
16
20
24
28
32
36
40
44
48
MAINTENANCE

1000 km
8
16
24
32
40
48
56
64
72
80
88
96
MAINTENANCE

ITEM
(
1000 miles)
(5)
(10)
(15)
(20)
(25)
(30)
(35)
(40)
(45)
(50)
(55)
(60)
Brake and clutch fluid level
I
I
I
I
I
I
I
I
I
I
I
I
Drum brakes
I
I
Disc brakes
I
I
I
I
Tire inflation pressure and tire wear
I
I
I
I
I
I
I
I
I
I
I
I
Steering operation and linkages
I
I
Power steering fluid level
I
I
I
I
I
I
I
I
I
I
I
I
Front suspension ball joints
I
I
Driveshaft dust boots
I
I
Bolts and nuts on chassis and body
I
I
I
I
Exhaust system heat shields
I
I
All locks and hinges
L
L
L
L
L
L
L
L
L
L
L
L