maintenance MAZDA MODEL 626 2001 Workshop Manual

Form No. 8P95-EA-00G
Maintenance
8-41
WARNING
!
Using Wrong-Sized Tires:Using any other tire size than
what is specified for your Mazda
(page 10-6) is dangerous. It could
seriously affect ride, handling,
ground clearance, tire clearance,
and speedometer calibration. This
could cause you to have an
accident. Use only tires that are
the correct size specified for your
Mazda.
J94A3005_7GrTire inflation pressure
Inspect all tire pressures monthly
(including the spare) when the tires are
cold. Maintain recommended
pressures for the best ride, top
handling, and minimum tire wear. Refer to the specification charts (page
10-6).

Form No. 8P95-EA-00G
Maintenance8-42NOTE•Warm tires normally exceed
recommended pressures. Don’ t
release air from warm tires to
adjust the pressure.
• Underinflation can cause
reduced fuel economy and poor
sealing of the tire bead, which
will deform the wheel and
cause separation of tire from
rim.
• Overinflation can produce a
harsh ride and a greater
possibility of damage from road
hazards.
(Continued)
•Keep your tire pressure at the
correct levels. If one frequently
needs inflating, have it
inspected.
WARNING
!
Incorrect Tire Inflation:Overinflation or underinflation of
tires is dangerous. Adverse
handling or unexpected tire
failure could result in a serious
accident. Always inflate the tires
to the correct pressure (page
10-6).
083-34A2E
J94A7027_a (J18T7031)
Front
Do not include (TEMPORARY USE ONLY
spare tire) in rotation.
 Tire rotation
To equalize tread wear, rotate the tires
every 6,000 km (3,750 miles), or
sooner if irregular wear develops.
During rotation, inspect them for
correct balance.

Form No. 8P95-EA-00G
Maintenance
8-43
Also, inspect them for uneven wear
and damage. Abnormal wear is usually
caused by one or a combination of the
following:
•Incorrect tire pressure
• Improper wheel alignment
• Out-of-balance wheel
• Severe braking
After rotation, bring all tire pressures
to specification (page 10-6) and
inspect the lug nuts for tightness.
083-37AE
J94A7028
(J18Y7061+62)
New tread Worn tread
Tread wear indicator

Replacing a tire
If a tire wears evenly, a wear indicator
will appear as a solid band across the
tread. Replace the tire when this
happens. You may need to replace it
before the band is across the entire
tread.
083-38A1E
WARNING
!
Worn Tires:Driving with worn tires is
dangerous. Reduced braking,
steering, and traction could result
in an accident. Always use tires
that are in good condition.

Form No. 8P95-EA-00G
Maintenance8-44
083-39AE
 Temporary spare tire
Inspect the temporary spare tire at
least monthly to make sure it’ s
properly inflated and stored.
The temporary spare tire is easier to
handle because of its construction. It is
lighter and smaller than a conventional
tire and should be used only for an
emergency and only for a short
distance.
Use the temporary only until the
conventional tire is repaired, which
should be as soon as possible.
Maintain its pressure at 420 kPa (60
psi).
CAUTION
!
• Don’ t use your temporary spare
tire rim with a snow tire or a
conventional tire. Neither will
properly fit and could damage
both tire and rim.
• The temporary spare tire has a
tread life of up to 4,800 km
(3,000 miles), depending on
road conditions and driving
habits.
• When the tread wear solid-band
indicator appears, replace the
tire with the same type of
temporary spare.
Q083-40A2E
Replacing a wheel
When replacing a wheel, make sure
the new one is the same as the original
factory wheel in diameter, rim width,
and offset.
Proper tire balancing provides the best
riding comfort and helps reduce tread
wear. Out-of-balance tires can cause
vibration and uneven wear, such as
cupping and flat spots.

Form No. 8P95-EA-00G
Maintenance
8-45
WARNING
!
Using a Wrong-Sized Wheel:Using a wrong-sized wheel is
dangerous. Braking and handling
could be affected, leading to loss
of control and an accident.
Always use wheels of the correct
size on your vehicle.
CAUTION
!
A wrong-sized wheel may
adversely affect
•Tire fit
• Wheel and bearing life
• Ground clearance
• Snow-chain clearance
• Speedometer calibration
• Headlight aim
• Bumper height

083-41A1E
Do not touch the glass surface
J94A7029 Replacing a Headlight Bulb
Your Mazda’ s headlights have
replaceable halogen bulbs.

Form No. 8P95-EA-00G
Maintenance8-46
WARNING
!
Handling Halogen Bulbs:When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurized gas. If one is broken,
it will explode and serious injuries
could be caused by the flying
glass. If the glass portion is
touched with bare hands, body oil
could cause the bulb to overheat
and explode when lit. Never touch
the glass portion of the bulb with
your bare hands and always wear
eye protection when handling or
working around halogen bulbs.
WARNING
!
Children and Halogen Bulbs:Playing with a halogen bulb is
dangerous. Serious injuries could
be caused by dropping a halogen
bulb or breaking it some other
way. Always keep halogen bulbs
out of the reach of children.

083-42SE
Bolts
J94A7030
1. Make sure the headlight switch is off.
2. Lift the hood and find the bulb in
the rear of the headlight body.
3. (2.5-liter engine) Remove the bolts and the coolant
reservoir.

Form No. 8P95-EA-00G
Maintenance
8-47
J94A70314. Disconnect the electrical connectorfrom the bulb by squeezing the tabs
and pulling it to the rear.
Sealing
cover
Bulb
retaining
spring
J94A7032
5. Pull off the sealing cover.
6. Unhook the bulb retaining spring.
7. Swing the retaining spring out and
away to free the headlight bulb. 8. Carefully remove the headlight
bulb from the socket by pulling it
straight back.
9. Replace the bulb.
10. Install in the reverse order of removal.
NOTEUse the protective cover and
carton to dispose of the old bulb
promptly out of the reach of
children.

Form No. 8P95-EA-00G
The number in ( ) shows the bulb
number.
J94S8003
To replace the map light bulbs, contact
an Authorized Mazda Dealer.
Maintenance8-48

083-43AE
Replacing a Bulb (Front, Interior)Front-turn signal lights/
Parking lights 27/8W (1157NA)
J94A7033_a
Interior light 10W (–)
J94A7034
Courtesy lights 5W (–) J94S8004

Form No. 8P95-EA-00G
The number in ( ) shows the bulb
number.

Brake lights/Taillights27/7W (2057)

Rear-turn signal lights27W (1156NA)

Back up light 18W (921)
For bulb access:
Remove the
trunk end trim
J94A7035A
J94A7035A+J94S8005+06
J94S8006 J94S8005J94S8001–1
Maintenance
8-49

Q083-44A1E
Replacing a Bulb (Rear)

Form No. 8P95-EA-00G
The number in ( ) shows the bulb
number.
J94S8001–2
Maintenance8-50License plate light 5W (–)J94A7037
J94A7038
(J18T7051)Trunk light 5W (–)
High-mount brake light
27W (1156)
94S060–001