clock MAZDA MODEL 626 2002 Owners Manual

3-10
Knowing Your Mazda
Doors and Locks
Form No. 8Q50-EA-01G
3. Use the support rod to hold the hood open.
Before closing the hood, secure the rod in
its clip.





Closing the Hood
1. Check under the hood area to make
certain all filler caps are in place and
all loose items (e.g. tools, oil
containers, etc.) have been removed.
2. Close the hood so that it locks securely.





Key-Operated Trunk
To open the trunk lid, insert the primary
key into the slot and turn it clockwise.
The secondary key will not operate this
lock (page 3-2).
To close, use both hands to push the lid
down until the lock snaps shut. Don ’t
slam it.
Then pull up on it to make sure it ’s secure.
Clip Support rod
Trunk Lid
Open Trunk and Exhaust Gas:Exhaust gas in the cabin of a vehicle
is dangerous. This gas contains CO
(carbon monoxide), which is
colorless, odorless, and highly
poisonous. If inhaled, it can cause
loss of consciousness and death.
Because exhaust gas can get into the
cabin through an open trunk, keep
the trunk closed when driving.
WARNING
open
J94S.book Page 10 Saturday, June 23, 2001 1:04 PM

3-11
Knowing Your Mazda
Doors and Locks
Form No. 8Q50-EA-01G





Remote Trunk Lid Release
To release the trunk lid from inside the
vehicle, push the button.





Trunk Security
In some situations you may want to
prevent the trunk from being opened with
the remote trunk lid release button.
If you must leave your Mazda with
another person, such as a parking
attendant, protect valuables in the trunk
by locking the rear seatbacks and trunk.
Give the other person only the secondary
key, which does not open the trunk.
To secure the trunk lid, lock the rear
seatbacks (page 2-7), push the left side of
the trunk-lock switch, and close the trunk. To cancel the security feature, insert the
primary key into the lock, turn the key
clockwise to open the trunk, and push the
right side of the trunk-lock switch.





Trunk Light
The trunk light is on when the lid is open
and off when it ’s closed.
NOTE
To prevent the battery from being
discharged, do not leave the trunk open
for a long period when the engine is
not running.
Unlock
Lock
J94S.book Page 11 Saturday, June 23, 2001 1:04 PM

3-14
Knowing Your Mazda
Doors and Locks
Form No. 8Q50-EA-01G





Fuel-Filler Lid
To open, pull up the remote fuel-filler lid
release.





Fuel-Filler Cap
To remove the filler cap, turn it
counterclockwise.
To replace the filler cap, turn it clockwise
until it clicks.
Fuel-Filler Lid and Cap
Fuel Spray:Fuel spray is dangerous. Fuel can
burn skin and eyes and cause illness
when ingested. Fuel spray is released
when there is pressure in the fuel
tank and the fuel cap is removed too
quickly. When removing the fuel cap,
loosen the cap slightly and wait for
any hissing to stop. Then remove it.
Fuel Vapor:
Fuel vapor is dangerous. It could be
ignited by sparks or flames causing
serious burns and injuries. Before
refueling, stop the engine, and always
keep sparks and flames away from the
filler neck.
Always use only a genuine Mazda fuel
cap or an approved equivalent,
available at Authorized Mazda
Dealers. The wrong cap can result in a
serious malfunction of the fuel and
emission control systems. It may also
cause the check engine light in the
instrument cluster to illuminate.
WARNING
CAUTION
Remote fuel-filler
lid relese
Close
Open
J94S.book Page 14 Saturday, June 23, 2001 1:04 PM

6-6
Interior Comfort
Climate Control System
Form No. 8Q50-EA-01G





Control Switches
Fan control dial
This dial allows variable fan speeds.
0—Fan off
1—Low speed
2—Medium low speed
3—Medium high speed
4—High speed Temperature control dial
This dial controls temperature of the air
coming through the system. Turn it
clockwise for hot (red) and
counterclockwise for cold (blue).
Manual Type
Fan control dial
Mode selector switch
Mode selector switch
Temperature control dial
Air conditioner switchAir intake selector switch
Hot
Cold
J94S.book Page 6 Saturday, June 23, 2001 1:04 PM

6-19
Interior Comfort
Audio System
Form No. 8Q50-EA-01G
Power/Volume/Sound Controls ............................................................................................. 6-20
Clock ..................................................................................................................................... 6-22
Operating the Radio ........................................................................................................... ... 6-24
Operating the Cassette Tape Player ....................................................................................... 6-26
Operating the Mini Disc (MD) Player ................................................................................... 6-28
Operating the Compact Disc (CD) Player ............................................................................. 6-30
Operating the In-Dash CD Changer ...................................................................................... 6-32
Error Indications ............................................................................................................. ....... 6-35
Audio Set
CD PlayerIn-dash CD Changer
Cassette Tape Player Mini Disc (MD) PlayerIllustration is of a representative audio unit.
J94S.book Page 19 Saturday, June 23, 2001 1:04 PM

6-22
Interior Comfort
Audio System
Form No. 8Q50-EA-01G





Clock
Setting the time
The clock can be set at any time when the
ignition switch is in the ACC or ON
position.
1. To adjust the time, press the clock
button ( ) for about 2 seconds
until a beep is heard.
The clock ’s current time will flash.
2. To advance the hours, press the hour set button ( ). To advance the
minutes, press the minute set button
( ) while the time is flashing.
3. Press the clock button ( ) again to start the clock. Exact hour adjustment 1. To set the exact hour, press the clock
button ( ) for about 2 seconds
until a beep is heard.
The clock ’s current time will flash.
2. Press the clock button ( ) again and the time will be adjusted as
follows:
(Example)
12:01 —12:29→ 12:00
12:30 —12:59→ 1:00
Display Clock button
Hour set
button
Minute set
button
NOTE
If the power supply to the unit is
interrupted (if the fuse blows or the
vehicle ’s battery is disconnected), the
clock will need to be reset.
J94S.book Page 22 Saturday, June 23, 2001 1:04 PM

6-23
Interior Comfort
Audio System
Form No. 8Q50-EA-01G
Changing the display mode
The display on the unit can be changed by
pressing the clock button ( ). This
alternates the display between time and
audio. When the clock mode has been
selected, the time will be displayed.
NOTE
If audio operation is selected while the
time mode is on, the selected audio
mode will be displayed for ten
seconds, then the display will revert to
the time mode.
J94S.book Page 23 Saturday, June 23, 2001 1:04 PM

6-40
Interior Comfort
Interior Equipment
Form No. 8Q50-EA-01G
1. Using a coin, turn the cap counterclockwise (about 45 ° from the
closed position) and remove it.
2. Open the tray by pulling the release catch.
3. Pass the plug cord through the hole of the tray and insert the plug in the
socket. 4. Make sure the plug cord is running
through the cap slot, reinstall the cap
and turn it clockwise (about 45 ° to the
opened position).





Cup Holders
45
Release
catchUsing the Cup Holder:Using the cup holder to hold hot
liquids while the vehicle is moving is
dangerous. If the contents spill, you
could be scalded. Never use the cup
holder to hold hot liquids while the
vehicle is moving.
45
Cord
WARNING
J94S.book Page 40 Saturday, June 23, 2001 1:04 PM

6-42
Interior Comfort
Interior Equipment
Form No. 8Q50-EA-01G
Without sunroof
To open, unlatch the release catch.





Storage Pocket
To open, push the release catch down and
pull the lid downward.





Center Pocket
To open, push the release catch down and
pull the lid downward.





Glove Box
To open the glove box, pull the latch
toward you.
The door has a lock, insert the primary
key and turn it clockwise to lock,
counterclockwise to unlock.
Release catch
Unlock
Lock
J94S.book Page 42 Saturday, June 23, 2001 1:04 PM

7-4
In Case of an Emergency
Flat Tire
Form No. 8Q50-EA-01G





Jack
To remove the jack
Turn the wing bolt counterclockwise.
To secure the jack
Perform the removal procedure in reverse.





Spare Tire
Your Mazda has a temporary spare tire.
It’s lighter and smaller than a
conventional tire, and is designed only for
emergency use and should be used only
for VERY short periods. Temporary
spares should NEVER be used for long
drives or extended periods. To remove the spare tire
Turn the tire hold-down bolt
counterclockwise with the lug wrench.
Driving with a Temporary Spare Tire on Ice or Snow:Driving with a spare tire on the front
(driving) wheels on ice or snow is
dangerous. Handling will be affected.
You could lose control of the vehicle
and have an accident. Put the spare
tire on the rear axle and move a
regular tire to the front.
Jack
Wing bolt
WARNING
To avoid damage to the temporary
spare or to the vehicle, observe the
following precautions:
•Don ’t exceed 80 km/h (50 mph).
• Avoid driving over obstacles.
Also, don ’t drive through an
automatic car wash. This tire ’s
diameter is smaller than a
conventional tire ’s, so the ground
clearance is reduced about 25 mm
(1 in).
• Don ’t use a tire chain on this tire
because it won ’t fit properly.
• Don ’t use your temporary spare on
any other vehicle; it has been
designed only for your Mazda.
• Use only one temporary spare tire
on your vehicle at the same time.
CAUTION
Lug wrench
J94S.book Page 4 Saturday, June 23, 2001 1:04 PM