driver seat adjustment MAZDA MODEL 626 2002 Owners Manual

2-2
Essential Safety Equipment
Form No. 8Q50-EA-01G
Seats
(Manually operated model)
(Electrically operated model)
The seat-bottom tilt, seat height and seat
slide can be electrically adjusted. Move
them to the desired positions by using the
switch on the seat’s lower side.





Seat Slide
(Manually operated model)
To move a seat forward or backward, raise
the lever and slide the seat to the desired
position and release the lever.
Make sure the lever returns to its original
position and the seat is locked in place by
attempting to push it forward and
backward. Front Seats
Securing the Seats:Adjustable seats and seatbacks that
are not securely locked are
dangerous. In a sudden stop or
collision, the seat or seatback could
move, causing injury. Make sure the
adjustable components of the seat are
locked in place by attempting to slide
the seat forward and backward and
rocking the seatback.
• The seat-bottom power adjust is
operated by a motor. Avoid
extended operation because
excessive use can damage the
motor.
• To prevent the battery from running
down, avoid using the power adjust
when the engine is stopped. The
adjuster uses a great amount of
electric power.
• Don ’t use the switch to make more
than one adjustment at a time.
WARNING
CAUTION
Driver’s Seat Adjustment:Adjusting the driver’s seat while the
vehicle is moving is dangerous. The
driver could lose control of the vehicle
and have an accident. Adjust the
driver’s seat only when the vehicle is
stopped.
WARNING
Lever
J94S.book Page 2 Saturday, June 23, 2001 1:04 PM

2-4
Essential Safety Equipment
Seats
Form No. 8Q50-EA-01G
To change the seatback angle, lean
forward slightly while raising the lever.
Then lean back to the desired position and
release the lever.
Make sure the lever returns to its original
position and the seatback is locked in
place by attempting to push it forward and
backward.




Seat Tilt (Driver’s Seat)
(Manually operated model)
The seat-bottom angle can be adjusted by
rotating the dial.
(Electrically operated model)
Front height adjustment
To adjust the front height of the seat-
bottom, raise or lower the front of the
slide lifter switch on the left side of the
seat.
When returning a rear-reclined
seatback to its upright position, make
sure you support the seatback while
operating the seatback lever. If the
seatback is not supported, it will flip
forward suddenly and could cause
injury.
Lever
CAUTION
Up
Down
Dial
J94S.book Page 4 Saturday, June 23, 2001 1:04 PM