fuel pump MAZDA MODEL CX-30 2019 Owners Manual (in English)

Fuel-Filler Flap and Cap
▼Fuel-Filler Flap and Cap
WARNING
When removing the fuel-filler cap,
loosen the cap slightly and wait for
any hissing to stop, then remove it:
Fuel spray is dangerous. Fuel can burn
skin and eyes and cause illness if
ingested. Fuel spray is released when
there is pressure in the fuel tank and
the fuel-filler cap is removed too
quickly.
Before refuelling, stop the engine,
and always keep sparks and flames
away from the filler neck:
Fuel vapour is dangerous. It could be
ignited by sparks or flames causing
serious burns and injuries.
Additionally, use of the incorrect
fuel-filler cap or not using a fuel-filler
cap may result in a fuel leak, which
could result in serious burns or death
in an accident.
Do not continue refuelling after the
fuel pump nozzle shuts off
automatically:
Continuing to add fuel after the fuel
pump nozzle has shut off automatically
is dangerous because
overfilling the
fuel tank may cause fuel overflow or
leakage. Fuel overflow and leakage
could damage the vehicle and if the
fuel ignites it could cause a fire and
explosion resulting in serious injury or
death.
CAUTION
¾Always use only a designated Mazda
fuel-filler cap or an approved
equivalent, available at an expert
repairer (we recommend an
Authorised Mazda Repairer). The
wrong cap can result in a serious
malfunction of the fuel and emission
control systems.
¾When using an automatic car wash
or a high water pressure car washer,
lock the driver's door. Otherwise,
the
fuel-filler
flap may open
unexpectedly and could be
damaged.
▼Refuelling
Before refuelling, close all the doors,
windows, and liftgate, and switch the
ignition OFF.
1. Using the following , unlock the
driver’s door.
xTransmitter (page 3-16)xTouch sensor (page 3-13)xDoor-lock switch (page 3-16)xAuto lock/unlock function (page
3-19)
NOTE
xWhen the driver's door is locked/
unlocked, the fuel flap is also
locked/unlocked at the same
time.
xThe time until the fuel flap is
locked after locking the driver's
door can be changed.
Refer to the Settings section in
the Mazda Connect Owner's
Manual.
xHowever, if you change the time
until the fuel flap is locked,
locking of the fuel flap using the
following functions is not
applicable.
Before Driving
Fuel and Emission
3-34

ACC (Accessory)
Some electrical accessories will
operate and the indicator light (amber)
illuminates.
In this position the steering wheel is
unlocked.
NOTE
The keyless entry system does not
function while the push button start
has been pressed to ACC, and the
doors will not lock/unlock even if they
have been locked manually.
ON
This is the normal running position
after the engine is started. The
indicator light (amber) turns off. (The
indicator light (amber) illuminates
when the ignition is switched ON and
the engine is not running.)
Some indicator lights/warning lights
should be inspected before the engine
is started.
Refer to Warning/Indicator Lights on
page 4-32.
Refer to Indication/Indicator Lights on
page 4-34.
NOTE
(SKYACTIV-G 2.0, SKYACTIV-G 2.5,
SKYACTIV-X 2.0)
When the push button start is pressed
to ON, the sound of the fuel pump
motor operating near the fuel tank can
be heard. This does not indicate an
abnormality.
Starting the Engine
▼Starting the Engine
WARNING
Radio waves from the key may affect
medical devices such as pacemakers:
Before using the key near people who
use medical devices, ask the medical
device manufacturer or your physician
if radio waves from the key will affect
the device.
NOTE
xThe key must be carried because the
key carries an immobilizer chip that
must communicate with the engine
controls at short range.
xThe engine can be started when the
push button start is pressed from off,
ACC, or ON.
xThe push button start system
functions (function which can start
the engine by only carrying the key)
can be deactivated to prevent any
possible adverse effect on a user
wearing a pacemaker or other
medical device. If the system is
deactivated, you will be unable to
start the engine by carrying the key.
Consult an expert repairer (we
recommend an Authorised Mazda
Repairer) for details. If the push
button start system functions have
been deactivated, you can start the
engine by following the procedure
indicated when the key battery goes
dead.
Refer to Engine Start Function When
Key Battery is Dead on page 4-8.
xAfter starting a cold engine, the
engine speed increases and a
whining sound from the engine
compartment can be heard.
When Driving
Start/Stop Engine
4-5

xA key from another
manufacturer similar to the key
is in the operational range.
x(Forced engine starting method)
If the KEY warning indication
(red) is displayed, or the push
button start indicator light
(amber) flashes, this could
indicate that the engine may not
start using the usual starting
method (page 7-56). Have your
vehicle inspected at an expert
repairer (we recommend an
Authorised Mazda Repairer) as
soon as possible. If this occurs,
the engine can be force-started.
Press and hold the push button
start until the engine starts. Other
procedures necessary for starting
the engine, such as having the key
in the cabin, and depressing the
clutch pedal (manual
transmission) or the brake pedal
(automatic transmission) are
required.
xWhen the engine is force-started,
the KEY warning indication (red)
remains displayed and the push
button start indicator light
(amber) remains flashing.
x(Automatic transmission)
When the selector lever is in the
neutral (N) position, the push
button start indicator light (green)
does not turn on.
7. Press the push button start after the
push button start indicator light
(green) turns on.
NOTE
xAfter starting the engine, the push
button start indicator light
(amber) turns off and the ignition
switches to the ON position.
x(SKYACTIV-G 2.0, SKYACTIV-G
2.5, SKYACTIV-X 2.0)
After pressing the push button
start and before the engine starts,
the operation sound of the fuel
pump motor from near the fuel
tank can be heard, however, this
does not indicate a malfunction.
x(SKYACTIV-D 1.8)
xThe starter does not rotate until
the glow indicator light turns
off.
xIf the ignition is left switched
ON for a long period of time
without the engine running
after the glow plugs are
warmed up, the glow plugs may
warm up again which will
illuminate the glow indicator
light.
xWhen starting the engine, do
not release the clutch pedal
(manual transmission) or the
brake pedal (automatic
transmission) until the glow
indicator light in the instrument
cluster turns off and the engine
starts, after pressing the push
button start.
xIf the clutch pedal (manual
transmission) or the brake
pedal (automatic transmission)
is released before the engine
starts, depress the clutch pedal
(manual transmission) or the
brake pedal (automatic
transmission) again and press
the push button start to start
the engine.
8. After starting the engine, let it idle
for about 10 seconds (Prohibited in
Germany).
When Driving
Start/Stop Engine
4-7

No.FUSE RAT-
INGPROTECTED COMPONENT
F715 A
Fuel warmer
*
20 A
Fuel pump*
F8 15 A Engine control system
F9 15 A
Transmission control system
*
F10 15 A Engine control system
F11 7.5 A Air conditioner
F12 15 A Engine control system
F13 15 A
NOx sensor
*
F14 20 A
Front seat warmer*
F15 20 A
Headlight washer*
F16 15 A For protection of various circuits
F17ŠŠ
F18 15 A Accessory sockets
F19 60 A Power steering system
F20 15 A Headlight (LH) 1
F21 15 A Headlight (RH) 1
F22 15 A Keyless system
F23 30 A ABS, Dynamic stability control system
F24 15 A Headlight (LH) 2
F25 15 A Headlight (RH) 2
F26 7.5 A On board diagnostics
F27 25 A For protection of various circuits
F28 25 A For protection of various circuits
F29 15 A Windscreen washer
F30ŠŠ
F31 15 A Horn
F32 15 A Headlights
F33ŠŠ
F34ŠŠ
F35 50A ABS, Dynamic stability control system
F36ŠŠ
F37 40 A Rear window defogger
F38 50 A For protection of various circuits
Maintenance and Care
Owner Maintenance
6-50*Some models.