oil type MAZDA MODEL 626 2002 Owners Manual
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2002, Model line: MODEL 626, Model: MAZDA MODEL 626 2002Pages: 250, PDF Size: 4.83 MB
Page 50 of 250
3-6
Knowing Your Mazda
Doors and Locks
Form No. 8Q50-EA-01G
Transmitter
Lock button
To lock the doors, press the button.
To confirm that all the doors have been
locked, press the button again within
5 seconds. If they are closed and locked,
the horn will sound. Unlock button
To unlock the driver
’s door, press the
button.
To unlock all the doors, press the
button again within 5 seconds.
Trunk button
To open the trunk, press the button.
Maintenance
Replacing the transmitter battery
1. Insert a small coin into the slot and
gently pry open the transmitter.
NOTE
This device complies with part 15 of
the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation. (Outside
transmissions may momentarily
interfere with the device ’s operation.)
NOTE
Confirm that all the doors are locked
visually or aurally by use of the double
click.
Unlock button
Lock button
Trunk button
•Make sure the battery is installed
with the correct pole facing upward.
Battery leakage could occur if it is
not installed correctly.
• When replacing the battery, be
careful not to bend the electrical
terminals or get oil on them. Also
be careful not to get dirt in the
transmitter as it could damage it.
• Danger of explosion if battery is
incorrectly replaced.
• Replace only with the same type
battery (CR2032 or the equivalent).
• Dispose of used batteries according
to the following instructions.
Insulate the plus and minus
terminals of the battery using
cellophane or equivalent tape.
Never disassemble.
Never throw the battery into fire
and/or water.
Never deform or crush.
CAUTION
J94S.book Page 6 Saturday, June 23, 2001 1:04 PM
Page 77 of 250
4-9
Before Driving Your Mazda
Driving Tips
Form No. 8Q50-EA-01G
•Carry emergency gear, including tire
chains, window scraper, flares, a small
shovel, jumper cables, and a small bag
of sand or salt.
Ask a Mazda dealer to perform the
following precautions:
• Have the proper ratio of antifreeze in
the radiator.
• Inspect the battery and its cables. Cold
reduces battery capacity.
• Use only cold-weather engine
oil (page 8-10).
• Inspect the ignition system for damage
and loose connections.
• Use washer fluid made with
antifreeze —but don ’t use engine
coolant antifreeze for washer
fluid (page 8-20).
• Don ’t use the parking brake if it might
freeze. Instead, shift to P with an
automatic transaxle and to 1 or R with
a manual transaxle. Block the rear
wheels.
Snow Tires
Your vehicle is originally equipped with
all season radials designed to be used all
year around. In some extreme climates
you may find it necessary to replace them
with snow tires during the winter months
to further improve traction on snow and
ice covered roads.
Use snow tires on all four wheels
Don ’t go faster than 120 km/h (75 mph).
Inflate snow tires 28 kPa (0.3 kgf/cm 2, 4
psi) more than recommended on the tire
pressure label (driver’ s door), but never
more than the maximum cold-tire
pressure shown on the tires.
Winter Driving
Mixing Tire Types:Using tires different in size or type is
dangerous. Your vehicle ’s handling
could be greatly affected and result in
an accident. Use only the same size
and type tires (snow, radial, or non-
radial) on all four wheels.
Check local regulations before using
studded tires.
WARNING
CAUTION
J94S.book Page 9 Saturday, June 23, 2001 1:04 PM
Page 180 of 250
8-4
Maintenance and Care
Scheduled Maintenance
Form No. 8Q50-EA-01G
Schedule 1
I : Inspect and repair, clean, adjust, or replace if necessary.
(Oil-permeated air filter cannot be cleaned using the air-blow method.) R: Replace
L : Lubricate
*1: According to state and federal regulations, failure to perform maintenance on these items will not void your emissions warranties. However, Mazda recommends that all maintenance services be performed at the
recommended time or kilometrage (mileage) period to ensure long-term reliability.
Maintenance
Interval
Maintenance
Item Number of months or kilometers (miles), whichever comes first Months 6 12182430364248
×1000 Km 12 24 36 48 60 72 84 96
(×1000 Miles) (7.5) (15) (22.5) (30) (37.5) (45) (52.5) (60)
Engine valve clearance I
Drive belts (tension) II
Engine timing belt Inspect at 96,000km (60,000miles)
Replace every 168,000km (105,000miles)
Engine oil RRRRRRRR
Engine oil filter RRRRRRRR
Cooling system II
Engine coolant Replace at first 168,000km (105,000miles) or 60 months ;
after that, every 48,000km (30,000miles) or 24 months
Idle speed II
Air filter RR
Fuel lines and hoses
*1II
Hoses and tubes for emission*1I
Spark plugs 2.0-liter engine
(non-PLATINUM tipped type)
RR
2.5-liter engine
(PLATINUM tipped type) Replace every 96,000km (60,000miles)
Brake lines, hoses and connections II
Disc brakes II
Drum brakes II
Steering operation and linkages II
Front suspension ball joints II
Driveshaft dust boots II
Bolts and nuts on chassis and body II
Exhaust system heat shields II
All locks and hinges LLLLLLLL
Refrigerant amount (if installed) IIII
Compressor operation (if installed) IIII
08.fm Page 4 Monday, June 25, 2001 5:12 PM
Page 181 of 250
8-5
Maintenance and Care
Scheduled Maintenance
Form No. 8Q50-EA-01G
Schedule 2
I : Inspect and repair, clean, adjust, or replace if necessary.
(Oil-permeated air filter cannot be cleaned using the air-blow method.) R: Replace
L : Lubricate
*1: According to state and federal regulations, failure to perform maintenance on these items will not void your emissions warranties. However, Mazda recommends that all maintenance services be performed at the
recommended time or kilometrage (mileage) period to ensure long-term reliability.
*2: If the vehicle is operated in cold districts { below –18 degrees C (0 degrees F) }, replace the timing belt at 96,000km (60,000miles).
Maintenance
Interval
Maintenance
Item Number of months or kilometers (miles), whichever comes first Months 4 8 12 16 20 24 28 32 36 40 44 48
×1000 Km 8 1624324048566472808896
(×1000 Miles) (5) (10) (15) (20) (25) (30) (35) (40) (45) (50) (55) (60)
Engine valve clearance I
Drive belts (tension) II
Engine timing belt
*2Inspect at 96,000km (60,000miles)
Replace every 168,000km (105,000miles)
Engine oil Puerto Rico
Replace every 5,000km (3,000miles) or 3 months
others RRRRRRRRRRRR
Engine oil filter RRRRRRRRRRRR
Cooling system II
Engine coolant Replace at first 168,000km (105,000miles) or 60 months ;
after that, every 48,000km (30,000miles) or 24 months
Engine coolant level IIIIIIIIIIII
Idle speed II
Air filter I
*1RI *1R
Fuel lines and hoses*1II
Hoses and tubes for emission*1I
Spark plugs 2.0-liter engine
(non-PLATINUM tipped type)
RR
2.5-liter engine
(PLATINUM tipped type) Replace every 96,000km (60,000miles)
Function of all lights IIIIIIIIIIII
Brake lines, hoses and connections II
Brake and clutch fluid level IIIIIIIIIIII
Disc brakes IIII
Drum brakes II
Tire inflation pressure and tire wear IIIIIIIIIIII
Steering operation and linkages II
Power steering fluid level IIIIIIIIIIII
Front suspension ball joints II
Driveshaft dust boots II
Bolts and nuts on chassis and body IIII
Exhaust system heat shields II
All locks and hinges LLLLLLLLLLLL
08.fm Page 5 Monday, June 25, 2001 5:12 PM
Page 242 of 250
10-4
Form No. 8Q50-EA-01G
Specifications
Engine
Electrical System
*1Manual transaxle*2Automatic transaxle
Lubricant Quality
*Refer to the recommended SAE viscosity numbers on 8-10.
Specifications
Model
Item 2.0-liter engine 2.5-liter engine
Type DOHC-16V in-line, 4-cyl DOHC-24V V6 6-cyl
Bore ×Stroke 83.0 × 92.0mm (3.27 × 3.62 in) 84.5 × 74.2mm (3.33 × 2.92 in)
Displacement 1,991 ml (1,991 cc , 121.5 cu in) 2,496 ml (2,496 cc , 152.3 cu in)
Compression ratio 9.19.5
Model
Item 2.0 liter engine
2.5-liter engine
Battery Maintenance-free 12V-48AH/5HR
Alternator 12V-80A12V-90A
Starter 12V-1.0 kW
12V-1.7 kW
*1, 12V-1.6 kW *2
Spark-plug
numberNGK BKR5E-11, BKR6E-11
—
DENSO K16PR-U11, K20PR-U11 PKJ16CR8, PKJ20CR8
Spark-plug gap 1.0 —1.1 mm (0.040 —0.043 in) 0.7 —0.8 mm (0.028 —0.031 in)
Lubricant Classification
Engine oil
*
API Service ILSAC
SG (Energy Conserving II) —
SH (Energy Conserving II) GF-I
SJ GF-II
SL GF-III
Manual transaxle oil Any temperature
API Service GL-4 or GL-5
(SAE 75W-90)
Above 50
°F (10 °C)
API Service GL-4 or GL-5
(SAE 80W-90)
Automatic transaxle fluid 2.0-liter engine ATF M-III or equivalent (e.g. Mercon
®)
2.5-liter engine ATF M-III or equivalent (e.g. Dexron ® III)
Power steering fluid ATF M-III or equivalent (e.g. Dexron® II)
Brake/clutch fluid SAE J1703 or FMVSS116 DOT-3
J94S.book Page 4 Saturday, June 23, 2001 1:04 PM